| // SPDX-License-Identifier: GPL-2.0 | |
| /* | |
| * Copyright (C) 2012 Regents of the University of California | |
| * Copyright (C) 2017 SiFive | |
| * | |
| * All RISC-V systems have a timer attached to every hart. These timers can | |
| * either be read from the "time" and "timeh" CSRs, and can use the SBI to | |
| * setup events, or directly accessed using MMIO registers. | |
| */ | |
| #define pr_fmt(fmt) "riscv-timer: " fmt | |
| #include <linux/acpi.h> | |
| #include <linux/clocksource.h> | |
| #include <linux/clockchips.h> | |
| #include <linux/cpu.h> | |
| #include <linux/delay.h> | |
| #include <linux/irq.h> | |
| #include <linux/irqdomain.h> | |
| #include <linux/module.h> | |
| #include <linux/sched_clock.h> | |
| #include <linux/io-64-nonatomic-lo-hi.h> | |
| #include <linux/interrupt.h> | |
| #include <linux/of_irq.h> | |
| #include <linux/limits.h> | |
| #include <clocksource/timer-riscv.h> | |
| #include <asm/smp.h> | |
| #include <asm/cpufeature.h> | |
| #include <asm/sbi.h> | |
| #include <asm/timex.h> | |
| static DEFINE_STATIC_KEY_FALSE(riscv_sstc_available); | |
| static bool riscv_timer_cannot_wake_cpu; | |
| static void riscv_clock_event_stop(void) | |
| { | |
| if (static_branch_likely(&riscv_sstc_available)) { | |
| csr_write(CSR_STIMECMP, ULONG_MAX); | |
| if (IS_ENABLED(CONFIG_32BIT)) | |
| csr_write(CSR_STIMECMPH, ULONG_MAX); | |
| } else { | |
| sbi_set_timer(U64_MAX); | |
| } | |
| } | |
| static int riscv_clock_next_event(unsigned long delta, | |
| struct clock_event_device *ce) | |
| { | |
| u64 next_tval = get_cycles64() + delta; | |
| if (static_branch_likely(&riscv_sstc_available)) { | |
| #if defined(CONFIG_32BIT) | |
| csr_write(CSR_STIMECMP, ULONG_MAX); | |
| csr_write(CSR_STIMECMPH, next_tval >> 32); | |
| csr_write(CSR_STIMECMP, next_tval & 0xFFFFFFFF); | |
| #else | |
| csr_write(CSR_STIMECMP, next_tval); | |
| #endif | |
| } else | |
| sbi_set_timer(next_tval); | |
| return 0; | |
| } | |
| static int riscv_clock_shutdown(struct clock_event_device *evt) | |
| { | |
| riscv_clock_event_stop(); | |
| return 0; | |
| } | |
| static unsigned int riscv_clock_event_irq; | |
| static DEFINE_PER_CPU(struct clock_event_device, riscv_clock_event) = { | |
| .name = "riscv_timer_clockevent", | |
| .features = CLOCK_EVT_FEAT_ONESHOT, | |
| .rating = 100, | |
| .set_next_event = riscv_clock_next_event, | |
| .set_state_shutdown = riscv_clock_shutdown, | |
| }; | |
| /* | |
| * It is guaranteed that all the timers across all the harts are synchronized | |
| * within one tick of each other, so while this could technically go | |
| * backwards when hopping between CPUs, practically it won't happen. | |
| */ | |
| static unsigned long long riscv_clocksource_rdtime(struct clocksource *cs) | |
| { | |
| return get_cycles64(); | |
| } | |
| static u64 notrace riscv_sched_clock(void) | |
| { | |
| return get_cycles64(); | |
| } | |
| static struct clocksource riscv_clocksource = { | |
| .name = "riscv_clocksource", | |
| .rating = 400, | |
| .mask = CLOCKSOURCE_MASK(64), | |
| .flags = CLOCK_SOURCE_IS_CONTINUOUS, | |
| .read = riscv_clocksource_rdtime, | |
| .vdso_clock_mode = VDSO_CLOCKMODE_ARCHTIMER, | |
| }; | |
| static int riscv_timer_starting_cpu(unsigned int cpu) | |
| { | |
| struct clock_event_device *ce = per_cpu_ptr(&riscv_clock_event, cpu); | |
| /* Clear timer interrupt */ | |
| riscv_clock_event_stop(); | |
| ce->cpumask = cpumask_of(cpu); | |
| ce->irq = riscv_clock_event_irq; | |
| if (riscv_timer_cannot_wake_cpu) | |
| ce->features |= CLOCK_EVT_FEAT_C3STOP; | |
| if (static_branch_likely(&riscv_sstc_available)) | |
| ce->rating = 450; | |
| clockevents_config_and_register(ce, riscv_timebase, 100, ULONG_MAX); | |
| enable_percpu_irq(riscv_clock_event_irq, | |
