| # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) |
| # Copyright (c) 2019 MediaTek Inc. |
| %YAML 1.2 |
| --- |
| $id: http://devicetree.org/schemas/media/i2c/ov8856.yaml# |
| $schema: http://devicetree.org/meta-schemas/core.yaml# |
| |
| title: Omnivision OV8856 CMOS Sensor |
| |
| maintainers: |
| - Dongchun Zhu <dongchun.zhu@mediatek.com> |
| |
| description: |- |
| The Omnivision OV8856 is a high performance, 1/4-inch, 8 megapixel, CMOS |
| image sensor that delivers 3264x2448 at 30fps. It provides full-frame, |
| sub-sampled, and windowed 10-bit MIPI images in various formats via the |
| Serial Camera Control Bus (SCCB) interface. This chip is programmable |
| through I2C and two-wire SCCB. The sensor output is available via CSI-2 |
| serial data output (up to 4-lane). |
| |
| properties: |
| compatible: |
| const: ovti,ov8856 |
| |
| reg: |
| maxItems: 1 |
| |
| clocks: |
| maxItems: 1 |
| |
| clock-names: |
| description: |
| Input clock for the sensor. |
| items: |
| - const: xvclk |
| |
| clock-frequency: |
| description: |
| Frequency of the xvclk clock in Hertz. |
| |
| dovdd-supply: |
| description: |
| Definition of the regulator used as interface power supply. |
| |
| avdd-supply: |
| description: |
| Definition of the regulator used as analog power supply. |
| |
| dvdd-supply: |
| description: |
| Definition of the regulator used as digital power supply. |
| |
| reset-gpios: |
| description: |
| The phandle and specifier for the GPIO that controls sensor reset. |
| This corresponds to the hardware pin XSHUTDOWN which is physically |
| active low. |
| |
| port: |
| $ref: /schemas/graph.yaml#/$defs/port-base |
| additionalProperties: false |
| |
| properties: |
| endpoint: |
| $ref: /schemas/media/video-interfaces.yaml# |
| unevaluatedProperties: false |
| |
| properties: |
| data-lanes: |
| description: |- |
| The driver only supports four-lane operation. |
| items: |
| - const: 1 |
| - const: 2 |
| - const: 3 |
| - const: 4 |
| |
| link-frequencies: |
| description: Frequencies listed are driver, not h/w limitations. |
| maxItems: 2 |
| items: |
| enum: [ 360000000, 180000000 ] |
| |
| required: |
| - link-frequencies |
| |
| required: |
| - compatible |
| - reg |
| - clocks |
| - clock-names |
| - clock-frequency |
| - dovdd-supply |
| - avdd-supply |
| - dvdd-supply |
| - reset-gpios |
| - port |
| |
| additionalProperties: false |
| |
| examples: |
| - | |
| #include <dt-bindings/gpio/gpio.h> |
| |
| i2c { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| ov8856: camera@10 { |
| compatible = "ovti,ov8856"; |
| reg = <0x10>; |
| |
| reset-gpios = <&pio 111 GPIO_ACTIVE_LOW>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&clk_24m_cam>; |
| |
| clocks = <&cam_osc>; |
| clock-names = "xvclk"; |
| clock-frequency = <19200000>; |
| |
| avdd-supply = <&mt6358_vcama2_reg>; |
| dvdd-supply = <&mt6358_vcamd_reg>; |
| dovdd-supply = <&mt6358_vcamio_reg>; |
| |
| port { |
| wcam_out: endpoint { |
| remote-endpoint = <&mipi_in_wcam>; |
| data-lanes = <1 2 3 4>; |
| link-frequencies = /bits/ 64 <360000000>; |
| }; |
| }; |
| }; |
| }; |
| ... |