| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * Copyright (C) 2015 Red Hat |
| * Copyright (C) 2015 Sony Mobile Communications Inc. |
| * Author: Werner Johansson <werner.johansson@sonymobile.com> |
| * |
| * Based on AUO panel driver by Rob Clark <robdclark@gmail.com> |
| */ |
| |
| #include <linux/delay.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/module.h> |
| #include <linux/of.h> |
| #include <linux/regulator/consumer.h> |
| |
| #include <video/mipi_display.h> |
| |
| #include <drm/drm_crtc.h> |
| #include <drm/drm_device.h> |
| #include <drm/drm_mipi_dsi.h> |
| #include <drm/drm_panel.h> |
| |
| struct sharp_nt_panel { |
| struct drm_panel base; |
| struct mipi_dsi_device *dsi; |
| |
| struct regulator *supply; |
| struct gpio_desc *reset_gpio; |
| |
| bool prepared; |
| }; |
| |
| static inline struct sharp_nt_panel *to_sharp_nt_panel(struct drm_panel *panel) |
| { |
| return container_of(panel, struct sharp_nt_panel, base); |
| } |
| |
| static int sharp_nt_panel_init(struct sharp_nt_panel *sharp_nt) |
| { |
| struct mipi_dsi_device *dsi = sharp_nt->dsi; |
| int ret; |
| |
| dsi->mode_flags |= MIPI_DSI_MODE_LPM; |
| |
| ret = mipi_dsi_dcs_exit_sleep_mode(dsi); |
| if (ret < 0) |
| return ret; |
| |
| msleep(120); |
| |
| /* Novatek two-lane operation */ |
| ret = mipi_dsi_dcs_write(dsi, 0xae, (u8[]){ 0x03 }, 1); |
| if (ret < 0) |
| return ret; |
| |
| /* Set both MCU and RGB I/F to 24bpp */ |
| ret = mipi_dsi_dcs_set_pixel_format(dsi, MIPI_DCS_PIXEL_FMT_24BIT | |
| (MIPI_DCS_PIXEL_FMT_24BIT << 4)); |
| if (ret < 0) |
| return ret; |
| |
| return 0; |
| } |
| |
| static int sharp_nt_panel_on(struct sharp_nt_panel *sharp_nt) |
| { |
| struct mipi_dsi_device *dsi = sharp_nt->dsi; |
| int ret; |
| |
| dsi->mode_flags |= MIPI_DSI_MODE_LPM; |
| |
| ret = mipi_dsi_dcs_set_display_on(dsi); |
| if (ret < 0) |
| return ret; |
| |
| return 0; |
| } |
| |
| static int sharp_nt_panel_off(struct sharp_nt_panel *sharp_nt) |
| { |
| struct mipi_dsi_device *dsi = sharp_nt->dsi; |
| int ret; |
| |
| dsi->mode_flags &= ~MIPI_DSI_MODE_LPM; |
| |
| ret = mipi_dsi_dcs_set_display_off(dsi); |
| if (ret < 0) |
| return ret; |
| |
| ret = mipi_dsi_dcs_enter_sleep_mode(dsi); |
| if (ret < 0) |
| return ret; |
| |
| return 0; |
| } |
| |
| static int sharp_nt_panel_unprepare(struct drm_panel *panel) |
| { |
| struct sharp_nt_panel *sharp_nt = to_sharp_nt_panel(panel); |
| int ret; |
| |
| if (!sharp_nt->prepared) |
| return 0; |
| |
| ret = sharp_nt_panel_off(sharp_nt); |
| if (ret < 0) { |
| dev_err(panel->dev, "failed to set panel off: %d\n", ret); |
| return ret; |
| } |
| |
| regulator_disable(sharp_nt->supply); |
| if (sharp_nt->reset_gpio) |
