| # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause |
| %YAML 1.2 |
| --- |
| $id: http://devicetree.org/schemas/mfd/cirrus,lochnagar.yaml# |
| $schema: http://devicetree.org/meta-schemas/core.yaml# |
| |
| title: Cirrus Logic Lochnagar Audio Development Board |
| |
| maintainers: |
| - patches@opensource.cirrus.com |
| |
| description: | |
| Lochnagar is an evaluation and development board for Cirrus Logic |
| Smart CODEC and Amp devices. It allows the connection of most Cirrus |
| Logic devices on mini-cards, as well as allowing connection of |
| various application processor systems to provide a full evaluation |
| platform. Audio system topology, clocking and power can all be |
| controlled through the Lochnagar, allowing the device under test |
| to be used in a variety of possible use cases. |
| |
| Also see these documents for generic binding information: |
| [1] GPIO : ../gpio/gpio.txt |
| |
| And these for relevant defines: |
| [2] include/dt-bindings/pinctrl/lochnagar.h |
| [3] include/dt-bindings/clock/lochnagar.h |
| |
| And these documents for the required sub-node binding details: |
| [4] Clock: ../clock/cirrus,lochnagar.yaml |
| [5] Pinctrl: ../pinctrl/cirrus,lochnagar.yaml |
| [6] Sound: ../sound/cirrus,lochnagar.yaml |
| [7] Hardware Monitor: ../hwmon/cirrus,lochnagar.yaml |
| |
| allOf: |
| - if: |
| properties: |
| compatible: |
| enum: |
| - cirrus,lochnagar2 |
| then: |
| properties: |
| lochnagar-hwmon: |
| type: object |
| $ref: /schemas/hwmon/cirrus,lochnagar.yaml# |
| |
| lochnagar-sc: |
| type: object |
| $ref: /schemas/sound/cirrus,lochnagar.yaml# |
| |
| properties: |
| compatible: |
| enum: |
| - cirrus,lochnagar1 |
| - cirrus,lochnagar2 |
| |
| reg: |
| const: 0x22 |
| |
| reset-gpios: |
| maxItems: 1 |
| |
| present-gpios: |
| description: | |
| Host present line, indicating the presence of a |
| host system, see [1]. This can be omitted if the present line is |
| tied in hardware. |
| maxItems: 1 |
| |
| lochnagar-clk: |
| type: object |
| $ref: /schemas/clock/cirrus,lochnagar.yaml# |
| |
| lochnagar-pmic32k: |
| type: object |
| $ref: /schemas/clock/fixed-clock.yaml# |
| properties: |
| clock-frequency: |
| const: 32768 |
| |
| lochnagar-clk12m: |
| type: object |
| $ref: /schemas/clock/fixed-clock.yaml# |
| properties: |
| clock-frequency: |
| const: 12288000 |
| |
| lochnagar-clk11m: |
| type: object |
| $ref: /schemas/clock/fixed-clock.yaml# |
| properties: |
| clock-frequency: |
| const: 11298600 |
| |
| lochnagar-clk24m: |
| type: object |
| $ref: /schemas/clock/fixed-clock.yaml# |
| properties: |
| clock-frequency: |
| const: 24576000 |
| |
| lochnagar-clk22m: |
| type: object |
| $ref: /schemas/clock/fixed-clock.yaml# |
| properties: |
| clock-frequency: |
| const: 22579200 |
| |
| lochnagar-clk8m: |
| type: object |
| $ref: /schemas/clock/fixed-clock.yaml# |
| properties: |
| clock-frequency: |
| const: 8192000 |
| |
| lochnagar-usb24m: |
| type: object |
| $ref: /schemas/clock/fixed-clock.yaml# |
| properties: |
| clock-frequency: |
| const: 24576000 |
| |
| lochnagar-usb12m: |
| type: object |
| $ref: /schemas/clock/fixed-clock.yaml# |
| properties: |
| clock-frequency: |
| const: 12288000 |
| |
| pinctrl: |
| type: object |
| $ref: /schemas/pinctrl/cirrus,lochnagar.yaml# |
| |
| lochnagar-hwmon: |
| type: object |
| $ref: /schemas/hwmon/cirrus,lochnagar.yaml# |
| |
| lochnagar-sc: |
| type: object |
| $ref: /schemas/sound/cirrus,lochnagar.yaml# |
| |
| VDDCORE: |
| description: |
| Initialisation data for the VDDCORE regulator, which supplies the |
| CODECs digital core if not being provided by an internal regulator. |
| type: object |
| $ref: /schemas/regulator/regulator.yaml# |
| properties: |
| compatible: |
| enum: |
| - cirrus,lochnagar2-vddcore |
| |
| SYSVDD-supply: |
| description: |
| Primary power supply for the Lochnagar. |
| required: |
| - compatible |
| |
| MICVDD: |
| description: |
| Initialisation data for the MICVDD regulator, which supplies the |
| CODECs MICVDD. |
| type: object |
| $ref: /schemas/regulator/regulator.yaml# |
| properties: |
| compatible: |
| enum: |
| - cirrus,lochnagar2-micvdd |
| |
| SYSVDD-supply: |
| description: |
| Primary power supply for the Lochnagar. |
| required: |
