blob: e69856cb62d5b30cf592eecf77026e2fedc6c8dc [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0-only
/*
* LG.Philips LB035Q02 LCD Panel driver
*
* Copyright (C) 2013 Texas Instruments
* Author: Tomi Valkeinen <tomi.valkeinen@ti.com>
* Based on a driver by: Steve Sakoman <steve@sakoman.com>
*/
#include <linux/module.h>
#include <linux/delay.h>
#include <linux/spi/spi.h>
#include <linux/mutex.h>
#include <linux/gpio/consumer.h>
#include <video/omapfb_dss.h>
static const struct omap_video_timings lb035q02_timings = {
.x_res = 320,
.y_res = 240,
.pixelclock = 6500000,
.hsw = 2,
.hfp = 20,
.hbp = 68,
.vsw = 2,
.vfp = 4,
.vbp = 18,
.vsync_level = OMAPDSS_SIG_ACTIVE_LOW,
.hsync_level = OMAPDSS_SIG_ACTIVE_LOW,
.data_pclk_edge = OMAPDSS_DRIVE_SIG_RISING_EDGE,
.de_level = OMAPDSS_SIG_ACTIVE_HIGH,
.sync_pclk_edge = OMAPDSS_DRIVE_SIG_FALLING_EDGE,
};
struct panel_drv_data {
struct omap_dss_device dssdev;
struct omap_dss_device *in;
struct spi_device *spi;
int data_lines;
struct omap_video_timings videomode;
struct gpio_desc *enable_gpio;
};
#define to_panel_data(p) container_of(p, struct panel_drv_data, dssdev)
static int lb035q02_write_reg(struct spi_device *spi, u8 reg, u16 val)
{
struct spi_message msg;
struct spi_transfer index_xfer = {
.len = 3,
.cs_change = 1,
};
struct spi_transfer value_xfer = {
.len = 3,
};
u8 buffer[16];
spi_message_init(&msg);
/* register index */
buffer[0] = 0x70;
buffer[1] = 0x00;
buffer[2] = reg & 0x7f;
index_xfer.tx_buf = buffer;
spi_message_add_tail(&index_xfer, &msg);
/* register value */
buffer[4] = 0x72;
buffer[5] = val >> 8;
buffer[6] = val;
value_xfer.tx_buf = buffer + 4;
spi_message_add_tail(&value_xfer, &msg);
return spi_sync(spi, &msg);
}
static void init_lb035q02_panel(struct spi_device *spi)
{
/* Init sequence from page 28 of the lb035q02 spec */
lb035q02_write_reg(spi, 0x01, 0x6300);
lb035q02_write_reg(spi, 0x02, 0x0200);
lb035q02_write_reg(spi, 0x03, 0x0177);
lb035q02_write_reg(spi, 0x04, 0x04c7);
lb035q02_write_reg(spi, 0x05, 0xffc0);
lb035q02_write_reg(spi, 0x06, 0xe806);
lb035q02_write_reg(spi, 0x0a, 0x4008);
lb035q02_write_reg(spi, 0x0b, 0x0000);
lb035q02_write_reg(spi, 0x0d, 0x0030);
lb035q02_write_reg(spi, 0x0e, 0x2800);
lb035q02_write_reg(spi, 0x0f, 0x0000);
lb035q02_write_reg(spi, 0x16, 0x9f80);
lb035q02_write_reg(spi, 0x17, 0x0a0f);
lb035q02_write_reg(spi, 0x1e, 0x00c1);
lb035q02_write_reg(spi, 0x30, 0x0300);
lb035q02_write_reg(spi, 0x31, 0x0007);
lb035q02_write_reg(spi, 0x32, 0x0000);
lb035q02_write_reg(spi, 0x33, 0x0000);
lb035q02_write_reg(spi, 0x34, 0x0707);
lb035q02_write_reg(spi, 0x35, 0x0004);
lb035q02_write_reg(spi, 0x36, 0x0302);
lb035q02_write_reg(spi, 0x37, 0x0202);
lb035q02_write_reg(spi, 0x3a, 0x0a0d);
lb035q02_write_reg(spi, 0x3b, 0x0806);
}
static int lb035q02_connect(struct omap_dss_device *dssdev)
{
struct panel_drv_data *ddata = to_panel_data(dssdev);
struct omap_dss_device *in = ddata->in;
int r;
if (omapdss_device_is_connected(dssdev))
return 0;
r = in->ops.dpi->connect(in, dssdev);
if (r)
return r;
init_lb035q02_panel(ddata->spi);
return 0;
}
static void lb035q02_disconnect(struct omap_dss_device *dssdev)
{
struct panel_drv_data *ddata = to_panel_data(dssdev);
struct omap_dss_device *in = ddata->in;
if (!omapdss_device_is_connected(dssdev))
return;
in->ops.dpi->disconnect(in, dssdev);
}
static int lb035q02_enable(struct omap_dss_device *dssdev)
{
struct panel_drv_data *ddata = to_panel_data(dssdev);
struct omap_dss_device *in = ddata->in;
int r;
if (!omapdss_device_is_connected(dssdev))
return -ENODEV;
if (omapdss_device_is_enabled(dssdev))
return 0;
if (ddata->data_lines)
in->ops.dpi->set_data_lines(in, ddata->data_lines);
in->ops.dpi->set_timings(in, &ddata->videomode);
r = in->ops.dpi->enable(in);
if (r)
return r;
if (ddata->enable_gpio)
gpiod_set_value_cansleep(ddata->enable_gpio, 1);
