| NTC Thermistor hwmon sensors |
| ------------------------------- |
| |
| Requires node properties: |
| - "compatible" value : one of |
| "epcos,b57330v2103" |
| "epcos,b57891s0103" |
| "murata,ncp15wb473" |
| "murata,ncp18wb473" |
| "murata,ncp21wb473" |
| "murata,ncp03wb473" |
| "murata,ncp15wl333" |
| "murata,ncp03wf104" |
| "murata,ncp15xh103" |
| |
| /* Usage of vendor name "ntc" is deprecated */ |
| <DEPRECATED> "ntc,ncp15wb473" |
| <DEPRECATED> "ntc,ncp18wb473" |
| <DEPRECATED> "ntc,ncp21wb473" |
| <DEPRECATED> "ntc,ncp03wb473" |
| <DEPRECATED> "ntc,ncp15wl333" |
| |
| - "pullup-uv" Pull up voltage in micro volts |
| - "pullup-ohm" Pull up resistor value in ohms |
| - "pulldown-ohm" Pull down resistor value in ohms |
| - "connected-positive" Always ON, If not specified. |
| Status change is possible. |
| - "io-channels" Channel node of ADC to be used for |
| conversion. |
| |
| Optional node properties: |
| - "#thermal-sensor-cells" Used to expose itself to thermal fw. |
| |
| Read more about iio bindings at |
| Documentation/devicetree/bindings/iio/iio-bindings.txt |
| |
| Example: |
| ncp15wb473@0 { |
| compatible = "murata,ncp15wb473"; |
| pullup-uv = <1800000>; |
| pullup-ohm = <47000>; |
| pulldown-ohm = <0>; |
| io-channels = <&adc 3>; |
| }; |