| - compatible |
| |
| MIC1VDD: |
| description: |
| Initialisation data for the MIC1VDD supplies. |
| type: object |
| $ref: /schemas/regulator/regulator.yaml# |
| properties: |
| compatible: |
| enum: |
| - cirrus,lochnagar2-mic1vdd |
| |
| cirrus,micbias-input: |
| description: |
| A property selecting which of the CODEC minicard micbias outputs |
| should be used. |
| $ref: /schemas/types.yaml#/definitions/uint32 |
| minimum: 1 |
| maximum: 4 |
| |
| MICBIAS1-supply: |
| description: |
| Regulator supplies for the MIC1VDD outputs, supplying the digital |
| microphones, normally supplied from the attached CODEC. |
| required: |
| - compatible |
| |
| MIC2VDD: |
| description: |
| Initialisation data for the MIC2VDD supplies. |
| type: object |
| $ref: /schemas/regulator/regulator.yaml# |
| properties: |
| compatible: |
| enum: |
| - cirrus,lochnagar2-mic2vdd |
| |
| cirrus,micbias-input: |
| description: |
| A property selecting which of the CODEC minicard micbias outputs |
| should be used. |
| $ref: /schemas/types.yaml#/definitions/uint32 |
| minimum: 1 |
| maximum: 4 |
| |
| MICBIAS2-supply: |
| description: |
| Regulator supplies for the MIC2VDD outputs, supplying the digital |
| microphones, normally supplied from the attached CODEC. |
| required: |
| - compatible |
| |
| VDD1V8: |
| description: |
| Recommended fixed regulator for the VDD1V8 regulator, which supplies |
| the CODECs analog and 1.8V digital supplies. |
| type: object |
| $ref: /schemas/regulator/regulator.yaml# |
| properties: |
| compatible: |
| enum: |
| - regulator-fixed |
| |
| regulator-min-microvolt: |
| const: 1800000 |
| |
| regulator-max-microvolt: |
| const: 1800000 |
| |
| vin-supply: |
| description: |
| Should be set to same supply as SYSVDD |
| required: |
| - compatible |
| - regulator-min-microvolt |
| - regulator-max-microvolt |
| - regulator-boot-on |
| - regulator-always-on |
| - vin-supply |
| |
| required: |
| - compatible |
| - reg |
| - reset-gpios |
| - lochnagar-clk |
| - pinctrl |
| |
| additionalProperties: false |
| |
| examples: |
| - | |
| #include <dt-bindings/clk/lochnagar.h> |
| #include <dt-bindings/pinctrl/lochnagar.h> |
| i2c@e0004000 { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| reg = <0xe0004000 0x1000>; |
| |
| lochnagar: lochnagar@22 { |
| compatible = "cirrus,lochnagar2"; |
| reg = <0x22>; |
| |
| reset-gpios = <&gpio0 55 0>; |
| present-gpios = <&gpio0 60 0>; |
| |
| lochnagarclk: lochnagar-clk { |
| compatible = "cirrus,lochnagar2-clk"; |
| |
| #clock-cells = <1>; |
| clocks = <&clkaudio>, <&clkpmic>; |
| clock-names = "ln-gf-mclk2", "ln-pmic-32k"; |
| |
| assigned-clocks = <&lochnagarclk LOCHNAGAR_CDC_MCLK1>, |
| <&lochnagarclk LOCHNAGAR_CDC_MCLK2>; |
| assigned-clock-parents = <&clkaudio>, <&clkpmic>; |
| }; |
| |
| clkpmic: lochnagar-pmic32k { |
| compatible = "fixed-clock"; |
| #clock-cells = <0>; |
| clock-frequency = <32768>; |
| }; |
| |
| pinctrl { |
| compatible = "cirrus,lochnagar-pinctrl"; |
| |
| gpio-controller; |
| #gpio-cells = <2>; |
| gpio-ranges = <&lochnagar 0 0 LOCHNAGAR2_PIN_NUM_GPIOS>; |
| |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinsettings>; |
| |
| pinsettings: pin-settings { |
| ap2aif-pins { |
| input-enable; |
| groups = "gf-aif1"; |
| function = "codec-aif3"; |
| }; |
| codec2aif-pins { |
| output-enable; |
| groups = "codec-aif3"; |
| function = "gf-aif1"; |
| }; |
| }; |
| }; |
| |
| lochnagar-sc { |
| compatible = "cirrus,lochnagar2-soundcard"; |
| |
| #sound-dai-cells = <1>; |
| |
| clocks = <&lochnagarclk LOCHNAGAR_SOUNDCARD_MCLK>; |
| clock-names = "mclk"; |
| }; |
| |
| lochnagar-hwmon { |
| compatible = "cirrus,lochnagar2-hwmon"; |
| }; |
| |
| MIC1VDD { |
| compatible = "cirrus,lochnagar2-mic1vdd"; |
| |
| cirrus,micbias-input = <3>; |
| }; |
| |
| MICVDD { |
| compatible = "cirrus,lochnagar2-micvdd"; |
| |
| SYSVDD-supply = <&wallvdd>; |
| |
| regulator-min-microvolt = <3300000>; |
| regulator-max-microvolt = <3300000>; |
| }; |
| |
| VDD1V8 { |
| compatible = "regulator-fixed"; |
| |
| regulator-name = "VDD1V8"; |
| regulator-min-microvolt = <1800000>; |
| regulator-max-microvolt = <1800000>; |
| regulator-boot-on; |
| regulator-always-on; |
| |
| vin-supply = <&wallvdd>; |
| }; |
| }; |
| }; |