| #include <dt-bindings/iio/qcom,spmi-vadc.h> |
| #include <dt-bindings/interrupt-controller/irq.h> |
| #include <dt-bindings/spmi/spmi.h> |
| |
| &spmi_bus { |
| |
| pm8916_0: pm8916@0 { |
| compatible = "qcom,pm8916", "qcom,spmi-pmic"; |
| reg = <0x0 SPMI_USID>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| rtc@6000 { |
| compatible = "qcom,pm8941-rtc"; |
| reg = <0x6000>; |
| reg-names = "rtc", "alarm"; |
| interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>; |
| }; |
| |
| pwrkey@800 { |
| compatible = "qcom,pm8941-pwrkey"; |
| reg = <0x800>; |
| interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>; |
| debounce = <15625>; |
| bias-pull-up; |
| }; |
| |
| pm8916_gpios: gpios@c000 { |
| compatible = "qcom,pm8916-gpio"; |
| reg = <0xc000>; |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupts = <0 0xc0 0 IRQ_TYPE_NONE>, |
| <0 0xc1 0 IRQ_TYPE_NONE>, |
| <0 0xc2 0 IRQ_TYPE_NONE>, |
| <0 0xc3 0 IRQ_TYPE_NONE>; |
| }; |
| |
| pm8916_mpps: mpps@a000 { |
| compatible = "qcom,pm8916-mpp"; |
| reg = <0xa000>; |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupts = <0 0xa0 0 IRQ_TYPE_NONE>, |
| <0 0xa1 0 IRQ_TYPE_NONE>, |
| <0 0xa2 0 IRQ_TYPE_NONE>, |
| <0 0xa3 0 IRQ_TYPE_NONE>; |
| }; |
| |
| pm8916_temp: temp-alarm@2400 { |
| compatible = "qcom,spmi-temp-alarm"; |
| reg = <0x2400>; |
| interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>; |
| io-channels = <&pm8916_vadc VADC_DIE_TEMP>; |
| io-channel-names = "thermal"; |
| #thermal-sensor-cells = <0>; |
| }; |
| |
| pm8916_vadc: vadc@3100 { |
| compatible = "qcom,spmi-vadc"; |
| reg = <0x3100>; |
| interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| #io-channel-cells = <1>; |
| |
| usb_in { |
| reg = <VADC_USBIN>; |
| qcom,pre-scaling = <1 10>; |
| }; |
| vph_pwr { |
| reg = <VADC_VSYS>; |
| qcom,pre-scaling = <1 3>; |
| }; |
| die_temp { |
| reg = <VADC_DIE_TEMP>; |
| }; |
| ref_625mv { |
| reg = <VADC_REF_625MV>; |
| }; |
| ref_1250v { |
| reg = <VADC_REF_1250MV>; |
| }; |
| ref_gnd { |
| reg = <VADC_GND_REF>; |
| }; |
| ref_vdd { |
| reg = <VADC_VDD_VADC>; |
| }; |
| }; |
| }; |
| |
| pm8916_1: pm8916@1 { |
| compatible = "qcom,spmi-pmic"; |
| reg = <0x1 SPMI_USID>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| }; |
| }; |
