| // SPDX-License-Identifier: GPL-2.0 | |
| use core::ops::{ | |
| Deref, | |
| Range, // | |
| }; | |
| use kernel::{ | |
| device, | |
| dma::CoherentHandle, | |
| fmt, | |
| io::Io, | |
| prelude::*, | |
| ptr::{ | |
| Alignable, | |
| Alignment, // | |
| }, | |
| sizes::*, // | |
| }; | |
| use crate::{ | |
| driver::Bar0, | |
| firmware::gsp::GspFirmware, | |
| gpu::Chipset, | |
| gsp, | |
| num::FromSafeCast, | |
| regs, // | |
| }; | |
| mod hal; | |
| /// Type holding the sysmem flush memory page, a page of memory to be written into the | |
| /// `NV_PFB_NISO_FLUSH_SYSMEM_ADDR*` registers and used to maintain memory coherency. | |
| /// | |
| /// A system memory page is required for `sysmembar`, which is a GPU-initiated hardware | |
| /// memory-barrier operation that flushes all pending GPU-side memory writes that were done through | |
| /// PCIE to system memory. It is required for falcons to be reset as the reset operation involves a | |
| /// reset handshake. When the falcon acknowledges a reset, it writes into system memory. To ensure | |
| /// this write is visible to the host and prevent driver timeouts, the falcon must perform a | |
| /// sysmembar operation to flush its writes. | |
| /// | |
| /// Because of this, the sysmem flush memory page must be registered as early as possible during | |
| /// driver initialization, and before any falcon is reset. | |
| /// | |
| pub(crate) struct SysmemFlush<'sys> { | |
| /// Chipset we are operating on. | |
| chipset: Chipset, | |
| device: &'sys device::Device, | |
| bar: Bar0<'sys>, | |
| /// Keep the page alive as long as we need it. | |
| page: CoherentHandle, | |
| } | |
| impl<'sys> SysmemFlush<'sys> { | |
| /// Allocate a memory page and register it as the sysmem flush page. | |
| pub(crate) fn register( | |
| dev: &'sys device::Device<device::Bound>, | |
| bar: Bar0<'sys>, | |
| chipset: Chipset, | |
| ) -> Result<Self> { | |
| let page = CoherentHandle::alloc(dev, kernel::page::PAGE_SIZE, GFP_KERNEL)?; | |
| hal::fb_hal(chipset).write_sysmem_flush_page(bar, page.dma_handle())?; | |
| Ok(Self { | |
| chipset, | |
| device: dev, | |
| bar, | |
| page, | |
| }) | |
| } | |
| } | |
| impl Drop for SysmemFlush<'_> { | |
| fn drop(&mut self) { | |
| let hal = hal::fb_hal(self.chipset); | |
| if hal.read_sysmem_flush_page(self.bar) == self.page.dma_handle() { | |
| let _ = hal.write_sysmem_flush_page(self.bar, 0).inspect_err(|e| { | |
| dev_warn!( | |
| &self.device, | |
| "failed to unregister sysmem flush page: {:?}\n", | |
| e | |
| ) | |
| }); | |
| } else { | |
| // Another page has been registered after us for some reason - warn as this is a bug. | |
| dev_warn!( | |
| &self.device, | |
| "attempt to unregister a sysmem flush page that is not active\n" | |
| ); | |
| } | |
| } | |
| } | |
| pub(crate) struct FbRange(Range<u64>); | |
| impl FbRange { | |
| pub(crate) fn len(&self) -> u64 { | |
| self.0.end - self.0.start | |
| } | |
| } | |
| impl From<Range<u64>> for FbRange { | |
| fn from(range: Range<u64>) -> Self { | |
| Self(range) | |
| } | |
| } | |
| impl Deref for FbRange { | |
| type Target = Range<u64>; | |
| fn deref(&self) -> &Self::Target { | |
| &self.0 | |
| } | |
| } | |
| impl fmt::Debug for FbRange { | |
| fn fmt(&self, f: &mut fmt::Formatter<'_>) -> fmt::Result { | |
| // Use alternate format ({:#?}) to include size, compact format ({:?}) for just the range. | |
| if f.alternate() { | |
| let size = self.len(); | |
| if size < u64::SZ_1M { | |
| let size_kib = size / u64::SZ_1K; | |
| f.write_fmt(fmt!( | |
| "{:#x}..{:#x} ({} KiB)", | |
| self.0.start, | |
| self.0.end, | |
| size_kib | |
| )) | |
| } else { | |
| let size_mib = size / u64::SZ_1M; | |
| f.write_fmt(fmt!( | |
| "{:#x}..{:#x} ({} MiB)", | |
| self.0.start, | |
| self.0.end, | |
| size_mib | |
| )) | |
| } | |
| } else { | |
| f.write_fmt(fmt!("{:#x}..{:#x}", self.0.start, self.0.end)) | |
