Merge tag 'imx-fixes-5.9-2' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux into arm/fixes
i.MX fixes for 5.9, round 2:
- Fix the misspelling of 'interrupts' property in i.MX8MQ TMU DT node.
- Correct 'ahb' clock for i.MX8MP SDMA1 in device tree.
- Fix pad QSPI1B_SCLK mux mode for UART3 on i.MX6SX.
* tag 'imx-fixes-5.9-2' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
ARM: dts: imx6sx: fix the pad QSPI1B_SCLK mux mode for uart3
arm64: dts: imx8mp: correct sdma1 clk setting
arm64: dts: imx8mq: Fix TMU interrupt property
Link: https://lore.kernel.org/r/20200909143844.GA25109@dragon
Signed-off-by: Olof Johansson <olof@lixom.net>
diff --git a/arch/arm/boot/dts/logicpd-som-lv-baseboard.dtsi b/arch/arm/boot/dts/logicpd-som-lv-baseboard.dtsi
index 100396f..395e05f 100644
--- a/arch/arm/boot/dts/logicpd-som-lv-baseboard.dtsi
+++ b/arch/arm/boot/dts/logicpd-som-lv-baseboard.dtsi
@@ -51,6 +51,8 @@
&mcbsp2 {
status = "okay";
+ pinctrl-names = "default";
+ pinctrl-0 = <&mcbsp2_pins>;
};
&charger {
@@ -102,35 +104,18 @@
regulator-max-microvolt = <3300000>;
};
- lcd0: display@0 {
- compatible = "panel-dpi";
- label = "28";
- status = "okay";
- /* default-on; */
+ lcd0: display {
+ /* This isn't the exact LCD, but the timings meet spec */
+ compatible = "logicpd,type28";
pinctrl-names = "default";
pinctrl-0 = <&lcd_enable_pin>;
- enable-gpios = <&gpio5 27 GPIO_ACTIVE_HIGH>; /* gpio155, lcd INI */
+ backlight = <&bl>;
+ enable-gpios = <&gpio5 27 GPIO_ACTIVE_HIGH>;
port {
lcd_in: endpoint {
remote-endpoint = <&dpi_out>;
};
};
-
- panel-timing {
- clock-frequency = <9000000>;
- hactive = <480>;
- vactive = <272>;
- hfront-porch = <3>;
- hback-porch = <2>;
- hsync-len = <42>;
- vback-porch = <3>;
- vfront-porch = <2>;
- vsync-len = <11>;
- hsync-active = <1>;
- vsync-active = <1>;
- de-active = <1>;
- pixelclk-active = <0>;
- };
};
bl: backlight {
diff --git a/arch/arm/boot/dts/logicpd-torpedo-baseboard.dtsi b/arch/arm/boot/dts/logicpd-torpedo-baseboard.dtsi
index 381f0e8..b0f6613 100644
--- a/arch/arm/boot/dts/logicpd-torpedo-baseboard.dtsi
+++ b/arch/arm/boot/dts/logicpd-torpedo-baseboard.dtsi
@@ -81,6 +81,8 @@
};
&mcbsp2 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&mcbsp2_pins>;
status = "okay";
};
diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi
index 5da9cff..a82c962 100644
--- a/arch/arm/boot/dts/omap5.dtsi
+++ b/arch/arm/boot/dts/omap5.dtsi
@@ -488,11 +488,11 @@
};
};
- target-module@5000 {
+ target-module@4000 {
compatible = "ti,sysc-omap2", "ti,sysc";
- reg = <0x5000 0x4>,
- <0x5010 0x4>,
