| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * net/dsa/mv88e6060.c - Driver for Marvell 88e6060 switch chips |
| * Copyright (c) 2008-2009 Marvell Semiconductor |
| */ |
| |
| #include <linux/delay.h> |
| #include <linux/etherdevice.h> |
| #include <linux/jiffies.h> |
| #include <linux/list.h> |
| #include <linux/module.h> |
| #include <linux/netdevice.h> |
| #include <linux/phy.h> |
| #include <net/dsa.h> |
| #include "mv88e6060.h" |
| |
| static int reg_read(struct mv88e6060_priv *priv, int addr, int reg) |
| { |
| return mdiobus_read_nested(priv->bus, priv->sw_addr + addr, reg); |
| } |
| |
| static int reg_write(struct mv88e6060_priv *priv, int addr, int reg, u16 val) |
| { |
| return mdiobus_write_nested(priv->bus, priv->sw_addr + addr, reg, val); |
| } |
| |
| static const char *mv88e6060_get_name(struct mii_bus *bus, int sw_addr) |
| { |
| int ret; |
| |
| ret = mdiobus_read(bus, sw_addr + REG_PORT(0), PORT_SWITCH_ID); |
| if (ret >= 0) { |
| if (ret == PORT_SWITCH_ID_6060) |
| return "Marvell 88E6060 (A0)"; |
| if (ret == PORT_SWITCH_ID_6060_R1 || |
| ret == PORT_SWITCH_ID_6060_R2) |
| return "Marvell 88E6060 (B0)"; |
| if ((ret & PORT_SWITCH_ID_6060_MASK) == PORT_SWITCH_ID_6060) |
| return "Marvell 88E6060"; |
| } |
| |
| return NULL; |
| } |
| |
| static enum dsa_tag_protocol mv88e6060_get_tag_protocol(struct dsa_switch *ds, |
| int port, |
| enum dsa_tag_protocol m) |
| { |
| return DSA_TAG_PROTO_TRAILER; |
| } |
| |
| static int mv88e6060_switch_reset(struct mv88e6060_priv *priv) |
| { |
| int i; |
| int ret; |
| unsigned long timeout; |
| |
| /* Set all ports to the disabled state. */ |
| for (i = 0; i < MV88E6060_PORTS; i++) { |
| ret = reg_read(priv, REG_PORT(i), PORT_CONTROL); |
| if (ret < 0) |
| return ret; |
| ret = reg_write(priv, REG_PORT(i), PORT_CONTROL, |
| ret & ~PORT_CONTROL_STATE_MASK); |
| if (ret) |
| return ret; |
| } |
| |
| /* Wait for transmit queues to drain. */ |
| usleep_range(2000, 4000); |
| |
| /* Reset the switch. */ |
| ret = reg_write(priv, REG_GLOBAL, GLOBAL_ATU_CONTROL, |
| GLOBAL_ATU_CONTROL_SWRESET | |
| GLOBAL_ATU_CONTROL_LEARNDIS); |
| if (ret) |
| return ret; |
| |
| /* Wait up to one second for reset to complete. */ |
| timeout = jiffies + 1 * HZ; |
| while (time_before(jiffies, timeout)) { |
| ret = reg_read(priv, REG_GLOBAL, GLOBAL_STATUS); |
| if (ret < 0) |
| return ret; |
| |
| if (ret & GLOBAL_STATUS_INIT_READY) |
| break; |
| |
| usleep_range(1000, 2000); |
| } |
| if (time_after(jiffies, timeout)) |
| return -ETIMEDOUT; |
| |
| return 0; |
| } |
| |
| static int mv88e6060_setup_global(struct mv88e6060_priv *priv) |
| { |
| int ret; |
| |
| /* Disable discarding of frames with excessive collisions, |
| * set the maximum frame size to 1536 bytes, and mask all |
| * interrupt sources. |
| */ |
| ret = reg_write(priv, REG_GLOBAL, GLOBAL_CONTROL, |