dssdev->state = OMAP_DSS_DISPLAY_ACTIVE;
return 0;
}
static void lb035q02_disable(struct omap_dss_device *dssdev)
{
struct panel_drv_data *ddata = to_panel_data(dssdev);
struct omap_dss_device *in = ddata->in;
if (!omapdss_device_is_enabled(dssdev))
return;
if (ddata->enable_gpio)
gpiod_set_value_cansleep(ddata->enable_gpio, 0);
in->ops.dpi->disable(in);
dssdev->state = OMAP_DSS_DISPLAY_DISABLED;
}
static void lb035q02_set_timings(struct omap_dss_device *dssdev,
struct omap_video_timings *timings)
{
struct panel_drv_data *ddata = to_panel_data(dssdev);
struct omap_dss_device *in = ddata->in;
ddata->videomode = *timings;
dssdev->panel.timings = *timings;
in->ops.dpi->set_timings(in, timings);
}
static void lb035q02_get_timings(struct omap_dss_device *dssdev,
struct omap_video_timings *timings)
{
struct panel_drv_data *ddata = to_panel_data(dssdev);
*timings = ddata->videomode;
}
static int lb035q02_check_timings(struct omap_dss_device *dssdev,
struct omap_video_timings *timings)
{
struct panel_drv_data *ddata = to_panel_data(dssdev);
struct omap_dss_device *in = ddata->in;
return in->ops.dpi->check_timings(in, timings);
}
static struct omap_dss_driver lb035q02_ops = {
.connect = lb035q02_connect,
.disconnect = lb035q02_disconnect,
.enable = lb035q02_enable,
.disable = lb035q02_disable,
.set_timings = lb035q02_set_timings,
.get_timings = lb035q02_get_timings,
.check_timings = lb035q02_check_timings,
.get_resolution = omapdss_default_get_resolution,
};
static int lb035q02_probe_of(struct spi_device *spi)
{
struct device_node *node = spi->dev.of_node;
struct panel_drv_data *ddata = spi_get_drvdata(spi);
struct omap_dss_device *in;
struct gpio_desc *gpio;
gpio = devm_gpiod_get(&spi->dev, "enable", GPIOD_OUT_LOW);
if (IS_ERR(gpio))
return dev_err_probe(&spi->dev, PTR_ERR(gpio),
"failed to parse enable gpio\n");
ddata->enable_gpio = gpio;
in = omapdss_of_find_source_for_first_ep(node);
if (IS_ERR(in)) {
dev_err(&spi->dev, "failed to find video source\n");
return PTR_ERR(in);
}
ddata->in = in;
return 0;
}
static int lb035q02_panel_spi_probe(struct spi_device *spi)
{
struct panel_drv_data *ddata;
struct omap_dss_device *dssdev;
int r;
if (!spi->dev.of_node)
return -ENODEV;
ddata = devm_kzalloc(&spi->dev, sizeof(*ddata), GFP_KERNEL);
if (ddata == NULL)
return -ENOMEM;
spi_set_drvdata(spi, ddata);
ddata->spi = spi;
r = lb035q02_probe_of(spi);
if (r)
return r;
ddata->videomode = lb035q02_timings;
dssdev = &ddata->dssdev;
dssdev->dev = &spi->dev;
dssdev->driver = &lb035q02_ops;
dssdev->type = OMAP_DISPLAY_TYPE_DPI;
dssdev->owner = THIS_MODULE;
dssdev->panel.timings = ddata->videomode;
dssdev->phy.dpi.data_lines = ddata->data_lines;
r = omapdss_register_display(dssdev);
if (r) {
dev_err(&spi->dev, "Failed to register panel\n");
goto err_reg;
}
return 0;
err_reg:
omap_dss_put_device(ddata->in);
return r;
}
static void lb035q02_panel_spi_remove(struct spi_device *spi)
{
struct panel_drv_data *ddata = spi_get_drvdata(spi);
struct omap_dss_device *dssdev = &ddata->dssdev;
struct omap_dss_device *in = ddata->in;
omapdss_unregister_display(dssdev);
lb035q02_disable(dssdev);
lb035q02_disconnect(dssdev);
omap_dss_put_device(in);
}
static const struct of_device_id lb035q02_of_match[] = {
{ .compatible = "omapdss,lgphilips,lb035q02", },
{},
};
MODULE_DEVICE_TABLE(of, lb035q02_of_match);
static struct spi_driver lb035q02_spi_driver = {
.probe = lb035q02_panel_spi_probe,
.remove = lb035q02_panel_spi_remove,
.driver = {
.name = "panel_lgphilips_lb035q02",
.of_match_table = lb035q02_of_match,
.suppress_bind_attrs = true,
},
};
module_spi_driver(lb035q02_spi_driver);
MODULE_ALIAS("spi:lgphilips,lb035q02");
MODULE_AUTHOR("Tomi Valkeinen <tomi.valkeinen@ti.com>");
MODULE_DESCRIPTION("LG.Philips LB035Q02 LCD Panel driver");
MODULE_LICENSE("GPL");