- <0x5014 0x4>;
+ reg = <0x4000 0x4>,
+ <0x4010 0x4>,
+ <0x4014 0x4>;
reg-names = "rev", "sysc", "syss";
ti,sysc-sidle = <SYSC_IDLE_FORCE>,
<SYSC_IDLE_NO>,
@@ -504,7 +504,7 @@
ti,syss-mask = <1>;
#address-cells = <1>;
#size-cells = <1>;
- ranges = <0 0x5000 0x1000>;
+ ranges = <0 0x4000 0x1000>;
dsi1: encoder@0 {
compatible = "ti,omap5-dsi";
@@ -514,8 +514,9 @@
reg-names = "proto", "phy", "pll";
interrupts = <GIC_SPI 53 IRQ_TYPE_LEVEL_HIGH>;
status = "disabled";
- clocks = <&dss_clkctrl OMAP5_DSS_CORE_CLKCTRL 8>;
- clock-names = "fck";
+ clocks = <&dss_clkctrl OMAP5_DSS_CORE_CLKCTRL 8>,
+ <&dss_clkctrl OMAP5_DSS_CORE_CLKCTRL 10>;
+ clock-names = "fck", "sys_clk";
};
};
@@ -545,8 +546,9 @@
reg-names = "proto", "phy", "pll";
interrupts = <GIC_SPI 55 IRQ_TYPE_LEVEL_HIGH>;
status = "disabled";
- clocks = <&dss_clkctrl OMAP5_DSS_CORE_CLKCTRL 8>;
- clock-names = "fck";
+ clocks = <&dss_clkctrl OMAP5_DSS_CORE_CLKCTRL 8>,
+ <&dss_clkctrl OMAP5_DSS_CORE_CLKCTRL 10>;
+ clock-names = "fck", "sys_clk";
};
};
diff --git a/arch/arm/boot/dts/socfpga_arria10.dtsi b/arch/arm/boot/dts/socfpga_arria10.dtsi
index fc4abef..0013ec3 100644
--- a/arch/arm/boot/dts/socfpga_arria10.dtsi
+++ b/arch/arm/boot/dts/socfpga_arria10.dtsi
@@ -821,7 +821,7 @@
timer3: timer3@ffd00100 {
compatible = "snps,dw-apb-timer";
interrupts = <0 118 IRQ_TYPE_LEVEL_HIGH>;
- reg = <0xffd01000 0x100>;
+ reg = <0xffd00100 0x100>;
clocks = <&l4_sys_free_clk>;
clock-names = "timer";
resets = <&rst L4SYSTIMER1_RESET>;
diff --git a/arch/arm/configs/integrator_defconfig b/arch/arm/configs/integrator_defconfig
index a9755c5..b06e537 100644
--- a/arch/arm/configs/integrator_defconfig
+++ b/arch/arm/configs/integrator_defconfig
@@ -1,13 +1,11 @@
CONFIG_SYSVIPC=y
CONFIG_NO_HZ=y
CONFIG_HIGH_RES_TIMERS=y
+CONFIG_PREEMPT=y
CONFIG_IKCONFIG=y
CONFIG_IKCONFIG_PROC=y
CONFIG_LOG_BUF_SHIFT=14
CONFIG_BLK_DEV_INITRD=y
-CONFIG_MODULES=y
-CONFIG_MODULE_UNLOAD=y
-CONFIG_PARTITION_ADVANCED=y
CONFIG_ARCH_MULTI_V4T=y
CONFIG_ARCH_MULTI_V5=y
# CONFIG_ARCH_MULTI_V7 is not set
@@ -15,19 +13,17 @@
CONFIG_ARCH_INTEGRATOR_AP=y
CONFIG_INTEGRATOR_IMPD1=y
CONFIG_ARCH_INTEGRATOR_CP=y
-CONFIG_PCI=y
-CONFIG_PREEMPT=y
CONFIG_AEABI=y
# CONFIG_ATAGS is not set
-CONFIG_ZBOOT_ROM_TEXT=0x0
-CONFIG_ZBOOT_ROM_BSS=0x0
CONFIG_CMDLINE="console=ttyAM0,38400n8 root=/dev/nfs ip=bootp"
CONFIG_CPU_FREQ=y
CONFIG_CPU_FREQ_GOV_POWERSAVE=y
CONFIG_CPU_FREQ_GOV_USERSPACE=y
CONFIG_CPU_FREQ_GOV_ONDEMAND=y
CONFIG_CPUFREQ_DT=y
-CONFIG_CMA=y
+CONFIG_MODULES=y
+CONFIG_MODULE_UNLOAD=y
+CONFIG_PARTITION_ADVANCED=y
CONFIG_NET=y
