| // SPDX-License-Identifier: GPL-2.0-or-later | |
| /* | |
| * Copyright (C) 2000-2003 Deep Blue Solutions Ltd | |
| */ | |
| #include <linux/kernel.h> | |
| #include <linux/init.h> | |
| #include <linux/syscore_ops.h> | |
| #include <linux/amba/bus.h> | |
| #include <linux/io.h> | |
| #include <linux/irqchip.h> | |
| #include <linux/of_irq.h> | |
| #include <linux/of_address.h> | |
| #include <linux/of_platform.h> | |
| #include <linux/uaccess.h> | |
| #include <linux/termios.h> | |
| #include <linux/mfd/syscon.h> | |
| #include <linux/regmap.h> | |
| #include <asm/mach/arch.h> | |
| #include <asm/mach/map.h> | |
| #include "integrator-hardware.h" | |
| #include "integrator-cm.h" | |
| #include "integrator.h" | |
| /* Regmap to the AP system controller */ | |
| static struct regmap *ap_syscon_map; | |
| /* | |
| * All IO addresses are mapped onto VA 0xFFFx.xxxx, where x.xxxx | |
| * is the (PA >> 12). | |
| * | |
| * Setup a VA for the Integrator interrupt controller (for header #0, | |
| * just for now). | |
| */ | |
| #define VA_IC_BASE __io_address(INTEGRATOR_IC_BASE) | |
| /* | |
| * Logical Physical | |
| * f1400000 14000000 Interrupt controller | |
| * f1600000 16000000 UART 0 | |
| */ | |
| static struct map_desc ap_io_desc[] __initdata __maybe_unused = { | |
| { | |
| .virtual = IO_ADDRESS(INTEGRATOR_IC_BASE), | |
| .pfn = __phys_to_pfn(INTEGRATOR_IC_BASE), | |
| .length = SZ_4K, | |
| .type = MT_DEVICE | |
| }, { | |
| .virtual = IO_ADDRESS(INTEGRATOR_UART0_BASE), | |
| .pfn = __phys_to_pfn(INTEGRATOR_UART0_BASE), | |
| .length = SZ_4K, | |
| .type = MT_DEVICE | |
| } | |
| }; | |
| static void __init ap_map_io(void) | |
| { | |
| iotable_init(ap_io_desc, ARRAY_SIZE(ap_io_desc)); | |
| } | |
| #ifdef CONFIG_PM | |
| static unsigned long ic_irq_enable; | |
| static int irq_suspend(void *data) | |
| { | |
| ic_irq_enable = readl(VA_IC_BASE + IRQ_ENABLE); | |
| return 0; | |
| } | |
| static void irq_resume(void *data) | |
| { | |
| /* disable all irq sources */ | |
| cm_clear_irqs(); | |
| writel(-1, VA_IC_BASE + IRQ_ENABLE_CLEAR); | |
| writel(-1, VA_IC_BASE + FIQ_ENABLE_CLEAR); | |
| writel(ic_irq_enable, VA_IC_BASE + IRQ_ENABLE_SET); | |
| } | |
| #else | |
| #define irq_suspend NULL | |
| #define irq_resume NULL | |
| #endif | |
| static const struct syscore_ops irq_syscore_ops = { | |
| .suspend = irq_suspend, | |
| .resume = irq_resume, | |
| }; | |
| static struct syscore irq_syscore = { | |
| .ops = &irq_syscore_ops, | |
| }; | |
| static int __init irq_syscore_init(void) | |
| { | |
| register_syscore(&irq_syscore); | |
| return 0; | |
| } | |
| device_initcall(irq_syscore_init); | |
| /* | |
| * For the PL010 found in the Integrator/AP some of the UART control is | |
| * implemented in the system controller and accessed using a callback | |
| * from the driver. | |
| */ | |
| static void integrator_uart_set_mctrl(struct amba_device *dev, | |
| void __iomem *base, unsigned int mctrl) | |
| { | |
| unsigned int ctrls = 0, ctrlc = 0, rts_mask, dtr_mask; | |
| u32 phybase = dev->res.start; | |
| int ret; | |
| if (phybase == INTEGRATOR_UART0_BASE) { | |
| /* UART0 */ | |
| rts_mask = 1 << 4; | |
| dtr_mask = 1 << 5; | |
| } else { | |
| /* UART1 */ | |
| rts_mask = 1 << 6; | |
| dtr_mask = 1 << 7; | |
| } | |
| if (mctrl & TIOCM_RTS) | |
| ctrlc |= rts_mask; | |
| else | |
| ctrls |= rts_mask; | |
| if (mctrl & TIOCM_DTR) | |
| ctrlc |= dtr_mask; | |
| else | |
| ctrls |= dtr_mask; | |
| ret = regmap_write(ap_syscon_map, | |
| INTEGRATOR_SC_CTRLS_OFFSET, | |
| ctrls); | |
| if (ret) | |
| pr_err("MODEM: unable to write PL010 UART CTRLS\n"); | |
| ret = regmap_write(ap_syscon_map, | |
| INTEGRATOR_SC_CTRLC_OFFSET, | |
| ctrlc); | |
| if (ret) | |
| pr_err("MODEM: unable to write PL010 UART CRTLC\n"); | |
| } | |
| struct amba_pl010_data ap_uart_data = { | |
| .set_mctrl = integrator_uart_set_mctrl, | |
| }; | |
| static void __init ap_init_irq_of(void) | |
| { | |
| cm_init(); | |
| irqchip_init(); | |
| } | |
| /* For the Device Tree, add in the UART callbacks as AUXDATA */ | |
| static struct of_dev_auxdata ap_auxdata_lookup[] __initdata = { | |
| OF_DEV_AUXDATA("arm,primecell", INTEGRATOR_UART0_BASE, | |
| "uart0", &ap_uart_data), | |
| OF_DEV_AUXDATA("arm,primecell", INTEGRATOR_UART1_BASE, | |
| "uart1", &ap_uart_data), | |
| { /* sentinel */ }, | |
| }; | |
| static const struct of_device_id ap_syscon_match[] = { | |
| { .compatible = "arm,integrator-ap-syscon"}, | |
| { }, | |
| }; | |
| static void __init ap_init_of(void) | |
| { | |
| struct device_node *syscon; | |
| of_platform_default_populate(NULL, ap_auxdata_lookup, NULL); | |
| syscon = of_find_matching_node(NULL, ap_syscon_match); | |
| if (!syscon) | |
| return; | |
| ap_syscon_map = syscon_node_to_regmap(syscon); | |
| if (IS_ERR(ap_syscon_map)) { | |
| pr_crit("could not find Integrator/AP system controller\n"); | |
| return; | |
| } | |
| } | |
| static const char * ap_dt_board_compat[] = { | |
| "arm,integrator-ap", | |
| NULL, | |
| }; | |
| DT_MACHINE_START(INTEGRATOR_AP_DT, "ARM Integrator/AP (Device Tree)") | |
| .reserve = integrator_reserve, | |
| .map_io = ap_map_io, | |
| .init_irq = ap_init_irq_of, | |
| .init_machine = ap_init_of, | |
| .dt_compat = ap_dt_board_compat, | |
| MACHINE_END |