| /* | 
 |  * Copyright (C) 2004 Anton Blanchard <anton@au.ibm.com>, IBM | 
 |  * | 
 |  * This program is free software; you can redistribute it and/or | 
 |  * modify it under the terms of the GNU General Public License | 
 |  * as published by the Free Software Foundation; either version | 
 |  * 2 of the License, or (at your option) any later version. | 
 |  */ | 
 |  | 
 | #include <linux/oprofile.h> | 
 | #include <linux/init.h> | 
 | #include <linux/smp.h> | 
 | #include <asm/ptrace.h> | 
 | #include <asm/system.h> | 
 | #include <asm/processor.h> | 
 | #include <asm/cputable.h> | 
 | #include <asm/oprofile_impl.h> | 
 |  | 
 | #define dbg(args...) | 
 |  | 
 | static void ctrl_write(unsigned int i, unsigned int val) | 
 | { | 
 | 	unsigned int tmp = 0; | 
 | 	unsigned long shift = 0, mask = 0; | 
 |  | 
 | 	dbg("ctrl_write %d %x\n", i, val); | 
 |  | 
 | 	switch(i) { | 
 | 	case 0: | 
 | 		tmp = mfspr(SPRN_MMCR0); | 
 | 		shift = 6; | 
 | 		mask = 0x7F; | 
 | 		break; | 
 | 	case 1: | 
 | 		tmp = mfspr(SPRN_MMCR0); | 
 | 		shift = 0; | 
 | 		mask = 0x3F; | 
 | 		break; | 
 | 	case 2: | 
 | 		tmp = mfspr(SPRN_MMCR1); | 
 | 		shift = 31 - 4; | 
 | 		mask = 0x1F; | 
 | 		break; | 
 | 	case 3: | 
 | 		tmp = mfspr(SPRN_MMCR1); | 
 | 		shift = 31 - 9; | 
 | 		mask = 0x1F; | 
 | 		break; | 
 | 	case 4: | 
 | 		tmp = mfspr(SPRN_MMCR1); | 
 | 		shift = 31 - 14; | 
 | 		mask = 0x1F; | 
 | 		break; | 
 | 	case 5: | 
 | 		tmp = mfspr(SPRN_MMCR1); | 
 | 		shift = 31 - 19; | 
 | 		mask = 0x1F; | 
 | 		break; | 
 | 	case 6: | 
 | 		tmp = mfspr(SPRN_MMCR1); | 
 | 		shift = 31 - 24; | 
 | 		mask = 0x1F; | 
 | 		break; | 
 | 	case 7: | 
 | 		tmp = mfspr(SPRN_MMCR1); | 
 | 		shift = 31 - 28; | 
 | 		mask = 0xF; | 
 | 		break; | 
 | 	} | 
 |  | 
 | 	tmp = tmp & ~(mask << shift); | 
 | 	tmp |= val << shift; | 
 |  | 
 | 	switch(i) { | 
 | 		case 0: | 
 | 		case 1: | 
 | 			mtspr(SPRN_MMCR0, tmp); | 
 | 			break; | 
 | 		default: | 
 | 			mtspr(SPRN_MMCR1, tmp); | 
 | 	} | 
 |  | 
 | 	dbg("ctrl_write mmcr0 %lx mmcr1 %lx\n", mfspr(SPRN_MMCR0), | 
 | 	       mfspr(SPRN_MMCR1)); | 
 | } | 
 |  | 
 | static unsigned long reset_value[OP_MAX_COUNTER]; | 
 |  | 
 | static int num_counters; | 
 |  | 
 | static void rs64_reg_setup(struct op_counter_config *ctr, | 
 | 			   struct op_system_config *sys, | 
 | 			   int num_ctrs) | 
 | { | 
 | 	int i; | 
 |  | 
 | 	num_counters = num_ctrs; | 
 |  | 
 | 	for (i = 0; i < num_counters; ++i) | 
 | 		reset_value[i] = 0x80000000UL - ctr[i].count; | 
 |  | 
 | 	/* XXX setup user and kernel profiling */ | 
 | } | 
 |  | 
 | static void rs64_cpu_setup(struct op_counter_config *ctr) | 
 | { | 
 | 	unsigned int mmcr0; | 
 |  | 
 | 	/* reset MMCR0 and set the freeze bit */ | 
 | 	mmcr0 = MMCR0_FC; | 
 | 	mtspr(SPRN_MMCR0, mmcr0); | 
 |  | 
 | 	/* reset MMCR1, MMCRA */ | 
 | 	mtspr(SPRN_MMCR1, 0); | 
 |  | 
 | 	if (cpu_has_feature(CPU_FTR_MMCRA)) | 