| gpiod_set_value(sharp_nt->reset_gpio, 0); |
| |
| sharp_nt->prepared = false; |
| |
| return 0; |
| } |
| |
| static int sharp_nt_panel_prepare(struct drm_panel *panel) |
| { |
| struct sharp_nt_panel *sharp_nt = to_sharp_nt_panel(panel); |
| int ret; |
| |
| if (sharp_nt->prepared) |
| return 0; |
| |
| ret = regulator_enable(sharp_nt->supply); |
| if (ret < 0) |
| return ret; |
| |
| msleep(20); |
| |
| if (sharp_nt->reset_gpio) { |
| gpiod_set_value(sharp_nt->reset_gpio, 1); |
| msleep(1); |
| gpiod_set_value(sharp_nt->reset_gpio, 0); |
| msleep(1); |
| gpiod_set_value(sharp_nt->reset_gpio, 1); |
| msleep(10); |
| } |
| |
| ret = sharp_nt_panel_init(sharp_nt); |
| if (ret < 0) { |
| dev_err(panel->dev, "failed to init panel: %d\n", ret); |
| goto poweroff; |
| } |
| |
| ret = sharp_nt_panel_on(sharp_nt); |
| if (ret < 0) { |
| dev_err(panel->dev, "failed to set panel on: %d\n", ret); |
| goto poweroff; |
| } |
| |
| sharp_nt->prepared = true; |
| |
| return 0; |
| |
| poweroff: |
| regulator_disable(sharp_nt->supply); |
| if (sharp_nt->reset_gpio) |
| gpiod_set_value(sharp_nt->reset_gpio, 0); |
| return ret; |
| } |
| |
| static const struct drm_display_mode default_mode = { |
| .clock = (540 + 48 + 32 + 80) * (960 + 3 + 10 + 15) * 60 / 1000, |
| .hdisplay = 540, |
| .hsync_start = 540 + 48, |
| .hsync_end = 540 + 48 + 32, |
| .htotal = 540 + 48 + 32 + 80, |
| .vdisplay = 960, |
| .vsync_start = 960 + 3, |
| .vsync_end = 960 + 3 + 10, |
| .vtotal = 960 + 3 + 10 + 15, |
| }; |
| |
| static int sharp_nt_panel_get_modes(struct drm_panel *panel, |
| struct drm_connector *connector) |
| { |
| struct drm_display_mode *mode; |
| |
| mode = drm_mode_duplicate(connector->dev, &default_mode); |
| if (!mode) { |
| dev_err(panel->dev, "failed to add mode %ux%u@%u\n", |
| default_mode.hdisplay, default_mode.vdisplay, |
| drm_mode_vrefresh(&default_mode)); |
| return -ENOMEM; |
| } |
| |
| drm_mode_set_name(mode); |
| |
| drm_mode_probed_add(connector, mode); |
| |
| connector->display_info.width_mm = 54; |
| connector->display_info.height_mm = 95; |
| |
| return 1; |
| } |
| |
| static const struct drm_panel_funcs sharp_nt_panel_funcs = { |
| .unprepare = sharp_nt_panel_unprepare, |
| .prepare = sharp_nt_panel_prepare, |
| .get_modes = sharp_nt_panel_get_modes, |
| }; |
| |
| static int sharp_nt_panel_add(struct sharp_nt_panel *sharp_nt) |
| { |
| struct device *dev = &sharp_nt->dsi->dev; |
| int ret; |
| |
| sharp_nt->supply = devm_regulator_get(dev, "avdd"); |
| if (IS_ERR(sharp_nt->supply)) |
| return PTR_ERR(sharp_nt->supply); |
| |
| sharp_nt->reset_gpio = devm_gpiod_get(dev, "reset", GPIOD_OUT_LOW); |
| if (IS_ERR(sharp_nt->reset_gpio)) { |
| dev_err(dev, "cannot get reset-gpios %ld\n", |
