| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * i.MX8QXP/i.MX8QM JPEG encoder/decoder v4l2 driver |
| * |
| * Copyright 2018-2019 NXP |
| */ |
| |
| #include <linux/delay.h> |
| #include <media/videobuf2-core.h> |
| #include "mxc-jpeg-hw.h" |
| |
| #define print_wrapper_reg(dev, base_address, reg_offset)\ |
| internal_print_wrapper_reg(dev, (base_address), #reg_offset,\ |
| (reg_offset)) |
| #define internal_print_wrapper_reg(dev, base_address, reg_name, reg_offset) {\ |
| int val;\ |
| val = readl((base_address) + (reg_offset));\ |
| dev_dbg(dev, "Wrapper reg %s = 0x%x\n", reg_name, val);\ |
| } |
| |
| void print_descriptor_info(struct device *dev, struct mxc_jpeg_desc *desc) |
| { |
| dev_dbg(dev, " MXC JPEG NEXT_DESCPT_PTR 0x%x\n", |
| desc->next_descpt_ptr); |
| dev_dbg(dev, " MXC JPEG BUF_BASE0 0x%x\n", desc->buf_base0); |
| dev_dbg(dev, " MXC JPEG BUF_BASE1 0x%x\n", desc->buf_base1); |
| dev_dbg(dev, " MXC JPEG LINE_PITCH %d\n", desc->line_pitch); |
| dev_dbg(dev, " MXC JPEG STM_BUFBASE 0x%x\n", desc->stm_bufbase); |
| dev_dbg(dev, " MXC JPEG STM_BUFSIZE %d\n", desc->stm_bufsize); |
| dev_dbg(dev, " MXC JPEG IMGSIZE %x (%d x %d)\n", desc->imgsize, |
| desc->imgsize >> 16, desc->imgsize & 0xFFFF); |
| dev_dbg(dev, " MXC JPEG STM_CTRL 0x%x\n", desc->stm_ctrl); |
| } |
| |
| void print_cast_status(struct device *dev, void __iomem *reg, |
| unsigned int mode) |
| { |
| dev_dbg(dev, "CAST IP status regs:\n"); |
| print_wrapper_reg(dev, reg, CAST_STATUS0); |
| print_wrapper_reg(dev, reg, CAST_STATUS1); |
| print_wrapper_reg(dev, reg, CAST_STATUS2); |
| print_wrapper_reg(dev, reg, CAST_STATUS3); |
| print_wrapper_reg(dev, reg, CAST_STATUS4); |
| print_wrapper_reg(dev, reg, CAST_STATUS5); |
| print_wrapper_reg(dev, reg, CAST_STATUS6); |
| print_wrapper_reg(dev, reg, CAST_STATUS7); |
| print_wrapper_reg(dev, reg, CAST_STATUS8); |
| print_wrapper_reg(dev, reg, CAST_STATUS9); |
| print_wrapper_reg(dev, reg, CAST_STATUS10); |
| print_wrapper_reg(dev, reg, CAST_STATUS11); |
| print_wrapper_reg(dev, reg, CAST_STATUS12); |
| print_wrapper_reg(dev, reg, CAST_STATUS13); |
| if (mode == MXC_JPEG_DECODE) |
| return; |
| print_wrapper_reg(dev, reg, CAST_STATUS14); |
| print_wrapper_reg(dev, reg, CAST_STATUS15); |
| print_wrapper_reg(dev, reg, CAST_STATUS16); |
| print_wrapper_reg(dev, reg, CAST_STATUS17); |
| print_wrapper_reg(dev, reg, CAST_STATUS18); |
| print_wrapper_reg(dev, reg, CAST_STATUS19); |
| } |
| |
| void print_wrapper_info(struct device *dev, void __iomem *reg) |
| { |
| dev_dbg(dev, "Wrapper regs:\n"); |
| print_wrapper_reg(dev, reg, GLB_CTRL); |
| print_wrapper_reg(dev, reg, COM_STATUS); |
| print_wrapper_reg(dev, reg, BUF_BASE0); |