| irq_get_trigger_type(riscv_clock_event_irq)); | |
| return 0; | |
| } | |
| static int riscv_timer_dying_cpu(unsigned int cpu) | |
| { | |
| /* | |
| * Stop the timer when the cpu is going to be offline otherwise | |
| * the timer interrupt may be pending while performing power-down. | |
| */ | |
| riscv_clock_event_stop(); | |
| disable_percpu_irq(riscv_clock_event_irq); | |
| return 0; | |
| } | |
| void riscv_cs_get_mult_shift(u32 *mult, u32 *shift) | |
| { | |
| *mult = riscv_clocksource.mult; | |
| *shift = riscv_clocksource.shift; | |
| } | |
| EXPORT_SYMBOL_GPL(riscv_cs_get_mult_shift); | |
| /* called directly from the low-level interrupt handler */ | |
| static irqreturn_t riscv_timer_interrupt(int irq, void *dev_id) | |
| { | |
| struct clock_event_device *evdev = this_cpu_ptr(&riscv_clock_event); | |
| riscv_clock_event_stop(); | |
| evdev->event_handler(evdev); | |
| return IRQ_HANDLED; | |
| } | |
| static int __init riscv_timer_init_common(void) | |
| { | |
| int error; | |
| struct irq_domain *domain; | |
| struct fwnode_handle *intc_fwnode = riscv_get_intc_hwnode(); | |
| domain = irq_find_matching_fwnode(intc_fwnode, DOMAIN_BUS_ANY); | |
| if (!domain) { | |
| pr_err("Failed to find irq_domain for INTC node [%pfwP]\n", | |
| intc_fwnode); | |
| return -ENODEV; | |
| } | |
| riscv_clock_event_irq = irq_create_mapping(domain, RV_IRQ_TIMER); | |
| if (!riscv_clock_event_irq) { | |
| pr_err("Failed to map timer interrupt for node [%pfwP]\n", intc_fwnode); | |
| return -ENODEV; | |
| } | |
| error = clocksource_register_hz(&riscv_clocksource, riscv_timebase); | |
| if (error) { | |
| pr_err("RISCV timer registration failed [%d]\n", error); | |
| return error; | |
| } | |
| sched_clock_register(riscv_sched_clock, 64, riscv_timebase); | |
| error = request_percpu_irq(riscv_clock_event_irq, | |
| riscv_timer_interrupt, | |
| "riscv-timer", &riscv_clock_event); | |
| if (error) { | |
| pr_err("registering percpu irq failed [%d]\n", error); | |
| return error; | |
| } | |
| if (riscv_isa_extension_available(NULL, SSTC)) { | |
| pr_info("Timer interrupt in S-mode is available via sstc extension\n"); | |
| static_branch_enable(&riscv_sstc_available); | |
| } | |
| error = cpuhp_setup_state(CPUHP_AP_RISCV_TIMER_STARTING, | |
| "clockevents/riscv/timer:starting", | |
| riscv_timer_starting_cpu, riscv_timer_dying_cpu); | |
| if (error) | |
| pr_err("cpu hp setup state failed for RISCV timer [%d]\n", | |
| error); | |
| return error; | |
| } | |
| static int __init riscv_timer_init_dt(struct device_node *n) | |
| { | |
| int cpuid, error; | |
| unsigned long hartid; | |
| struct device_node *child; | |
| error = riscv_of_processor_hartid(n, &hartid); | |
| if (error < 0) { | |
| pr_warn("Invalid hartid for node [%pOF] error = [%lu]\n", | |
| n, hartid); | |
| return error; | |
| } | |
| cpuid = riscv_hartid_to_cpuid(hartid); | |
| if (cpuid < 0) { | |
| pr_warn("Invalid cpuid for hartid [%lu]\n", hartid); | |
| return cpuid; | |
| } | |
| if (cpuid != smp_processor_id()) | |
| return 0; | |
| child = of_find_compatible_node(NULL, NULL, "riscv,timer"); | |
| if (child) { | |
| riscv_timer_cannot_wake_cpu = of_property_read_bool(child, | |
| "riscv,timer-cannot-wake-cpu"); | |
| of_node_put(child); | |
| } | |
| return riscv_timer_init_common(); | |
| } | |
| TIMER_OF_DECLARE(riscv_timer, "riscv", riscv_timer_init_dt); | |
| #ifdef CONFIG_ACPI | |
| static int __init riscv_timer_acpi_init(struct acpi_table_header *table) | |
| { | |
| struct acpi_table_rhct *rhct = (struct acpi_table_rhct *)table; | |
| riscv_timer_cannot_wake_cpu = rhct->flags & ACPI_RHCT_TIMER_CANNOT_WAKEUP_CPU; | |
| return riscv_timer_init_common(); | |
| } | |
| TIMER_ACPI_DECLARE(aclint_mtimer, ACPI_SIG_RHCT, riscv_timer_acpi_init); | |
| #endif |