 | 		mtspr(SPRN_MMCRA, 0); | 
 |  | 
 | 	mmcr0 |= MMCR0_FCM1|MMCR0_PMXE|MMCR0_FCECE; | 
 | 	/* Only applies to POWER3, but should be safe on RS64 */ | 
 | 	mmcr0 |= MMCR0_PMC1CE|MMCR0_PMCjCE; | 
 | 	mtspr(SPRN_MMCR0, mmcr0); | 
 |  | 
 | 	dbg("setup on cpu %d, mmcr0 %lx\n", smp_processor_id(), | 
 | 	    mfspr(SPRN_MMCR0)); | 
 | 	dbg("setup on cpu %d, mmcr1 %lx\n", smp_processor_id(), | 
 | 	    mfspr(SPRN_MMCR1)); | 
 | } | 
 |  | 
 | static void rs64_start(struct op_counter_config *ctr) | 
 | { | 
 | 	int i; | 
 | 	unsigned int mmcr0; | 
 |  | 
 | 	/* set the PMM bit (see comment below) */ | 
 | 	mtmsrd(mfmsr() | MSR_PMM); | 
 |  | 
 | 	for (i = 0; i < num_counters; ++i) { | 
 | 		if (ctr[i].enabled) { | 
 | 			classic_ctr_write(i, reset_value[i]); | 
 | 			ctrl_write(i, ctr[i].event); | 
 | 		} else { | 
 | 			classic_ctr_write(i, 0); | 
 | 		} | 
 | 	} | 
 |  | 
 | 	mmcr0 = mfspr(SPRN_MMCR0); | 
 |  | 
 | 	/* | 
 | 	 * now clear the freeze bit, counting will not start until we | 
 | 	 * rfid from this excetion, because only at that point will | 
 | 	 * the PMM bit be cleared | 
 | 	 */ | 
 | 	mmcr0 &= ~MMCR0_FC; | 
 | 	mtspr(SPRN_MMCR0, mmcr0); | 
 |  | 
 | 	dbg("start on cpu %d, mmcr0 %x\n", smp_processor_id(), mmcr0); | 
 | } | 
 |  | 
 | static void rs64_stop(void) | 
 | { | 
 | 	unsigned int mmcr0; | 
 |  | 
 | 	/* freeze counters */ | 
 | 	mmcr0 = mfspr(SPRN_MMCR0); | 
 | 	mmcr0 |= MMCR0_FC; | 
 | 	mtspr(SPRN_MMCR0, mmcr0); | 
 |  | 
 | 	dbg("stop on cpu %d, mmcr0 %x\n", smp_processor_id(), mmcr0); | 
 |  | 
 | 	mb(); | 
 | } | 
 |  | 
 | static void rs64_handle_interrupt(struct pt_regs *regs, | 
 | 				  struct op_counter_config *ctr) | 
 | { | 
 | 	unsigned int mmcr0; | 
 | 	int is_kernel; | 
 | 	int val; | 
 | 	int i; | 
 | 	unsigned long pc = mfspr(SPRN_SIAR); | 
 |  | 
 | 	is_kernel = is_kernel_addr(pc); | 
 |  | 
 | 	/* set the PMM bit (see comment below) */ | 
 | 	mtmsrd(mfmsr() | MSR_PMM); | 
 |  | 
 | 	for (i = 0; i < num_counters; ++i) { | 
 | 		val = classic_ctr_read(i); | 
 | 		if (val < 0) { | 
 | 			if (ctr[i].enabled) { | 
 | 				oprofile_add_ext_sample(pc, regs, i, is_kernel); | 
 | 				classic_ctr_write(i, reset_value[i]); | 
 | 			} else { | 
 | 				classic_ctr_write(i, 0); | 
 | 			} | 
 | 		} | 
 | 	} | 
 |  | 
 | 	mmcr0 = mfspr(SPRN_MMCR0); | 
 |  | 
 | 	/* reset the perfmon trigger */ | 
 | 	mmcr0 |= MMCR0_PMXE; | 
 |  | 
 | 	/* | 
 | 	 * now clear the freeze bit, counting will not start until we | 
 | 	 * rfid from this exception, because only at that point will | 
 | 	 * the PMM bit be cleared | 
 | 	 */ | 
 | 	mmcr0 &= ~MMCR0_FC; | 
 | 	mtspr(SPRN_MMCR0, mmcr0); | 
 | } | 
 |  | 
 | struct op_powerpc_model op_model_rs64 = { | 
 | 	.reg_setup		= rs64_reg_setup, | 
 | 	.cpu_setup		= rs64_cpu_setup, | 
 | 	.start			= rs64_start, | 
 | 	.stop			= rs64_stop, | 
 | 	.handle_interrupt	= rs64_handle_interrupt, | 
 | }; |