| print_wrapper_reg(dev, reg, BUF_BASE1); |
| print_wrapper_reg(dev, reg, LINE_PITCH); |
| print_wrapper_reg(dev, reg, STM_BUFBASE); |
| print_wrapper_reg(dev, reg, STM_BUFSIZE); |
| print_wrapper_reg(dev, reg, IMGSIZE); |
| print_wrapper_reg(dev, reg, STM_CTRL); |
| } |
| |
| void mxc_jpeg_enable_irq(void __iomem *reg, int slot) |
| { |
| writel(0xFFFFFFFF, reg + MXC_SLOT_OFFSET(slot, SLOT_IRQ_EN)); |
| } |
| |
| void mxc_jpeg_sw_reset(void __iomem *reg) |
| { |
| /* |
| * engine soft reset, internal state machine reset |
| * this will not reset registers, however, it seems |
| * the registers may remain inconsistent with the internal state |
| * so, on purpose, at least let GLB_CTRL bits clear after this reset |
| */ |
| writel(GLB_CTRL_SFT_RST, reg + GLB_CTRL); |
| } |
| |
| void mxc_jpeg_enc_mode_conf(struct device *dev, void __iomem *reg) |
| { |
| dev_dbg(dev, "CAST Encoder CONFIG...\n"); |
| /* |
| * "Config_Mode" enabled, "Config_Mode auto clear enabled", |
| */ |
| writel(0xa0, reg + CAST_MODE); |
| |
| /* all markers and segments */ |
| writel(0x3ff, reg + CAST_CFG_MODE); |
| |
| /* quality factor */ |
| writel(0x4b, reg + CAST_QUALITY); |
| } |
| |
| void mxc_jpeg_enc_mode_go(struct device *dev, void __iomem *reg) |
| { |
| dev_dbg(dev, "CAST Encoder GO...\n"); |
| /* |
| * "GO" enabled, "GO bit auto clear" enabled |
| */ |
| writel(0x140, reg + CAST_MODE); |
| } |
| |
| void mxc_jpeg_dec_mode_go(struct device *dev, void __iomem *reg) |
| { |
| dev_dbg(dev, "CAST Decoder GO...\n"); |
| writel(MXC_DEC_EXIT_IDLE_MODE, reg + CAST_CTRL); |
| } |
| |
| int mxc_jpeg_enable(void __iomem *reg) |
| { |
| u32 regval; |
| |
| writel(GLB_CTRL_JPG_EN, reg + GLB_CTRL); |
| regval = readl(reg); |
| return regval; |
| } |
| |
| void mxc_jpeg_enable_slot(void __iomem *reg, int slot) |
| { |
| u32 regval; |
| |
| regval = readl(reg + GLB_CTRL); |
| writel(GLB_CTRL_SLOT_EN(slot) | regval, reg + GLB_CTRL); |
| } |
| |
| void mxc_jpeg_set_l_endian(void __iomem *reg, int le) |
| { |
| u32 regval; |
| |
| regval = readl(reg + GLB_CTRL); |
| regval &= ~GLB_CTRL_L_ENDIAN(1); /* clear */ |
| writel(GLB_CTRL_L_ENDIAN(le) | regval, reg + GLB_CTRL); /* set */ |
| } |
| |
| void mxc_jpeg_set_bufsize(struct mxc_jpeg_desc *desc, u32 bufsize) |
| { |
| desc->stm_bufsize = bufsize; |
| } |
| |
| void mxc_jpeg_set_res(struct mxc_jpeg_desc *desc, u16 w, u16 h) |
| { |
| desc->imgsize = w << 16 | h; |
| } |
| |
| void mxc_jpeg_set_line_pitch(struct mxc_jpeg_desc *desc, u32 line_pitch) |
| { |
| desc->line_pitch = line_pitch; |
| } |
| |
| void mxc_jpeg_set_desc(u32 desc, void __iomem *reg, int slot) |
| { |
| writel(desc | MXC_NXT_DESCPT_EN, |
| reg + MXC_SLOT_OFFSET(slot, SLOT_NXT_DESCPT_PTR)); |
| } |