CONFIG_PACKET=y
CONFIG_UNIX=y
@@ -37,6 +33,7 @@
CONFIG_IP_PNP_DHCP=y
CONFIG_IP_PNP_BOOTP=y
# CONFIG_IPV6 is not set
+CONFIG_PCI=y
CONFIG_MTD=y
CONFIG_MTD_CMDLINE_PARTS=y
CONFIG_MTD_AFS_PARTS=y
@@ -52,9 +49,12 @@
CONFIG_NETDEVICES=y
CONFIG_E100=y
CONFIG_SMC91X=y
+CONFIG_INPUT_EVDEV=y
# CONFIG_KEYBOARD_ATKBD is not set
+CONFIG_KEYBOARD_GPIO=y
# CONFIG_SERIO_SERPORT is not set
CONFIG_DRM=y
+CONFIG_DRM_DISPLAY_CONNECTOR=y
CONFIG_DRM_SIMPLE_BRIDGE=y
CONFIG_DRM_PL111=y
CONFIG_FB_MODE_HELPERS=y
diff --git a/arch/arm/mach-omap2/omap-iommu.c b/arch/arm/mach-omap2/omap-iommu.c
index 54aff33..bfa5e1b 100644
--- a/arch/arm/mach-omap2/omap-iommu.c
+++ b/arch/arm/mach-omap2/omap-iommu.c
@@ -74,7 +74,7 @@
return pwrdm;
clk = of_clk_get(dev->of_node->parent, 0);
- if (!clk) {
+ if (IS_ERR(clk)) {
dev_err(dev, "no fck found\n");
return NULL;
}
diff --git a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
index 9174ddc..3ec99f1 100644
--- a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
+++ b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
@@ -13,6 +13,7 @@
*/
#include <dt-bindings/power/xlnx-zynqmp-power.h>
+#include <dt-bindings/reset/xlnx-zynqmp-resets.h>
/ {
compatible = "xlnx,zynqmp";
@@ -558,6 +559,15 @@
};
};
+ psgtr: phy@fd400000 {
+ compatible = "xlnx,zynqmp-psgtr-v1.1";
+ status = "disabled";
+ reg = <0x0 0xfd400000 0x0 0x40000>,
+ <0x0 0xfd3d0000 0x0 0x1000>;
+ reg-names = "serdes", "siou";
+ #phy-cells = <4>;
+ };
+
rtc: rtc@ffa60000 {
compatible = "xlnx,zynqmp-rtc";
status = "disabled";
@@ -601,7 +611,7 @@
power-domains = <&zynqmp_firmware PD_SD_1>;
};
- smmu: smmu@fd800000 {
+ smmu: iommu@fd800000 {
compatible = "arm,mmu-500";
reg = <0x0 0xfd800000 0x0 0x20000>;
status = "disabled";
diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig
index e0f3382..6d04b95 100644
--- a/arch/arm64/configs/defconfig
+++ b/arch/arm64/configs/defconfig
@@ -724,6 +724,17 @@
CONFIG_USB_RENESAS_USBHS_UDC=m
CONFIG_USB_RENESAS_USB3=m
CONFIG_USB_TEGRA_XUDC=m
+CONFIG_USB_CONFIGFS=m
+CONFIG_USB_CONFIGFS_SERIAL=y
+CONFIG_USB_CONFIGFS_ACM=y
+CONFIG_USB_CONFIGFS_OBEX=y
+CONFIG_USB_CONFIGFS_NCM=y
+CONFIG_USB_CONFIGFS_ECM=y
+CONFIG_USB_CONFIGFS_ECM_SUBSET=y
+CONFIG_USB_CONFIGFS_RNDIS=y
+CONFIG_USB_CONFIGFS_EEM=y
+CONFIG_USB_CONFIGFS_MASS_STORAGE=y
+CONFIG_USB_CONFIGFS_F_FS=y
CONFIG_TYPEC=m
CONFIG_TYPEC_TCPM=m
CONFIG_TYPEC_FUSB302=m
@@ -914,6 +925,7 @@
CONFIG_ARCH_K3_AM6_SOC=y
CONFIG_ARCH_K3_J721E_SOC=y
CONFIG_TI_SCI_PM_DOMAINS=y
+CONFIG_EXTCON_PTN5150=m
CONFIG_EXTCON_USB_GPIO=y
CONFIG_EXTCON_USBC_CROS_EC=y
CONFIG_IIO=y