| PTR_ERR(sharp_nt->reset_gpio)); |
| sharp_nt->reset_gpio = NULL; |
| } else { |
| gpiod_set_value(sharp_nt->reset_gpio, 0); |
| } |
| |
| drm_panel_init(&sharp_nt->base, &sharp_nt->dsi->dev, |
| &sharp_nt_panel_funcs, DRM_MODE_CONNECTOR_DSI); |
| |
| ret = drm_panel_of_backlight(&sharp_nt->base); |
| if (ret) |
| return ret; |
| |
| drm_panel_add(&sharp_nt->base); |
| |
| return 0; |
| } |
| |
| static void sharp_nt_panel_del(struct sharp_nt_panel *sharp_nt) |
| { |
| if (sharp_nt->base.dev) |
| drm_panel_remove(&sharp_nt->base); |
| } |
| |
| static int sharp_nt_panel_probe(struct mipi_dsi_device *dsi) |
| { |
| struct sharp_nt_panel *sharp_nt; |
| int ret; |
| |
| dsi->lanes = 2; |
| dsi->format = MIPI_DSI_FMT_RGB888; |
| dsi->mode_flags = MIPI_DSI_MODE_VIDEO | |
| MIPI_DSI_MODE_VIDEO_SYNC_PULSE | |
| MIPI_DSI_MODE_VIDEO_HSE | |
| MIPI_DSI_CLOCK_NON_CONTINUOUS | |
| MIPI_DSI_MODE_NO_EOT_PACKET; |
| |
| sharp_nt = devm_kzalloc(&dsi->dev, sizeof(*sharp_nt), GFP_KERNEL); |
| if (!sharp_nt) |
| return -ENOMEM; |
| |
| mipi_dsi_set_drvdata(dsi, sharp_nt); |
| |
| sharp_nt->dsi = dsi; |
| |
| ret = sharp_nt_panel_add(sharp_nt); |
| if (ret < 0) |
| return ret; |
| |
| ret = mipi_dsi_attach(dsi); |
| if (ret < 0) { |
| sharp_nt_panel_del(sharp_nt); |
| return ret; |
| } |
| |
| return 0; |
| } |
| |
| static void sharp_nt_panel_remove(struct mipi_dsi_device *dsi) |
| { |
| struct sharp_nt_panel *sharp_nt = mipi_dsi_get_drvdata(dsi); |
| int ret; |
| |
| ret = drm_panel_disable(&sharp_nt->base); |
| if (ret < 0) |
| dev_err(&dsi->dev, "failed to disable panel: %d\n", ret); |
| |
| ret = mipi_dsi_detach(dsi); |
| if (ret < 0) |
| dev_err(&dsi->dev, "failed to detach from DSI host: %d\n", ret); |
| |
| sharp_nt_panel_del(sharp_nt); |
| } |
| |
| static void sharp_nt_panel_shutdown(struct mipi_dsi_device *dsi) |
| { |
| struct sharp_nt_panel *sharp_nt = mipi_dsi_get_drvdata(dsi); |
| |
| drm_panel_disable(&sharp_nt->base); |
| } |
| |
| static const struct of_device_id sharp_nt_of_match[] = { |
| { .compatible = "sharp,ls043t1le01-qhd", }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(of, sharp_nt_of_match); |
| |
| static struct mipi_dsi_driver sharp_nt_panel_driver = { |
| .driver = { |
| .name = "panel-sharp-ls043t1le01-qhd", |
| .of_match_table = sharp_nt_of_match, |
| }, |
| .probe = sharp_nt_panel_probe, |
| .remove = sharp_nt_panel_remove, |
| .shutdown = sharp_nt_panel_shutdown, |
| }; |
| module_mipi_dsi_driver(sharp_nt_panel_driver); |
| |
| MODULE_AUTHOR("Werner Johansson <werner.johansson@sonymobile.com>"); |
| MODULE_DESCRIPTION("Sharp LS043T1LE01 NT35565-based qHD (540x960) video mode panel driver"); |
| MODULE_LICENSE("GPL v2"); |