| Freescale's NAND flash controller (NFC) |
| |
| This variant of the Freescale NAND flash controller (NFC) can be found on |
| Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70. |
| |
| Required properties: |
| - compatible: Should be set to "fsl,vf610-nfc". |
| - reg: address range of the NFC. |
| - interrupts: interrupt of the NFC. |
| - #address-cells: shall be set to 1. Encode the nand CS. |
| - #size-cells : shall be set to 0. |
| - assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>; |
| - assigned-clock-rates: The NAND bus timing is derived from this clock |
| rate and should not exceed maximum timing for any NAND memory chip |
| in a board stuffing. Typical NAND memory timings derived from this |
| clock are found in the SoC hardware reference manual. Furthermore, |
| there might be restrictions on maximum rates when using hardware ECC. |
| |
| - #address-cells, #size-cells : Must be present if the device has sub-nodes |
| representing partitions. |
| |
| Required children nodes: |
| Children nodes represent the available nand chips. Currently the driver can |
| only handle one NAND chip. |
| |
| Required properties: |
| - compatible: Should be set to "fsl,vf610-nfc-cs". |
| - nand-bus-width: see nand-controller.yaml |
| - nand-ecc-mode: see nand-controller.yaml |
| |
| Required properties for hardware ECC: |
| - nand-ecc-strength: supported strengths are 24 and 32 bit (see nand-controller.yaml) |
| - nand-ecc-step-size: step size equals page size, currently only 2k pages are |
| supported |
| - nand-on-flash-bbt: see nand-controller.yaml |
| |
| Example: |
| |
| nfc: nand@400e0000 { |
| compatible = "fsl,vf610-nfc"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| reg = <0x400e0000 0x4000>; |
| interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>; |
| clocks = <&clks VF610_CLK_NFC>; |
| clock-names = "nfc"; |
| assigned-clocks = <&clks VF610_CLK_NFC>; |
| assigned-clock-rates = <33000000>; |
| |
| nand@0 { |
| compatible = "fsl,vf610-nfc-nandcs"; |
| reg = <0>; |
| nand-bus-width = <8>; |
| nand-ecc-mode = "hw"; |
| nand-ecc-strength = <32>; |
| nand-ecc-step-size = <2048>; |
| nand-on-flash-bbt; |
| }; |
| }; |