| /* SPDX-License-Identifier: GPL-2.0 or MIT */ | |
| /* | |
| * Copyright (c) 2024 Intel | |
| * Copyright (c) 2024 Red Hat | |
| */ | |
| #ifndef __DRM_PANIC_H__ | |
| #define __DRM_PANIC_H__ | |
| #include <linux/module.h> | |
| #include <linux/types.h> | |
| #include <linux/iosys-map.h> | |
| #include <drm/drm_device.h> | |
| #include <drm/drm_fourcc.h> | |
| /** | |
| * struct drm_scanout_buffer - DRM scanout buffer | |
| * | |
| * This structure holds the information necessary for drm_panic to draw the | |
| * panic screen, and display it. | |
| */ | |
| struct drm_scanout_buffer { | |
| /** | |
| * @format: | |
| * | |
| * drm format of the scanout buffer. | |
| */ | |
| const struct drm_format_info *format; | |
| /** | |
| * @map: | |
| * | |
| * Virtual address of the scanout buffer, either in memory or iomem. | |
| * The scanout buffer should be in linear format, and can be directly | |
| * sent to the display hardware. Tearing is not an issue for the panic | |
| * screen. | |
| */ | |
| struct iosys_map map[DRM_FORMAT_MAX_PLANES]; | |
| /** | |
| * @pages: Optional, if the scanout buffer is not mapped, set this field | |
| * to the array of pages of the scanout buffer. The panic code will use | |
| * kmap_local_page_try_from_panic() to map one page at a time to write | |
| * all the pixels. This array shouldn't be allocated from the | |
| * get_scanoutbuffer() callback. | |
| * The scanout buffer should be in linear format. | |
| */ | |
| struct page **pages; | |
| /** | |
| * @width: Width of the scanout buffer, in pixels. | |
| */ | |
| unsigned int width; | |
| /** | |
| * @height: Height of the scanout buffer, in pixels. | |
| */ | |
| unsigned int height; | |
| /** | |
| * @pitch: Length in bytes between the start of two consecutive lines. | |
| */ | |
| unsigned int pitch[DRM_FORMAT_MAX_PLANES]; | |
| /** | |
| * @set_pixel: Optional function, to set a pixel color on the | |
| * framebuffer. It allows to handle special tiling format inside the | |
| * driver. It takes precedence over the @map and @pages fields. | |
| */ | |
| void (*set_pixel)(struct drm_scanout_buffer *sb, unsigned int x, | |
| unsigned int y, u32 color); | |
| /** | |
| * @private: private pointer that you can use in the callbacks | |
| * set_pixel() | |
| */ | |
| void *private; | |
| }; | |
| #ifdef CONFIG_DRM_PANIC | |
| /** | |
| * drm_panic_trylock - try to enter the panic printing critical section | |
| * @dev: struct drm_device | |
| * @flags: unsigned long irq flags you need to pass to the unlock() counterpart | |
| * | |
| * This function must be called by any panic printing code. The panic printing | |
| * attempt must be aborted if the trylock fails. | |
| * | |
| * Panic printing code can make the following assumptions while holding the | |
| * panic lock: | |
| * | |
| * - Anything protected by drm_panic_lock() and drm_panic_unlock() pairs is safe | |
| * to access. | |
| * | |
| * - Furthermore the panic printing code only registers in drm_dev_unregister() | |
| * and gets removed in drm_dev_unregister(). This allows the panic code to | |
| * safely access any state which is invariant in between these two function | |
| * calls, like the list of planes &drm_mode_config.plane_list or most of the | |
| * struct drm_plane structure. | |
| * | |
| * Specifically thanks to the protection around plane updates in | |
| * drm_atomic_helper_swap_state() the following additional guarantees hold: | |
| * | |
| * - It is safe to deference the drm_plane.state pointer. | |
| * | |
| * - Anything in struct drm_plane_state or the driver's subclass thereof which | |
| * stays invariant after the atomic check code has finished is safe to access. | |
| * Specifically this includes the reference counted pointers to framebuffer | |
| * and buffer objects. | |
| * | |
| * - Anything set up by &drm_plane_helper_funcs.fb_prepare and cleaned up | |
| * &drm_plane_helper_funcs.fb_cleanup is safe to access, as long as it stays | |
| * invariant between these two calls. This also means that for drivers using | |
| * dynamic buffer management the framebuffer is pinned, and therefer all | |
| * relevant datastructures can be accessed without taking any further locks | |
| * (which would be impossible in panic context anyway). | |
| * | |
| * - Importantly, software and hardware state set up by | |
| * &drm_plane_helper_funcs.begin_fb_access and | |
| * &drm_plane_helper_funcs.end_fb_access is not safe to access. | |
| * | |
| * Drivers must not make any assumptions about the actual state of the hardware, | |
| * unless they explicitly protected these hardware access with drm_panic_lock() | |
| * and drm_panic_unlock(). | |
| * | |
| * Return: | |
| * %0 when failing to acquire the raw spinlock, nonzero on success. | |
| */ | |
| #define drm_panic_trylock(dev, flags) \ | |
| raw_spin_trylock_irqsave(&(dev)->mode_config.panic_lock, flags) | |
| /** | |
| * drm_panic_lock - protect panic printing relevant state | |
| * @dev: struct drm_device | |
| * @flags: unsigned long irq flags you need to pass to the unlock() counterpart | |
| * | |
| * This function must be called to protect software and hardware state that the | |
| * panic printing code must be able to rely on. The protected sections must be | |
| * as small as possible. It uses the irqsave/irqrestore variant, and can be | |
| * called from irq handler. Examples include: | |
| * | |
| * - Access to peek/poke or other similar registers, if that is the way the | |
| * driver prints the pixels into the scanout buffer at panic time. | |
| * | |
| * - Updates to pointers like &drm_plane.state, allowing the panic handler to | |
| * safely deference these. This is done in drm_atomic_helper_swap_state(). | |
| * | |
| * - An state that isn't invariant and that the driver must be able to access | |
| * during panic printing. | |
| */ | |
| #define drm_panic_lock(dev, flags) \ | |
| raw_spin_lock_irqsave(&(dev)->mode_config.panic_lock, flags) | |
| /** | |
| * drm_panic_unlock - end of the panic printing critical section | |
| * @dev: struct drm_device | |
| * @flags: irq flags that were returned when acquiring the lock | |
| * | |
| * Unlocks the raw spinlock acquired by either drm_panic_lock() or | |
| * drm_panic_trylock(). | |
| */ | |
| #define drm_panic_unlock(dev, flags) \ | |
| raw_spin_unlock_irqrestore(&(dev)->mode_config.panic_lock, flags) | |
| #else | |
| static inline bool drm_panic_trylock(struct drm_device *dev, unsigned long flags) | |
| { | |
| return true; | |
| } | |
| static inline void drm_panic_lock(struct drm_device *dev, unsigned long flags) {} | |
| static inline void drm_panic_unlock(struct drm_device *dev, unsigned long flags) {} | |
| #endif | |
| #if defined(CONFIG_DRM_PANIC_SCREEN_QR_CODE) | |
| size_t drm_panic_qr_max_data_size(u8 version, size_t url_len); | |
| u8 drm_panic_qr_generate(const char *url, u8 *data, size_t data_len, size_t data_size, | |
| u8 *tmp, size_t tmp_size); | |
| #endif | |
| #endif /* __DRM_PANIC_H__ */ |