| STMicroelectronics stih4xx platforms |
| |
| - sti-vtg: video timing generator |
| Required properties: |
| - compatible: "st,vtg" |
| - reg: Physical base address of the IP registers and length of memory mapped region. |
| Optional properties: |
| - interrupts : VTG interrupt number to the CPU. |
| - st,slave: phandle on a slave vtg |
| |
| - sti-vtac: video timing advanced inter dye communication Rx and TX |
| Required properties: |
| - compatible: "st,vtac-main" or "st,vtac-aux" |
| - reg: Physical base address of the IP registers and length of memory mapped region. |
| - clocks: from common clock binding: handle hardware IP needed clocks, the |
| number of clocks may depend of the SoC type. |
| See ../clocks/clock-bindings.txt for details. |
| - clock-names: names of the clocks listed in clocks property in the same |
| order. |
| |
| - sti-display-subsystem: Master device for DRM sub-components |
| This device must be the parent of all the sub-components and is responsible |
| of bind them. |
| Required properties: |
| - compatible: "st,sti-display-subsystem" |
| - ranges: to allow probing of subdevices |
| |
| - sti-compositor: frame compositor engine |
| must be a child of sti-display-subsystem |
| Required properties: |
| - compatible: "st,stih<chip>-compositor" |
| - reg: Physical base address of the IP registers and length of memory mapped region. |
| - clocks: from common clock binding: handle hardware IP needed clocks, the |
| number of clocks may depend of the SoC type. |
| See ../clocks/clock-bindings.txt for details. |
| - clock-names: names of the clocks listed in clocks property in the same |
| order. |
| - resets: resets to be used by the device |
| See ../reset/reset.txt for details. |
| - reset-names: names of the resets listed in resets property in the same |
| order. |
| - st,vtg: phandle(s) on vtg device (main and aux) nodes. |
| |
| - sti-tvout: video out hardware block |
| must be a child of sti-display-subsystem |
| Required properties: |
| - compatible: "st,stih<chip>-tvout" |
| - reg: Physical base address of the IP registers and length of memory mapped region. |
| - reg-names: names of the mapped memory regions listed in regs property in |
| the same order. |
| - resets: resets to be used by the device |
| See ../reset/reset.txt for details. |
| - reset-names: names of the resets listed in resets property in the same |
| order. |
| - ranges: to allow probing of subdevices |
| |
| - sti-hdmi: hdmi output block |
| must be a child of sti-tvout |
| Required properties: |
| - compatible: "st,stih<chip>-hdmi"; |
| - reg: Physical base address of the IP registers and length of memory mapped region. |
| - reg-names: names of the mapped memory regions listed in regs property in |
| the same order. |
| - interrupts : HDMI interrupt number to the CPU. |
| - interrupt-names: name of the interrupts listed in interrupts property in |
| the same order |
| - clocks: from common clock binding: handle hardware IP needed clocks, the |
| number of clocks may depend of the SoC type. |
| - clock-names: names of the clocks listed in clocks property in the same |
| order. |
| - hdmi,hpd-gpio: gpio id to detect if an hdmi cable is plugged or not. |
| |
| sti-hda: |
| Required properties: |
| must be a child of sti-tvout |
| - compatible: "st,stih<chip>-hda" |
| - reg: Physical base address of the IP registers and length of memory mapped region. |
