| /* SPDX-License-Identifier: GPL-2.0-only */ |
| /* |
| * Copyright (C) 2012 Texas Instruments |
| * Author: Rob Clark <robdclark@gmail.com> |
| */ |
| |
| #ifndef __TILCDC_DRV_H__ |
| #define __TILCDC_DRV_H__ |
| |
| #include <linux/cpufreq.h> |
| #include <linux/irqreturn.h> |
| |
| #include <drm/drm_print.h> |
| |
| struct clk; |
| struct workqueue_struct; |
| |
| struct drm_connector; |
| struct drm_connector_helper_funcs; |
| struct drm_crtc; |
| struct drm_device; |
| struct drm_display_mode; |
| struct drm_encoder; |
| struct drm_framebuffer; |
| struct drm_minor; |
| struct drm_pending_vblank_event; |
| struct drm_plane; |
| |
| /* Defaulting to pixel clock defined on AM335x */ |
| #define TILCDC_DEFAULT_MAX_PIXELCLOCK 126000 |
| /* Defaulting to max width as defined on AM335x */ |
| #define TILCDC_DEFAULT_MAX_WIDTH 2048 |
| /* |
| * This may need some tweaking, but want to allow at least 1280x1024@60 |
| * with optimized DDR & EMIF settings tweaked 1920x1080@24 appears to |
| * be supportable |
| */ |
| #define TILCDC_DEFAULT_MAX_BANDWIDTH (1280*1024*60) |
| |
| |
| struct tilcdc_drm_private { |
| void __iomem *mmio; |
| |
| struct clk *clk; /* functional clock */ |
| int rev; /* IP revision */ |
| |
| /* don't attempt resolutions w/ higher W * H * Hz: */ |
| uint32_t max_bandwidth; |
| /* |
| * Pixel Clock will be restricted to some value as |
| * defined in the device datasheet measured in KHz |
| */ |
| uint32_t max_pixelclock; |
| /* |
| * Max allowable width is limited on a per device basis |
| * measured in pixels |
| */ |
| uint32_t max_width; |
| |
| /* Supported pixel formats */ |
| const uint32_t *pixelformats; |
| uint32_t num_pixelformats; |
| |
| #ifdef CONFIG_CPU_FREQ |
| struct notifier_block freq_transition; |
| #endif |
| |
| struct workqueue_struct *wq; |
| |
| struct drm_crtc *crtc; |
| |
| unsigned int num_encoders; |
| struct drm_encoder *encoders[8]; |
| |
| unsigned int num_connectors; |
| struct drm_connector *connectors[8]; |
| |
| struct drm_encoder *external_encoder; |
| struct drm_connector *external_connector; |
| |
| bool is_registered; |
| bool is_componentized; |
| }; |
| |
| /* Sub-module for display. Since we don't know at compile time what panels |
| * or display adapter(s) might be present (for ex, off chip dvi/tfp410, |
| * hdmi encoder, various lcd panels), the connector/encoder(s) are split into |
| * separate drivers. If they are probed and found to be present, they |
| * register themselves with tilcdc_register_module(). |
| */ |
| struct tilcdc_module; |
| |
| struct tilcdc_module_ops { |
| /* create appropriate encoders/connectors: */ |
| int (*modeset_init)(struct tilcdc_module *mod, struct drm_device *dev); |
| #ifdef CONFIG_DEBUG_FS |
| /* create debugfs nodes (can be NULL): */ |
| int (*debugfs_init)(struct tilcdc_module *mod, struct drm_minor *minor); |
| #endif |
| }; |
| |
| struct tilcdc_module { |
| const char *name; |
| struct list_head list; |
| const struct tilcdc_module_ops *funcs; |
| }; |
| |
| void tilcdc_module_init(struct tilcdc_module *mod, const char *name, |
| const struct tilcdc_module_ops *funcs); |
| void tilcdc_module_cleanup(struct tilcdc_module *mod); |
| |
| /* Panel config that needs to be set in the crtc, but is not coming from |
| * the mode timings. The display module is expected to call |
| * tilcdc_crtc_set_panel_info() to set this during modeset. |
| */ |
| struct tilcdc_panel_info { |
| |
| /* AC Bias Pin Frequency */ |
| uint32_t ac_bias; |
| |
| /* AC Bias Pin Transitions per Interrupt */ |
| uint32_t ac_bias_intrpt; |
| |
| /* DMA burst size */ |
| uint32_t dma_burst_sz; |
| |
| /* Bits per pixel */ |
| uint32_t bpp; |
| |
| /* FIFO DMA Request Delay */ |
| uint32_t fdd; |
| |
| /* TFT Alternative Signal Mapping (Only for active) */ |
| bool tft_alt_mode; |
| |
| /* Invert pixel clock */ |
| bool invert_pxl_clk; |
| |
| /* Horizontal and Vertical Sync Edge: 0=rising 1=falling */ |
| uint32_t sync_edge; |
| |
| /* Horizontal and Vertical Sync: Control: 0=ignore */ |
| uint32_t sync_ctrl; |
| |
| /* Raster Data Order Select: 1=Most-to-least 0=Least-to-most */ |
| uint32_t raster_order; |
| |
| /* DMA FIFO threshold */ |
| uint32_t fifo_th; |
| }; |
| |
| #define DBG(fmt, ...) DRM_DEBUG(fmt"\n", ##__VA_ARGS__) |
| |
| int tilcdc_crtc_create(struct drm_device *dev); |
| irqreturn_t tilcdc_crtc_irq(struct drm_crtc *crtc); |
| void tilcdc_crtc_update_clk(struct drm_crtc *crtc); |
| void tilcdc_crtc_set_panel_info(struct drm_crtc *crtc, |
| const struct tilcdc_panel_info *info); |
| void tilcdc_crtc_set_simulate_vesa_sync(struct drm_crtc *crtc, |
| bool simulate_vesa_sync); |
| int tilcdc_crtc_max_width(struct drm_crtc *crtc); |
| void tilcdc_crtc_shutdown(struct drm_crtc *crtc); |
| int tilcdc_crtc_update_fb(struct drm_crtc *crtc, |
| struct drm_framebuffer *fb, |
| struct drm_pending_vblank_event *event); |
| |
| int tilcdc_plane_init(struct drm_device *dev, struct drm_plane *plane); |
| |
| #endif /* __TILCDC_DRV_H__ */ |