| /* We need to carefully read the error status, ACK the errors, |
| * prevent recursive traps, and pass the information on to C |
| * code for logging. |
| * |
| * We pass the AFAR in as-is, and we encode the status |
| * information as described in asm-sparc64/sfafsr.h |
| */ |
| .type __spitfire_access_error,#function |
| __spitfire_access_error: |
| /* Disable ESTATE error reporting so that we do not take |
| * recursive traps and RED state the processor. |
| */ |
| stxa %g0, [%g0] ASI_ESTATE_ERROR_EN |
| membar #Sync |
| |
| mov UDBE_UE, %g1 |
| ldxa [%g0] ASI_AFSR, %g4 ! Get AFSR |
| |
| /* __spitfire_cee_trap branches here with AFSR in %g4 and |
| * UDBE_CE in %g1. It only clears ESTATE_ERR_CE in the ESTATE |
| * Error Enable register. |
| */ |
| __spitfire_cee_trap_continue: |
| ldxa [%g0] ASI_AFAR, %g5 ! Get AFAR |
| |
| rdpr %tt, %g3 |
| and %g3, 0x1ff, %g3 ! Paranoia |
| sllx %g3, SFSTAT_TRAP_TYPE_SHIFT, %g3 |
| or %g4, %g3, %g4 |
| rdpr %tl, %g3 |
| cmp %g3, 1 |
| mov 1, %g3 |
| bleu %xcc, 1f |
| sllx %g3, SFSTAT_TL_GT_ONE_SHIFT, %g3 |
| |
| or %g4, %g3, %g4 |
| |
| /* Read in the UDB error register state, clearing the sticky |
| * error bits as-needed. We only clear them if the UE bit is |
| * set. Likewise, __spitfire_cee_trap below will only do so |
| * if the CE bit is set. |
| * |
| * NOTE: UltraSparc-I/II have high and low UDB error |
| * registers, corresponding to the two UDB units |
| * present on those chips. UltraSparc-IIi only |
| * has a single UDB, called "SDB" in the manual. |
| * For IIi the upper UDB register always reads |
| * as zero so for our purposes things will just |
| * work with the checks below. |
| */ |
| 1: ldxa [%g0] ASI_UDBH_ERROR_R, %g3 |
| and %g3, 0x3ff, %g7 ! Paranoia |
| sllx %g7, SFSTAT_UDBH_SHIFT, %g7 |
| or %g4, %g7, %g4 |
| andcc %g3, %g1, %g3 ! UDBE_UE or UDBE_CE |
| be,pn %xcc, 1f |
| nop |
| stxa %g3, [%g0] ASI_UDB_ERROR_W |
| membar #Sync |
| |
| 1: mov 0x18, %g3 |
| ldxa [%g3] ASI_UDBL_ERROR_R, %g3 |
| and %g3, 0x3ff, %g7 ! Paranoia |
| sllx %g7, SFSTAT_UDBL_SHIFT, %g7 |
| or %g4, %g7, %g4 |
| andcc %g3, %g1, %g3 ! UDBE_UE or UDBE_CE |
| be,pn %xcc, 1f |
| nop |
| mov 0x18, %g7 |
| stxa %g3, [%g7] ASI_UDB_ERROR_W |
| membar #Sync |
| |
| 1: /* Ok, now that we've latched the error state, clear the |
| * sticky bits in the AFSR. |
| */ |
| stxa %g4, [%g0] ASI_AFSR |
| membar #Sync |
| |
| rdpr %tl, %g2 |
| cmp %g2, 1 |
| rdpr %pil, %g2 |
| bleu,pt %xcc, 1f |
| wrpr %g0, 15, %pil |
| |
| ba,pt %xcc, etraptl1 |
| rd %pc, %g7 |
| |
| ba,pt %xcc, 2f |
| nop |
| |
| 1: ba,pt %xcc, etrap_irq |
| rd %pc, %g7 |
| |
| 2: |
| #ifdef CONFIG_TRACE_IRQFLAGS |
| call trace_hardirqs_off |
| nop |
| #endif |
| mov %l4, %o1 |
| mov %l5, %o2 |
| call spitfire_access_error |
| add %sp, PTREGS_OFF, %o0 |
| ba,pt %xcc, rtrap |
| nop |
| .size __spitfire_access_error,.-__spitfire_access_error |
| |
| /* This is the trap handler entry point for ECC correctable |
| * errors. They are corrected, but we listen for the trap so |
| * that the event can be logged. |
| * |
| * Disrupting errors are either: |
| * 1) single-bit ECC errors during UDB reads to system |
| * memory |
| * 2) data parity errors during write-back events |
| * |
| * As far as I can make out from the manual, the CEE trap is |
| * only for correctable errors during memory read accesses by |
| * the front-end of the processor. |
| * |
| * The code below is only for trap level 1 CEE events, as it |
| * is the only situation where we can safely record and log. |
| * For trap level >1 we just clear the CE bit in the AFSR and |
| * return. |
| * |
| * This is just like __spiftire_access_error above, but it |
| * specifically handles correctable errors. If an |
| * uncorrectable error is indicated in the AFSR we will branch |
