| // SPDX-License-Identifier: GPL-2.0+ |
| |
| #include <linux/gpio/consumer.h> |
| #include <linux/i2c.h> |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/of.h> |
| #include <linux/regmap.h> |
| #include <linux/regulator/driver.h> |
| |
| #define RT4801_REG_VOP 0x00 |
| #define RT4801_REG_VON 0x01 |
| #define RT4801_REG_APPS 0x03 |
| |
| #define VOUT_MASK 0x1F |
| |
| #define MIN_UV 4000000 |
| #define STEP_UV 100000 |
| #define MAX_UV 6000000 |
| #define N_VOLTAGES ((MAX_UV - MIN_UV) / STEP_UV + 1) |
| |
| #define DSV_OUT_POS 0 |
| #define DSV_OUT_NEG 1 |
| #define DSV_OUT_MAX 2 |
| |
| #define DSVP_ENABLE BIT(0) |
| #define DSVN_ENABLE BIT(1) |
| #define DSVALL_ENABLE (DSVP_ENABLE | DSVN_ENABLE) |
| |
| struct rt4801_priv { |
| struct device *dev; |
| struct gpio_descs *enable_gpios; |
| unsigned int enable_flag; |
| unsigned int volt_sel[DSV_OUT_MAX]; |
| }; |
| |
| static int rt4801_set_voltage_sel(struct regulator_dev *rdev, unsigned int selector) |
| { |
| struct rt4801_priv *priv = rdev_get_drvdata(rdev); |
| int id = rdev_get_id(rdev), ret; |
| |
| if (priv->enable_flag & BIT(id)) { |
| ret = regulator_set_voltage_sel_regmap(rdev, selector); |
| if (ret) |
| return ret; |
| } |
| |
| priv->volt_sel[id] = selector; |
| return 0; |
| } |
| |
| static int rt4801_get_voltage_sel(struct regulator_dev *rdev) |
| { |
| struct rt4801_priv *priv = rdev_get_drvdata(rdev); |
| int id = rdev_get_id(rdev); |
| |
| if (priv->enable_flag & BIT(id)) |
| return regulator_get_voltage_sel_regmap(rdev); |
| |
| return priv->volt_sel[id]; |
| } |
| |
| static int rt4801_enable(struct regulator_dev *rdev) |
| { |
| struct rt4801_priv *priv = rdev_get_drvdata(rdev); |
| struct gpio_descs *gpios = priv->enable_gpios; |
| int id = rdev_get_id(rdev), ret; |
| |
| if (!gpios || gpios->ndescs <= id) { |
| dev_warn(&rdev->dev, "no dedicated gpio can control\n"); |
| goto bypass_gpio; |
| } |
| |
| gpiod_set_value(gpios->desc[id], 1); |
| |
| bypass_gpio: |
| ret = regmap_write(rdev->regmap, rdev->desc->vsel_reg, priv->volt_sel[id]); |
| if (ret) |
| return ret; |
| |
| priv->enable_flag |= BIT(id); |
| return 0; |
| } |
| |
| static int rt4801_disable(struct regulator_dev *rdev) |
| { |
| struct rt4801_priv *priv = rdev_get_drvdata(rdev); |
| struct gpio_descs *gpios = priv->enable_gpios; |
| int id = rdev_get_id(rdev); |
| |
| if (!gpios || gpios->ndescs <= id) { |
| dev_warn(&rdev->dev, "no dedicated gpio can control\n"); |
| goto bypass_gpio; |
| } |
| |
| gpiod_set_value(gpios->desc[id], 0); |
| |
| bypass_gpio: |
| priv->enable_flag &= ~BIT(id); |
| return 0; |
| } |
| |
| static int rt4801_is_enabled(struct regulator_dev *rdev) |
| { |
| struct rt4801_priv *priv = rdev_get_drvdata(rdev); |
| int id = rdev_get_id(rdev); |
| |
| return !!(priv->enable_flag & BIT(id)); |
| } |
| |
| static const struct regulator_ops rt4801_regulator_ops = { |
| .list_voltage = regulator_list_voltage_linear, |
| .set_voltage_sel = rt4801_set_voltage_sel, |