| - reg-names: names of the mapped memory regions listed in regs property in |
| the same order. |
| - clocks: from common clock binding: handle hardware IP needed clocks, the |
| number of clocks may depend of the SoC type. |
| See ../clocks/clock-bindings.txt for details. |
| - clock-names: names of the clocks listed in clocks property in the same |
| order. |
| |
| Example: |
| |
| / { |
| ... |
| |
| vtg_main_slave: sti-vtg-main-slave@fe85A800 { |
| compatible = "st,vtg"; |
| reg = <0xfe85A800 0x300>; |
| interrupts = <GIC_SPI 175 IRQ_TYPE_NONE>; |
| }; |
| |
| vtg_main: sti-vtg-main-master@fd348000 { |
| compatible = "st,vtg"; |
| reg = <0xfd348000 0x400>; |
| st,slave = <&vtg_main_slave>; |
| }; |
| |
| vtg_aux_slave: sti-vtg-aux-slave@fd348400 { |
| compatible = "st,vtg"; |
| reg = <0xfe858200 0x300>; |
| interrupts = <GIC_SPI 176 IRQ_TYPE_NONE>; |
| }; |
| |
| vtg_aux: sti-vtg-aux-master@fd348400 { |
| compatible = "st,vtg"; |
| reg = <0xfd348400 0x400>; |
| st,slave = <&vtg_aux_slave>; |
| }; |
| |
| |
| sti-vtac-rx-main@fee82800 { |
| compatible = "st,vtac-main"; |
| reg = <0xfee82800 0x200>; |
| clock-names = "vtac"; |
| clocks = <&clk_m_a2_div0 CLK_M_VTAC_MAIN_PHY>; |
| }; |
| |
| sti-vtac-rx-aux@fee82a00 { |
| compatible = "st,vtac-aux"; |
| reg = <0xfee82a00 0x200>; |
| clock-names = "vtac"; |
| clocks = <&clk_m_a2_div0 CLK_M_VTAC_AUX_PHY>; |
| }; |
| |
| sti-vtac-tx-main@fd349000 { |
| compatible = "st,vtac-main"; |
| reg = <0xfd349000 0x200>, <0xfd320000 0x10000>; |
| clock-names = "vtac"; |
| clocks = <&clk_s_a1_hs CLK_S_VTAC_TX_PHY>; |
| }; |
| |
| sti-vtac-tx-aux@fd349200 { |
| compatible = "st,vtac-aux"; |
| reg = <0xfd349200 0x200>, <0xfd320000 0x10000>; |
| clock-names = "vtac"; |
| clocks = <&clk_s_a1_hs CLK_S_VTAC_TX_PHY>; |
| }; |
| |
| sti-display-subsystem { |
| compatible = "st,sti-display-subsystem"; |
| ranges; |
| |
| sti-compositor@fd340000 { |
| compatible = "st,stih416-compositor"; |
| reg = <0xfd340000 0x1000>; |
| clock-names = "compo_main", "compo_aux", |
| "pix_main", "pix_aux"; |
| clocks = <&clk_m_a2_div1 CLK_M_COMPO_MAIN>, <&clk_m_a2_div1 CLK_M_COMPO_AUX>, |
| <&clockgen_c_vcc CLK_S_PIX_MAIN>, <&clockgen_c_vcc CLK_S_PIX_AUX>; |
| reset-names = "compo-main", "compo-aux"; |
| resets = <&softreset STIH416_COMPO_M_SOFTRESET>, <&softreset STIH416_COMPO_A_SOFTRESET>; |
| st,vtg = <&vtg_main>, <&vtg_aux>; |
| }; |
| |
| sti-tvout@fe000000 { |
| compatible = "st,stih416-tvout"; |
| reg = <0xfe000000 0x1000>, <0xfe85a000 0x400>, <0xfe830000 0x10000>; |
| reg-names = "tvout-reg", "hda-reg", "syscfg"; |
| reset-names = "tvout"; |
| resets = <&softreset STIH416_HDTVOUT_SOFTRESET>; |
| ranges; |
| |
| sti-hdmi@fe85c000 { |
| compatible = "st,stih416-hdmi"; |
| reg = <0xfe85c000 0x1000>, <0xfe830000 0x10000>; |
| reg-names = "hdmi-reg", "syscfg"; |
| interrupts = <GIC_SPI 173 IRQ_TYPE_NONE>; |
| interrupt-names = "irq"; |
| clock-names = "pix", "tmds", "phy", "audio"; |
| clocks = <&clockgen_c_vcc CLK_S_PIX_HDMI>, <&clockgen_c_vcc CLK_S_TMDS_HDMI>, <&clockgen_c_vcc CLK_S_HDMI_REJECT_PLL>, <&clockgen_b1 CLK_S_PCM_0>; |
| hdmi,hpd-gpio = <&PIO2 5>; |
| }; |
| |
| sti-hda@fe85a000 { |
| compatible = "st,stih416-hda"; |
| reg = <0xfe85a000 0x400>, <0xfe83085c 0x4>; |
| reg-names = "hda-reg", "video-dacs-ctrl"; |
| clock-names = "pix", "hddac"; |
| clocks = <&clockgen_c_vcc CLK_S_PIX_HD>, <&clockgen_c_vcc CLK_S_HDDAC>; |
| }; |
| }; |
| }; |
| ... |
| }; |
