| // SPDX-License-Identifier: GPL-2.0-only |
| |
| #include "msm8916-pm8916.dtsi" |
| #include "msm8916-modem-qdsp6.dtsi" |
| |
| #include <dt-bindings/gpio/gpio.h> |
| #include <dt-bindings/pinctrl/qcom,pmic-mpp.h> |
| |
| / { |
| aliases { |
| mmc0 = &sdhc_1; /* eMMC */ |
| mmc1 = &sdhc_2; /* SD card */ |
| serial0 = &blsp_uart2; |
| }; |
| |
| chosen { |
| stdout-path = "serial0"; |
| }; |
| |
| headphones_switch: audio-switch { |
| compatible = "simple-audio-amplifier"; |
| |
| pinctrl-0 = <&headphones_switch_default>; |
| pinctrl-names = "default"; |
| |
| enable-gpios = <&tlmm 120 GPIO_ACTIVE_HIGH>; |
| sound-name-prefix = "Headphones Switch"; |
| }; |
| |
| backlight: backlight { |
| compatible = "pwm-backlight"; |
| pwms = <&pm8916_pwm 0 100000>; |
| |
| brightness-levels = <0 255>; |
| num-interpolated-steps = <255>; |
| default-brightness-level = <255>; |
| }; |
| |
| battery: battery { |
| compatible = "simple-battery"; |
| voltage-min-design-microvolt = <3400000>; |
| voltage-max-design-microvolt = <4350000>; |
| energy-full-design-microwatt-hours = <8740000>; |
| charge-full-design-microamp-hours = <2300000>; |
| |
| ocv-capacity-celsius = <25>; |
| ocv-capacity-table-0 = <4328000 100>, <4266000 95>, <4208000 90>, |
| <4154000 85>, <4102000 80>, <4062000 75>, <3992000 70>, |
| <3960000 65>, <3914000 60>, <3870000 55>, <3840000 50>, |
| <3818000 45>, <3800000 40>, <3784000 35>, <3770000 30>, |
| <3756000 25>, <3736000 20>, <3714000 16>, <3696000 13>, |
| <3690000 11>, <3689000 10>, <3688000 9>, <3686000 8>, |
| <3682000 7>, <3670000 6>, <3639000 5>, <3592000 4>, |
| <3530000 3>, <3448000 2>, <3320000 1>, <3000000 0>; |
| }; |
| |
| gpio-keys { |
| compatible = "gpio-keys"; |
| |
| pinctrl-0 = <&gpio_keys_default>; |
| pinctrl-names = "default"; |
| |
| label = "GPIO Buttons"; |
| |
| volume-up-button { |
| label = "Volume Up"; |
| gpios = <&tlmm 107 GPIO_ACTIVE_LOW>; |
| linux,code = <KEY_VOLUMEUP>; |
| }; |
| }; |
| }; |
| |
| &blsp_i2c5 { |
| status = "okay"; |
| |
| touchscreen@38 { |
| compatible = "edt,edt-ft5306"; |
| reg = <0x38>; |
| |
| interrupts-extended = <&tlmm 13 IRQ_TYPE_EDGE_FALLING>; |
| |
| vcc-supply = <&pm8916_l17>; |
| iovcc-supply = <&pm8916_l6>; |
| |
| reset-gpios = <&tlmm 12 GPIO_ACTIVE_LOW>; |
| |
| touchscreen-size-x = <720>; |
| touchscreen-size-y = <1280>; |
| |
| pinctrl-0 = <&touchscreen_default>; |
| pinctrl-names = "default"; |
| }; |
| }; |
| |
| &blsp_uart2 { |
| status = "okay"; |
| }; |
| |
| &mpss_mem { |
| reg = <0x0 0x86800000 0x0 0x5500000>; |
| }; |
| |
| &pm8916_bms { |
| monitored-battery = <&battery>; |
| status = "okay"; |
| }; |
| |
| &pm8916_codec { |
| qcom,micbias-lvl = <2800>; |
| qcom,mbhc-vthreshold-low = <75 150 237 450 500>; |
| qcom,mbhc-vthreshold-high = <75 150 237 450 500>; |
| qcom,hphl-jack-type-normally-open; |
| }; |
| |
| &pm8916_pwm { |
| pinctrl-0 = <&pwm_out>; |
| pinctrl-names = "default"; |
| status = "okay"; |
| }; |
| |
| &pm8916_resin { |
| linux,code = <KEY_VOLUMEDOWN>; |
| status = "okay"; |
| }; |
| |
| &pm8916_rpm_regulators { |
| pm8916_l17: l17 { |
| regulator-min-microvolt = <2850000>; |
| regulator-max-microvolt = <2850000>; |
| }; |
| }; |
| |
| &pm8916_vib { |
| status = "okay"; |
| }; |
| |
| &sdhc_1 { |
| status = "okay"; |
| }; |
| |
| &sdhc_2 { |
| pinctrl-0 = <&sdc2_default>; |
| pinctrl-1 = <&sdc2_sleep>; |
| pinctrl-names = "default", "sleep"; |
| |
| non-removable; |
| |
| status = "okay"; |
| }; |
| |
| &usb { |
| status = "okay"; |
| }; |
| |
| &venus { |
| status = "okay"; |
| }; |
| |
| &venus_mem { |
| status = "okay"; |
| }; |
| |
| &wcnss { |
| status = "okay"; |
| }; |
| |
| &wcnss_iris { |
| compatible = "qcom,wcn3620"; |
| }; |
| |
| &wcnss_mem { |
| status = "okay"; |
| }; |
| |
| &tlmm { |
| gpio_keys_default: gpio-keys-default-state { |
| pins = "gpio107"; |
| function = "gpio"; |
| drive-strength = <2>; |
| bias-pull-up; |
| }; |
| |
| headphones_switch_default: headphones-switch-default-state { |
| pins = "gpio120"; |
| function = "gpio"; |
| drive-strength = <2>; |
| bias-disable; |
| }; |
| |
| touchscreen_default: touchscreen-default-state { |
| touchscreen-pins { |
| pins = "gpio13"; |
| function = "gpio"; |
| drive-strength = <2>; |
| bias-pull-up; |
| }; |
| |
| reset-pins { |
| pins = "gpio12"; |
| function = "gpio"; |
| drive-strength = <2>; |
| bias-disable; |
| }; |
| }; |
| }; |
| |
| &pm8916_mpps { |
| pwm_out: mpp4-state { |
| pins = "mpp4"; |
| function = "digital"; |
| power-source = <PM8916_MPP_VPH>; |
| output-low; |
| qcom,dtest = <1>; |
| }; |
| }; |