| * directly above to __spitfire_access_error to handle it |
| * instead. Uncorrectable therefore takes priority over |
| * correctable, and the error logging C code will notice this |
| * case by inspecting the trap type. |
| */ |
| .type __spitfire_cee_trap,#function |
| __spitfire_cee_trap: |
| ldxa [%g0] ASI_AFSR, %g4 ! Get AFSR |
| mov 1, %g3 |
| sllx %g3, SFAFSR_UE_SHIFT, %g3 |
| andcc %g4, %g3, %g0 ! Check for UE |
| bne,pn %xcc, __spitfire_access_error |
| nop |
| |
| /* Ok, in this case we only have a correctable error. |
| * Indicate we only wish to capture that state in register |
| * %g1, and we only disable CE error reporting unlike UE |
| * handling which disables all errors. |
| */ |
| ldxa [%g0] ASI_ESTATE_ERROR_EN, %g3 |
| andn %g3, ESTATE_ERR_CE, %g3 |
| stxa %g3, [%g0] ASI_ESTATE_ERROR_EN |
| membar #Sync |
| |
| /* Preserve AFSR in %g4, indicate UDB state to capture in %g1 */ |
| ba,pt %xcc, __spitfire_cee_trap_continue |
| mov UDBE_CE, %g1 |
| .size __spitfire_cee_trap,.-__spitfire_cee_trap |
| |
| .type __spitfire_data_access_exception_tl1,#function |
| __spitfire_data_access_exception_tl1: |
| rdpr %pstate, %g4 |
| wrpr %g4, PSTATE_MG|PSTATE_AG, %pstate |
| mov TLB_SFSR, %g3 |
| mov DMMU_SFAR, %g5 |
| ldxa [%g3] ASI_DMMU, %g4 ! Get SFSR |
| ldxa [%g5] ASI_DMMU, %g5 ! Get SFAR |
| stxa %g0, [%g3] ASI_DMMU ! Clear SFSR.FaultValid bit |
| membar #Sync |
| rdpr %tt, %g3 |
| cmp %g3, 0x80 ! first win spill/fill trap |
| blu,pn %xcc, 1f |
| cmp %g3, 0xff ! last win spill/fill trap |
| bgu,pn %xcc, 1f |
| nop |
| ba,pt %xcc, winfix_dax |
| rdpr %tpc, %g3 |
| 1: sethi %hi(109f), %g7 |
| ba,pt %xcc, etraptl1 |
| 109: or %g7, %lo(109b), %g7 |
| mov %l4, %o1 |
| mov %l5, %o2 |
| call spitfire_data_access_exception_tl1 |
| add %sp, PTREGS_OFF, %o0 |
| ba,pt %xcc, rtrap |
| nop |
| .size __spitfire_data_access_exception_tl1,.-__spitfire_data_access_exception_tl1 |
| |
| .type __spitfire_data_access_exception,#function |
| __spitfire_data_access_exception: |
| rdpr %pstate, %g4 |
| wrpr %g4, PSTATE_MG|PSTATE_AG, %pstate |
| mov TLB_SFSR, %g3 |
| mov DMMU_SFAR, %g5 |
| ldxa [%g3] ASI_DMMU, %g4 ! Get SFSR |
| ldxa [%g5] ASI_DMMU, %g5 ! Get SFAR |
| stxa %g0, [%g3] ASI_DMMU ! Clear SFSR.FaultValid bit |
| membar #Sync |
| sethi %hi(109f), %g7 |
| ba,pt %xcc, etrap |
| 109: or %g7, %lo(109b), %g7 |
| mov %l4, %o1 |
| mov %l5, %o2 |
| call spitfire_data_access_exception |
| add %sp, PTREGS_OFF, %o0 |
| ba,pt %xcc, rtrap |
| nop |
| .size __spitfire_data_access_exception,.-__spitfire_data_access_exception |
| |
| .type __spitfire_insn_access_exception_tl1,#function |
| __spitfire_insn_access_exception_tl1: |
| rdpr %pstate, %g4 |
| wrpr %g4, PSTATE_MG|PSTATE_AG, %pstate |
| mov TLB_SFSR, %g3 |
| ldxa [%g3] ASI_IMMU, %g4 ! Get SFSR |
| rdpr %tpc, %g5 ! IMMU has no SFAR, use TPC |
| stxa %g0, [%g3] ASI_IMMU ! Clear FaultValid bit |
| membar #Sync |
| sethi %hi(109f), %g7 |
| ba,pt %xcc, etraptl1 |
| 109: or %g7, %lo(109b), %g7 |
| mov %l4, %o1 |
| mov %l5, %o2 |
| call spitfire_insn_access_exception_tl1 |
| add %sp, PTREGS_OFF, %o0 |
| ba,pt %xcc, rtrap |
| nop |
| .size __spitfire_insn_access_exception_tl1,.-__spitfire_insn_access_exception_tl1 |
| |
| .type __spitfire_insn_access_exception,#function |
| __spitfire_insn_access_exception: |
| rdpr %pstate, %g4 |
| wrpr %g4, PSTATE_MG|PSTATE_AG, %pstate |
| mov TLB_SFSR, %g3 |
| ldxa [%g3] ASI_IMMU, %g4 ! Get SFSR |
| rdpr %tpc, %g5 ! IMMU has no SFAR, use TPC |
| stxa %g0, [%g3] ASI_IMMU ! Clear FaultValid bit |
| membar #Sync |
| sethi %hi(109f), %g7 |
| ba,pt %xcc, etrap |
| 109: or %g7, %lo(109b), %g7 |
| mov %l4, %o1 |
| mov %l5, %o2 |
| call spitfire_insn_access_exception |
| add %sp, PTREGS_OFF, %o0 |
| ba,pt %xcc, rtrap |
| nop |
| .size __spitfire_insn_access_exception,.-__spitfire_insn_access_exception |