| } | |
| } | |
| } | |
| /// Layout of the GPU framebuffer memory. | |
| /// | |
| /// Contains ranges of GPU memory reserved for a given purpose during the GSP boot process. | |
| #[derive(Debug)] | |
| pub(crate) struct FbLayout { | |
| /// Range of the framebuffer. Starts at `0`. | |
| pub(crate) fb: FbRange, | |
| /// VGA workspace, small area of reserved memory at the end of the framebuffer. | |
| pub(crate) vga_workspace: FbRange, | |
| /// FRTS range. | |
| pub(crate) frts: FbRange, | |
| /// Memory area containing the GSP bootloader image. | |
| pub(crate) boot: FbRange, | |
| /// Memory area containing the GSP firmware image. | |
| pub(crate) elf: FbRange, | |
| /// WPR2 heap. | |
| pub(crate) wpr2_heap: FbRange, | |
| /// WPR2 region range, starting with an instance of `GspFwWprMeta`. | |
| pub(crate) wpr2: FbRange, | |
| pub(crate) heap: FbRange, | |
| pub(crate) vf_partition_count: u8, | |
| /// PMU reserved memory size, in bytes. | |
| pub(crate) pmu_reserved_size: u32, | |
| } | |
| impl FbLayout { | |
| /// Computes the FB layout for `chipset` required to run the `gsp_fw` GSP firmware. | |
| pub(crate) fn new(chipset: Chipset, bar: Bar0<'_>, gsp_fw: &GspFirmware) -> Result<Self> { | |
| let hal = hal::fb_hal(chipset); | |
| let fb = { | |
| let fb_size = hal.vidmem_size(bar); | |
| FbRange(0..fb_size) | |
| }; | |
| let vga_workspace = { | |
| let vga_base = { | |
| const NV_PRAMIN_SIZE: u64 = u64::SZ_1M; | |
| let base = fb.end - NV_PRAMIN_SIZE; | |
| if hal.supports_display(bar) { | |
| match bar | |
| .read(regs::NV_PDISP_VGA_WORKSPACE_BASE) | |
| .vga_workspace_addr() | |
| { | |
| Some(addr) => { | |
| if addr < base { | |
| const VBIOS_WORKSPACE_SIZE: u64 = u64::SZ_128K; | |
| // Point workspace address to end of framebuffer. | |
| fb.end - VBIOS_WORKSPACE_SIZE | |
| } else { | |
| addr | |
| } | |
| } | |
| None => base, | |
| } | |
| } else { | |
| base | |
| } | |
| }; | |
| FbRange(vga_base..fb.end) | |
| }; | |
| let frts = { | |
| const FRTS_DOWN_ALIGN: Alignment = Alignment::new::<SZ_128K>(); | |
| let frts_size: u64 = hal.frts_size(); | |
| let frts_base = vga_workspace.start.align_down(FRTS_DOWN_ALIGN) - frts_size; | |
| FbRange(frts_base..frts_base + frts_size) | |
| }; | |
| let boot = { | |
| const BOOTLOADER_DOWN_ALIGN: Alignment = Alignment::new::<SZ_4K>(); | |
| let bootloader_size = u64::from_safe_cast(gsp_fw.bootloader.ucode.size()); | |
| let bootloader_base = (frts.start - bootloader_size).align_down(BOOTLOADER_DOWN_ALIGN); | |
| FbRange(bootloader_base..bootloader_base + bootloader_size) | |
| }; | |
| let elf = { | |
| const ELF_DOWN_ALIGN: Alignment = Alignment::new::<SZ_64K>(); | |
| let elf_size = u64::from_safe_cast(gsp_fw.size); | |
| let elf_addr = (boot.start - elf_size).align_down(ELF_DOWN_ALIGN); | |
| FbRange(elf_addr..elf_addr + elf_size) | |
| }; | |
| let wpr2_heap = { | |
| const WPR2_HEAP_DOWN_ALIGN: Alignment = Alignment::new::<SZ_1M>(); | |
| let wpr2_heap_size = | |
| gsp::LibosParams::from_chipset(chipset).wpr_heap_size(chipset, fb.end)?; | |
| let wpr2_heap_addr = (elf.start - wpr2_heap_size).align_down(WPR2_HEAP_DOWN_ALIGN); | |
| FbRange(wpr2_heap_addr..(elf.start).align_down(WPR2_HEAP_DOWN_ALIGN)) | |
| }; | |
| let wpr2 = { | |
| const WPR2_DOWN_ALIGN: Alignment = Alignment::new::<SZ_1M>(); | |
| let wpr2_addr = (wpr2_heap.start - u64::from_safe_cast(size_of::<gsp::GspFwWprMeta>())) | |
| .align_down(WPR2_DOWN_ALIGN); | |
| FbRange(wpr2_addr..frts.end) | |
| }; | |
| let heap = { | |
| let heap_size = u64::from(hal.non_wpr_heap_size()); | |
| FbRange(wpr2.start - heap_size..wpr2.start) | |
| }; | |
| Ok(Self { | |
| fb, | |
| vga_workspace, | |
| frts, | |
| boot, | |
| elf, | |
| wpr2_heap, | |
| wpr2, | |
| heap, | |
| vf_partition_count: 0, | |
| pmu_reserved_size: hal.pmu_reserved_size(), | |
| }) | |
| } | |
| } |