| // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause) |
| /* |
| * Copyright (C) STMicroelectronics 2017 - All Rights Reserved |
| * Author: Ludovic Barre <ludovic.barre@st.com> for STMicroelectronics. |
| */ |
| #include <dt-bindings/pinctrl/stm32-pinfunc.h> |
| |
| / { |
| soc { |
| pinctrl: pin-controller { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| compatible = "st,stm32mp157-pinctrl"; |
| ranges = <0 0x50002000 0xa400>; |
| interrupt-parent = <&exti>; |
| st,syscfg = <&exti 0x60 0xff>; |
| pins-are-numbered; |
| |
| gpioa: gpio@50002000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x0 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOA"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 0 16>; |
| }; |
| |
| gpiob: gpio@50003000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x1000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOB"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 16 16>; |
| }; |
| |
| gpioc: gpio@50004000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x2000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOC"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 32 16>; |
| }; |
| |
| gpiod: gpio@50005000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x3000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOD"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 48 16>; |
| }; |
| |
| gpioe: gpio@50006000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x4000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOE"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 64 16>; |
| }; |
| |
| gpiof: gpio@50007000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x5000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOF"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 80 16>; |
| }; |
| |
| gpiog: gpio@50008000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x6000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOG"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 96 16>; |
| }; |
| |
| gpioh: gpio@50009000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x7000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOH"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 112 16>; |
| }; |
| |
| gpioi: gpio@5000a000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x8000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOI"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 128 16>; |
| }; |
| |
| gpioj: gpio@5000b000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0x9000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOJ"; |
| ngpios = <16>; |
| gpio-ranges = <&pinctrl 0 144 16>; |
| }; |
| |
| gpiok: gpio@5000c000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0xa000 0x400>; |
| clocks = <&clk_pll3_p>; |
| st,bank-name = "GPIOK"; |
| ngpios = <8>; |
| gpio-ranges = <&pinctrl 0 160 8>; |
| }; |
| |
| uart4_pins_a: uart4@0 { |
| pins1 { |
| pinmux = <STM32_PINMUX('G', 11, AF6)>; /* UART4_TX */ |
| bias-disable; |
| drive-push-pull; |
| slew-rate = <0>; |
| }; |
| pins2 { |
| pinmux = <STM32_PINMUX('B', 2, AF8)>; /* UART4_RX */ |
| bias-disable; |
| }; |
| }; |
| }; |
| |
| pinctrl_z: pin-controller-z { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| compatible = "st,stm32mp157-z-pinctrl"; |
| ranges = <0 0x54004000 0x400>; |
| pins-are-numbered; |
| interrupt-parent = <&exti>; |
| st,syscfg = <&exti 0x60 0xff>; |
| status = "disabled"; |
| |
| gpioz: gpio@54004000 { |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| reg = <0 0x400>; |
| clocks = <&clk_pll2_p>; |
| st,bank-name = "GPIOZ"; |
| st,bank-ioport = <11>; |
| ngpios = <8>; |
| gpio-ranges = <&pinctrl_z 0 400 8>; |
| }; |
| }; |
| }; |
| }; |