| .get_voltage_sel = rt4801_get_voltage_sel, |
| .enable = rt4801_enable, |
| .disable = rt4801_disable, |
| .is_enabled = rt4801_is_enabled, |
| }; |
| |
| static const struct regulator_desc rt4801_regulator_descs[] = { |
| { |
| .name = "DSVP", |
| .ops = &rt4801_regulator_ops, |
| .of_match = of_match_ptr("DSVP"), |
| .type = REGULATOR_VOLTAGE, |
| .id = DSV_OUT_POS, |
| .min_uV = MIN_UV, |
| .uV_step = STEP_UV, |
| .n_voltages = N_VOLTAGES, |
| .owner = THIS_MODULE, |
| .vsel_reg = RT4801_REG_VOP, |
| .vsel_mask = VOUT_MASK, |
| }, |
| { |
| .name = "DSVN", |
| .ops = &rt4801_regulator_ops, |
| .of_match = of_match_ptr("DSVN"), |
| .type = REGULATOR_VOLTAGE, |
| .id = DSV_OUT_NEG, |
| .min_uV = MIN_UV, |
| .uV_step = STEP_UV, |
| .n_voltages = N_VOLTAGES, |
| .owner = THIS_MODULE, |
| .vsel_reg = RT4801_REG_VON, |
| .vsel_mask = VOUT_MASK, |
| }, |
| }; |
| |
| static const struct regmap_config rt4801_regmap_config = { |
| .reg_bits = 8, |
| .val_bits = 8, |
| .max_register = RT4801_REG_APPS, |
| }; |
| |
| static int rt4801_probe(struct i2c_client *i2c) |
| { |
| struct rt4801_priv *priv; |
| struct regmap *regmap; |
| int i; |
| |
| priv = devm_kzalloc(&i2c->dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| |
| priv->dev = &i2c->dev; |
| /* bootloader will on, driver only reconfigure enable to all output high */ |
| priv->enable_flag = DSVALL_ENABLE; |
| |
| regmap = devm_regmap_init_i2c(i2c, &rt4801_regmap_config); |
| if (IS_ERR(regmap)) { |
| dev_err(&i2c->dev, "Failed to init regmap\n"); |
| return PTR_ERR(regmap); |
| } |
| |
| priv->enable_gpios = devm_gpiod_get_array_optional(&i2c->dev, "enable", GPIOD_OUT_HIGH); |
| if (IS_ERR(priv->enable_gpios)) { |
| dev_err(&i2c->dev, "Failed to get gpios\n"); |
| return PTR_ERR(priv->enable_gpios); |
| } |
| |
| for (i = 0; i < DSV_OUT_MAX; i++) { |
| const struct regulator_desc *desc = rt4801_regulator_descs + i; |
| struct regulator_config config = { .dev = &i2c->dev, .driver_data = priv, |
| .regmap = regmap, }; |
| struct regulator_dev *rdev; |
| unsigned int val; |
| int ret; |
| |
| /* initialize volt_sel variable */ |
| ret = regmap_read(regmap, desc->vsel_reg, &val); |
| if (ret) |
| return ret; |
| |
| priv->volt_sel[i] = val & desc->vsel_mask; |
| |
| rdev = devm_regulator_register(&i2c->dev, desc, &config); |
| if (IS_ERR(rdev)) { |
| dev_err(&i2c->dev, "Failed to register [%d] regulator\n", i); |
| return PTR_ERR(rdev); |
| } |
| } |
| |
| return 0; |
| } |
| |
| static const struct of_device_id __maybe_unused rt4801_of_id[] = { |
| { .compatible = "richtek,rt4801", }, |
| { }, |
| }; |
| MODULE_DEVICE_TABLE(of, rt4801_of_id); |
| |
| static struct i2c_driver rt4801_driver = { |
| .driver = { |
| .name = "rt4801", |
| .of_match_table = of_match_ptr(rt4801_of_id), |
| }, |
| .probe_new = rt4801_probe, |
| }; |
| module_i2c_driver(rt4801_driver); |
| |
| MODULE_AUTHOR("ChiYuan Hwang <cy_huang@richtek.com>"); |
| MODULE_DESCRIPTION("Richtek RT4801 Display Bias Driver"); |
| MODULE_LICENSE("GPL v2"); |