blob: 131b7e57d22f46d28a9501c5641fd3c03b7e6ca0 [file] [log] [blame]
# SPDX-License-Identifier: GPL-2.0
# Copyright (C) 2021 Sebastian Reichel
%YAML 1.2
---
$id: http://devicetree.org/schemas/power/supply/bq24190.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: TI BQ2419x Li-Ion Battery Charger
maintainers:
- Sebastian Reichel <sre@kernel.org>
allOf:
- $ref: power-supply.yaml#
properties:
compatible:
enum:
- ti,bq24190
- ti,bq24192
- ti,bq24192i
- ti,bq24196
- ti,bq24296
reg:
maxItems: 1
interrupts:
maxItems: 1
usb-otg-vbus:
$ref: /schemas/regulator/regulator.yaml#
description: |
Regulator that is used to control the VBUS voltage direction for
either USB host mode or for charging on the OTG port
ti,system-minimum-microvolt:
description: |
when power is connected and the battery is below minimum system voltage,
the system will be regulated above this setting.
omit-battery-class:
type: boolean
description: |
If this property is set, the operating system does not try to create a
battery device.
monitored-battery:
$ref: /schemas/types.yaml#/definitions/phandle
description: |
phandle to a "simple-battery" compatible node.
This property must be a phandle to a node using the format described
in battery.yaml, with the following properties being required:
- precharge-current-microamp: maximum charge current during precharge phase
(typically 20% of battery capacity).
- charge-term-current-microamp: a charge cycle terminates when the battery voltage is
above recharge threshold, and the current is below this
setting (typically 10% of battery capacity).
required:
- compatible
- reg
- interrupts
additionalProperties: false
examples:
- |
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/interrupt-controller/irq.h>
bat: battery {
compatible = "simple-battery";
precharge-current-microamp = <256000>;
charge-term-current-microamp = <128000>;
};
i2c {
#address-cells = <1>;
#size-cells = <0>;
charger@6a {
compatible = "ti,bq24190";
reg = <0x6a>;
interrupt-parent = <&gpiochip>;
interrupts = <10 IRQ_TYPE_EDGE_FALLING>;
monitored-battery = <&bat>;
ti,system-minimum-microvolt = <3200000>;
usb_otg_vbus: usb-otg-vbus { };
};
};