| What: /sys/class/uwb_rc/uwbN/wusbhc/wusb_chid |
| Contact: David Vrabel <david.vrabel@csr.com> |
| Write the CHID (16 space-separated hex octets) for this host controller. |
| This starts the host controller, allowing it to accept connection from |
| Set an all zero CHID to stop the host controller. |
| What: /sys/class/uwb_rc/uwbN/wusbhc/wusb_trust_timeout |
| Contact: David Vrabel <david.vrabel@csr.com> |
| Devices that haven't sent a WUSB packet to the host |
| within 'wusb_trust_timeout' ms are considered to have |
| disconnected and are removed. The default value of |
| 4000 ms is the value required by the WUSB |
| Since this relates to security (specifically, the |
| lifetime of PTKs and GTKs) it should not be changed |
| What: /sys/class/uwb_rc/uwbN/wusbhc/wusb_phy_rate |
| Contact: David Vrabel <david.vrabel@csr.com> |
| The maximum PHY rate to use for all connected devices. |
| This is only of limited use for testing and |
| development as the hardware's automatic rate |
| adaptation is better then this simple control. |
| Refer to [ECMA-368] section 10.3.1.1 for the value to |