| // SPDX-License-Identifier: GPL-2.0-or-later |
| /* |
| * arch/powerpc/platforms/embedded6xx/wii.c |
| * |
| * Nintendo Wii board-specific support |
| * Copyright (C) 2008-2009 The GameCube Linux Team |
| * Copyright (C) 2008,2009 Albert Herranz |
| */ |
| #define DRV_MODULE_NAME "wii" |
| #define pr_fmt(fmt) DRV_MODULE_NAME ": " fmt |
| |
| #include <linux/kernel.h> |
| #include <linux/init.h> |
| #include <linux/irq.h> |
| #include <linux/seq_file.h> |
| #include <linux/of_address.h> |
| #include <linux/of_platform.h> |
| |
| #include <asm/io.h> |
| #include <asm/machdep.h> |
| #include <asm/time.h> |
| #include <asm/udbg.h> |
| |
| #include "flipper-pic.h" |
| #include "hlwd-pic.h" |
| #include "usbgecko_udbg.h" |
| |
| /* control block */ |
| #define HW_CTRL_COMPATIBLE "nintendo,hollywood-control" |
| |
| #define HW_CTRL_RESETS 0x94 |
| #define HW_CTRL_RESETS_SYS (1<<0) |
| |
| /* gpio */ |
| #define HW_GPIO_COMPATIBLE "nintendo,hollywood-gpio" |
| |
| #define HW_GPIO_BASE(idx) (idx * 0x20) |
| #define HW_GPIO_OUT(idx) (HW_GPIO_BASE(idx) + 0) |
| #define HW_GPIO_DIR(idx) (HW_GPIO_BASE(idx) + 4) |
| #define HW_GPIO_OWNER (HW_GPIO_BASE(1) + 0x1c) |
| |
| #define HW_GPIO_SHUTDOWN (1<<1) |
| #define HW_GPIO_SLOT_LED (1<<5) |
| #define HW_GPIO_SENSOR_BAR (1<<8) |
| |
| |
| static void __iomem *hw_ctrl; |
| static void __iomem *hw_gpio; |
| |
| static void __noreturn wii_spin(void) |
| { |
| local_irq_disable(); |
| for (;;) |
| cpu_relax(); |
| } |
| |
| static void __iomem *__init wii_ioremap_hw_regs(char *name, char *compatible) |
| { |
| void __iomem *hw_regs = NULL; |
| struct device_node *np; |
| struct resource res; |
| int error = -ENODEV; |
| |
| np = of_find_compatible_node(NULL, NULL, compatible); |
| if (!np) { |
| pr_err("no compatible node found for %s\n", compatible); |
| goto out; |
| } |
| error = of_address_to_resource(np, 0, &res); |
| if (error) { |
| pr_err("no valid reg found for %pOFn\n", np); |
| goto out_put; |
| } |
| |
| hw_regs = ioremap(res.start, resource_size(&res)); |
| if (hw_regs) { |
| pr_info("%s at 0x%pa mapped to 0x%p\n", name, |
| &res.start, hw_regs); |
| } |
| |
| out_put: |
| of_node_put(np); |
| out: |
| return hw_regs; |
| } |
| |
| static void __init wii_setup_arch(void) |
| { |
| hw_ctrl = wii_ioremap_hw_regs("hw_ctrl", HW_CTRL_COMPATIBLE); |
| hw_gpio = wii_ioremap_hw_regs("hw_gpio", HW_GPIO_COMPATIBLE); |
| if (hw_gpio) { |
| /* turn off the front blue led and IR light */ |
| clrbits32(hw_gpio + HW_GPIO_OUT(0), |
| HW_GPIO_SLOT_LED | HW_GPIO_SENSOR_BAR); |
| } |
| } |
| |
| static void __noreturn wii_restart(char *cmd) |
| { |
| local_irq_disable(); |
| |
| if (hw_ctrl) { |
| /* clear the system reset pin to cause a reset */ |
| clrbits32(hw_ctrl + HW_CTRL_RESETS, HW_CTRL_RESETS_SYS); |
| } |
| wii_spin(); |
| } |
| |
| static void wii_power_off(void) |
| { |
| local_irq_disable(); |
| |
| if (hw_gpio) { |
| /* |
| * set the owner of the shutdown pin to ARM, because it is |
| * accessed through the registers for the ARM, below |
| */ |
| clrbits32(hw_gpio + HW_GPIO_OWNER, HW_GPIO_SHUTDOWN); |
| |
| /* make sure that the poweroff GPIO is configured as output */ |
| setbits32(hw_gpio + HW_GPIO_DIR(1), HW_GPIO_SHUTDOWN); |
| |
| /* drive the poweroff GPIO high */ |
| setbits32(hw_gpio + HW_GPIO_OUT(1), HW_GPIO_SHUTDOWN); |
| } |
| wii_spin(); |
| } |
| |
| static void __noreturn wii_halt(void) |
| { |
| if (ppc_md.restart) |
| ppc_md.restart(NULL); |
| wii_spin(); |
| } |
| |
| static void __init wii_pic_probe(void) |
| { |
| flipper_pic_probe(); |
| hlwd_pic_probe(); |
| } |
| |
| static int __init wii_probe(void) |
| { |
| pm_power_off = wii_power_off; |
| |
| ug_udbg_init(); |
| |
| return 1; |
| } |
| |
| static void wii_shutdown(void) |
| { |
| hlwd_quiesce(); |
| flipper_quiesce(); |
| } |
| |
| static const struct of_device_id wii_of_bus[] = { |
| { .compatible = "nintendo,hollywood", }, |
| { }, |
| }; |
| |
| static int __init wii_device_probe(void) |
| { |
| of_platform_populate(NULL, wii_of_bus, NULL, NULL); |
| return 0; |
| } |
| machine_device_initcall(wii, wii_device_probe); |
| |
| define_machine(wii) { |
| .name = "wii", |
| .compatible = "nintendo,wii", |
| .probe = wii_probe, |
| .setup_arch = wii_setup_arch, |
| .restart = wii_restart, |
| .halt = wii_halt, |
| .init_IRQ = wii_pic_probe, |
| .get_irq = flipper_pic_get_irq, |
| .progress = udbg_progress, |
| .machine_shutdown = wii_shutdown, |
| }; |