| * Denali NAND controller |
| |
| Required properties: |
| - compatible : should be one of the following: |
| "altr,socfpga-denali-nand" - for Altera SOCFPGA |
| "socionext,uniphier-denali-nand-v5a" - for Socionext UniPhier (v5a) |
| "socionext,uniphier-denali-nand-v5b" - for Socionext UniPhier (v5b) |
| - reg : should contain registers location and length for data and reg. |
| - reg-names: Should contain the reg names "nand_data" and "denali_reg" |
| - interrupts : The interrupt number. |
| |
| Optional properties: |
| - nand-ecc-step-size: see nand.txt for details. If present, the value must be |
| 512 for "altr,socfpga-denali-nand" |
| 1024 for "socionext,uniphier-denali-nand-v5a" |
| 1024 for "socionext,uniphier-denali-nand-v5b" |
| - nand-ecc-strength: see nand.txt for details. Valid values are: |
| 8, 15 for "altr,socfpga-denali-nand" |
| 8, 16, 24 for "socionext,uniphier-denali-nand-v5a" |
| 8, 16 for "socionext,uniphier-denali-nand-v5b" |
| - nand-ecc-maximize: see nand.txt for details |
| |
| The device tree may optionally contain sub-nodes describing partitions of the |
| address space. See partition.txt for more detail. |
| |
| Examples: |
| |
| nand: nand@ff900000 { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| compatible = "altr,socfpga-denali-nand"; |
| reg = <0xff900000 0x20>, <0xffb80000 0x1000>; |
| reg-names = "nand_data", "denali_reg"; |
| interrupts = <0 144 4>; |
| }; |