| GLOBAL_CONTROL_MAX_FRAME_1536); |
| if (ret) |
| return ret; |
| |
| /* Disable automatic address learning. |
| */ |
| return reg_write(priv, REG_GLOBAL, GLOBAL_ATU_CONTROL, |
| GLOBAL_ATU_CONTROL_LEARNDIS); |
| } |
| |
| static int mv88e6060_setup_port(struct mv88e6060_priv *priv, int p) |
| { |
| int addr = REG_PORT(p); |
| int ret; |
| |
| if (dsa_is_unused_port(priv->ds, p)) |
| return 0; |
| |
| /* Do not force flow control, disable Ingress and Egress |
| * Header tagging, disable VLAN tunneling, and set the port |
| * state to Forwarding. Additionally, if this is the CPU |
| * port, enable Ingress and Egress Trailer tagging mode. |
| */ |
| ret = reg_write(priv, addr, PORT_CONTROL, |
| dsa_is_cpu_port(priv->ds, p) ? |
| PORT_CONTROL_TRAILER | |
| PORT_CONTROL_INGRESS_MODE | |
| PORT_CONTROL_STATE_FORWARDING : |
| PORT_CONTROL_STATE_FORWARDING); |
| if (ret) |
| return ret; |
| |
| /* Port based VLAN map: give each port its own address |
| * database, allow the CPU port to talk to each of the 'real' |
| * ports, and allow each of the 'real' ports to only talk to |
| * the CPU port. |
| */ |
| ret = reg_write(priv, addr, PORT_VLAN_MAP, |
| ((p & 0xf) << PORT_VLAN_MAP_DBNUM_SHIFT) | |
| (dsa_is_cpu_port(priv->ds, p) ? |
| dsa_user_ports(priv->ds) : |
| BIT(dsa_to_port(priv->ds, p)->cpu_dp->index))); |
| if (ret) |
| return ret; |
| |
| /* Port Association Vector: when learning source addresses |
| * of packets, add the address to the address database using |
| * a port bitmap that has only the bit for this port set and |
| * the other bits clear. |
| */ |
| return reg_write(priv, addr, PORT_ASSOC_VECTOR, BIT(p)); |
| } |
| |
| static int mv88e6060_setup_addr(struct mv88e6060_priv *priv) |
| { |
| u8 addr[ETH_ALEN]; |
| int ret; |
| u16 val; |
| |
| eth_random_addr(addr); |
| |
| val = addr[0] << 8 | addr[1]; |
| |
| /* The multicast bit is always transmitted as a zero, so the switch uses |
| * bit 8 for "DiffAddr", where 0 means all ports transmit the same SA. |
| */ |
| val &= 0xfeff; |
| |
| ret = reg_write(priv, REG_GLOBAL, GLOBAL_MAC_01, val); |
| if (ret) |
| return ret; |
| |
| ret = reg_write(priv, REG_GLOBAL, GLOBAL_MAC_23, |
| (addr[2] << 8) | addr[3]); |
| if (ret) |
| return ret; |
| |
| return reg_write(priv, REG_GLOBAL, GLOBAL_MAC_45, |
| (addr[4] << 8) | addr[5]); |
| } |
| |
| static int mv88e6060_setup(struct dsa_switch *ds) |
| { |
| struct mv88e6060_priv *priv = ds->priv; |
| int ret; |
| int i; |
| |
| priv->ds = ds; |
| |
| ret = mv88e6060_switch_reset(priv); |
| if (ret < 0) |
| return ret; |
| |
| /* @@@ initialise atu */ |
| |
| ret = mv88e6060_setup_global(priv); |
| if (ret < 0) |
| return ret; |
| |
| ret = mv88e6060_setup_addr(priv); |
| if (ret < 0) |
| return ret; |
| |
| for (i = 0; i < MV88E6060_PORTS; i++) { |
| ret = mv88e6060_setup_port(priv, i); |
| if (ret < 0) |
| return ret; |
| } |
| |
