| What: /sys/bus/counter/devices/counterX/signalY/cable_fault |
| KernelVersion: 5.7 |
| Contact: linux-iio@vger.kernel.org |
| Description: |
| Read-only attribute that indicates whether a differential |
| encoder cable fault (not connected or loose wires) is detected |
| for the respective channel of Signal Y. Valid attribute values |
| are boolean. Detection must first be enabled via the |
| corresponding cable_fault_enable attribute. |
| |
| What: /sys/bus/counter/devices/counterX/signalY/cable_fault_enable |
| KernelVersion: 5.7 |
| Contact: linux-iio@vger.kernel.org |
| Description: |
| Whether detection of differential encoder cable faults for the |
| respective channel of Signal Y is enabled. Valid attribute |
| values are boolean. |
| |
| What: /sys/bus/counter/devices/counterX/signalY/filter_clock_prescaler |
| KernelVersion: 5.7 |
| Contact: linux-iio@vger.kernel.org |
| Description: |
| Filter clock factor for input Signal Y. This prescaler value |
| affects the inputs of both quadrature pair signals. |
| |
| What: /sys/bus/counter/devices/counterX/signalY/index_polarity |
| KernelVersion: 5.2 |
| Contact: linux-iio@vger.kernel.org |
| Description: |
| Active level of index input Signal Y; irrelevant in |
| non-synchronous load mode. |
| |
| What: /sys/bus/counter/devices/counterX/signalY/index_polarity_available |
| What: /sys/bus/counter/devices/counterX/signalY/synchronous_mode_available |
| KernelVersion: 5.2 |
| Contact: linux-iio@vger.kernel.org |
| Description: |
| Discrete set of available values for the respective Signal Y |
| configuration are listed in this file. |
| |
| What: /sys/bus/counter/devices/counterX/signalY/synchronous_mode |
| KernelVersion: 5.2 |
| Contact: linux-iio@vger.kernel.org |
| Description: |
| Configure the counter associated with Signal Y for |
| non-synchronous or synchronous load mode. Synchronous load mode |
| cannot be selected in non-quadrature (Pulse-Direction) clock |
| mode. |
| |
| non-synchronous: |
| A logic low level is the active level at this index |
| input. The index function (as enabled via preset_enable) |
| is performed directly on the active level of the index |
| input. |
| |
| synchronous: |
| Intended for interfacing with encoder Index output in |
| quadrature clock mode. The active level is configured |
| via index_polarity. The index function (as enabled via |
| preset_enable) is performed synchronously with the |
| quadrature clock on the active level of the index input. |