| return 0; |
| } |
| |
| static int mv88e6060_port_to_phy_addr(int port) |
| { |
| if (port >= 0 && port < MV88E6060_PORTS) |
| return port; |
| return -1; |
| } |
| |
| static int mv88e6060_phy_read(struct dsa_switch *ds, int port, int regnum) |
| { |
| struct mv88e6060_priv *priv = ds->priv; |
| int addr; |
| |
| addr = mv88e6060_port_to_phy_addr(port); |
| if (addr == -1) |
| return 0xffff; |
| |
| return reg_read(priv, addr, regnum); |
| } |
| |
| static int |
| mv88e6060_phy_write(struct dsa_switch *ds, int port, int regnum, u16 val) |
| { |
| struct mv88e6060_priv *priv = ds->priv; |
| int addr; |
| |
| addr = mv88e6060_port_to_phy_addr(port); |
| if (addr == -1) |
| return 0xffff; |
| |
| return reg_write(priv, addr, regnum, val); |
| } |
| |
| static const struct dsa_switch_ops mv88e6060_switch_ops = { |
| .get_tag_protocol = mv88e6060_get_tag_protocol, |
| .setup = mv88e6060_setup, |
| .phy_read = mv88e6060_phy_read, |
| .phy_write = mv88e6060_phy_write, |
| }; |
| |
| static int mv88e6060_probe(struct mdio_device *mdiodev) |
| { |
| struct device *dev = &mdiodev->dev; |
| struct mv88e6060_priv *priv; |
| struct dsa_switch *ds; |
| const char *name; |
| |
| priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| |
| priv->bus = mdiodev->bus; |
| priv->sw_addr = mdiodev->addr; |
| |
| name = mv88e6060_get_name(priv->bus, priv->sw_addr); |
| if (!name) |
| return -ENODEV; |
| |
| dev_info(dev, "switch %s detected\n", name); |
| |
| ds = devm_kzalloc(dev, sizeof(*ds), GFP_KERNEL); |
| if (!ds) |
| return -ENOMEM; |
| |
| ds->dev = dev; |
| ds->num_ports = MV88E6060_PORTS; |
| ds->priv = priv; |
| ds->dev = dev; |
| ds->ops = &mv88e6060_switch_ops; |
| |
| dev_set_drvdata(dev, ds); |
| |
| return dsa_register_switch(ds); |
| } |
| |
| static void mv88e6060_remove(struct mdio_device *mdiodev) |
| { |
| struct dsa_switch *ds = dev_get_drvdata(&mdiodev->dev); |
| |
| if (!ds) |
| return; |
| |
| dsa_unregister_switch(ds); |
| } |
| |
| static void mv88e6060_shutdown(struct mdio_device *mdiodev) |
| { |
| struct dsa_switch *ds = dev_get_drvdata(&mdiodev->dev); |
| |
| if (!ds) |
| return; |
| |
| dsa_switch_shutdown(ds); |
| |
| dev_set_drvdata(&mdiodev->dev, NULL); |
| } |
| |
| static const struct of_device_id mv88e6060_of_match[] = { |
| { |
| .compatible = "marvell,mv88e6060", |
| }, |
| { /* sentinel */ }, |
| }; |
| |
| static struct mdio_driver mv88e6060_driver = { |
| .probe = mv88e6060_probe, |
| .remove = mv88e6060_remove, |
| .shutdown = mv88e6060_shutdown, |
| .mdiodrv.driver = { |
| .name = "mv88e6060", |
| .of_match_table = mv88e6060_of_match, |
| }, |
| }; |
| |
| mdio_module_driver(mv88e6060_driver); |
| |
| MODULE_AUTHOR("Lennert Buytenhek <buytenh@wantstofly.org>"); |
| MODULE_DESCRIPTION("Driver for Marvell 88E6060 ethernet switch chip"); |
| MODULE_LICENSE("GPL"); |
| MODULE_ALIAS("platform:mv88e6060"); |