blob: 39f3e6cbba3d500ff57a47853ced3939c1c8ddd4 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0
/*
* Device Tree Source for the V3M Starter Kit board
*
* Copyright (C) 2017 Renesas Electronics Corp.
* Copyright (C) 2017 Cogent Embedded, Inc.
*/
/dts-v1/;
#include "r8a77970.dtsi"
#include <dt-bindings/gpio/gpio.h>
/ {
model = "Renesas V3M Starter Kit board";
compatible = "renesas,v3msk", "renesas,r8a77970";
aliases {
serial0 = &scif0;
};
chosen {
stdout-path = "serial0:115200n8";
};
hdmi-out {
compatible = "hdmi-connector";
type = "a";
port {
hdmi_con: endpoint {
remote-endpoint = <&adv7511_out>;
};
};
};
lvds-decoder {
compatible = "thine,thc63lvd1024";
vcc-supply = <&vcc_d3_3v>;
ports {
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
thc63lvd1024_in: endpoint {
remote-endpoint = <&lvds0_out>;
};
};
port@2 {
reg = <2>;
thc63lvd1024_out: endpoint {
remote-endpoint = <&adv7511_in>;
};
};
};
};
memory@48000000 {
device_type = "memory";
/* first 128MB is reserved for secure area. */
reg = <0x0 0x48000000 0x0 0x78000000>;
};
osc5_clk: osc5-clock {
compatible = "fixed-clock";
#clock-cells = <0>;
clock-frequency = <148500000>;
};
vcc_d1_8v: regulator-0 {
compatible = "regulator-fixed";
regulator-name = "VCC_D1.8V";
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
regulator-boot-on;
regulator-always-on;
};
vcc_d3_3v: regulator-1 {
compatible = "regulator-fixed";
regulator-name = "VCC_D3.3V";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-boot-on;
regulator-always-on;
};
vcc_vddq_vin0: regulator-2 {
compatible = "regulator-fixed";
regulator-name = "VCC_VDDQ_VIN0";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
regulator-boot-on;
regulator-always-on;
};
};
&avb {
pinctrl-0 = <&avb_pins>;
pinctrl-names = "default";
renesas,no-ether-link;
phy-handle = <&phy0>;
rx-internal-delay-ps = <1800>;
tx-internal-delay-ps = <2000>;
status = "okay";
phy0: ethernet-phy@0 {
compatible = "ethernet-phy-id0022.1622",
"ethernet-phy-ieee802.3-c22";
rxc-skew-ps = <1500>;
reg = <0>;
interrupt-parent = <&gpio1>;
interrupts = <17 IRQ_TYPE_LEVEL_LOW>;
reset-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
};
};
&du {
clocks = <&cpg CPG_MOD 724>,
<&osc5_clk>;
clock-names = "du.0", "dclkin.0";
status = "okay";
};
&extal_clk {
clock-frequency = <16666666>;
};
&extalr_clk {
clock-frequency = <32768>;
};
&i2c0 {
pinctrl-0 = <&i2c0_pins>;
pinctrl-names = "default";
status = "okay";
clock-frequency = <400000>;
hdmi@39{
compatible = "adi,adv7511w";
#sound-dai-cells = <0>;
reg = <0x39>;
interrupt-parent = <&gpio1>;
interrupts = <20 IRQ_TYPE_LEVEL_LOW>;
avdd-supply = <&vcc_d1_8v>;
dvdd-supply = <&vcc_d1_8v>;
pvdd-supply = <&vcc_d1_8v>;
bgvdd-supply = <&vcc_d1_8v>;
dvdd-3v-supply = <&vcc_d3_3v>;
adi,input-depth = <8>;
adi,input-colorspace = "rgb";
adi,input-clock = "1x";
ports {
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
adv7511_in: endpoint {
remote-endpoint = <&thc63lvd1024_out>;
};
};
port@1 {
reg = <1>;
adv7511_out: endpoint {
remote-endpoint = <&hdmi_con>;
};
};
};
};
};
&lvds0 {
status = "okay";
ports {
port@1 {
lvds0_out: endpoint {
remote-endpoint = <&thc63lvd1024_in>;
};
};
};
};
&mmc0 {
pinctrl-0 = <&mmc_pins>;
pinctrl-names = "default";
vmmc-supply = <&vcc_d3_3v>;
vqmmc-supply = <&vcc_vddq_vin0>;
bus-width = <8>;
non-removable;
status = "okay";
};
&pfc {
avb_pins: avb0 {
groups = "avb0_mdio", "avb0_rgmii", "avb0_txcrefclk";
function = "avb0";
};
i2c0_pins: i2c0 {
groups = "i2c0";
function = "i2c0";
};
mmc_pins: mmc_3_3v {
groups = "mmc_data8", "mmc_ctrl";
function = "mmc";
power-source = <3300>;
};
qspi0_pins: qspi0 {
groups = "qspi0_ctrl", "qspi0_data4";
function = "qspi0";
};
scif0_pins: scif0 {
groups = "scif0_data";
function = "scif0";
};
};
&rpc {
pinctrl-0 = <&qspi0_pins>;
pinctrl-names = "default";
status = "okay";
flash@0 {
compatible = "spansion,s25fs512s", "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <50000000>;
spi-rx-bus-width = <4>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
bootparam@0 {
reg = <0x00000000 0x040000>;
read-only;
};
cr7@40000 {
reg = <0x00040000 0x080000>;
read-only;
};
cert_header_sa3@c0000 {
reg = <0x000c0000 0x080000>;
read-only;
};
bl2@140000 {
reg = <0x00140000 0x040000>;
read-only;
};
cert_header_sa6@180000 {
reg = <0x00180000 0x040000>;
read-only;
};
bl31@1c0000 {
reg = <0x001c0000 0x460000>;
read-only;
};
uboot@640000 {
reg = <0x00640000 0x0c0000>;
read-only;
};
uboot-env@700000 {
reg = <0x00700000 0x040000>;
read-only;
};
dtb@740000 {
reg = <0x00740000 0x080000>;
};
kernel@7c0000 {
reg = <0x007c0000 0x1400000>;
};
user@1bc0000 {
reg = <0x01bc0000 0x2440000>;
};
};
};
};
&scif0 {
pinctrl-0 = <&scif0_pins>;
pinctrl-names = "default";
status = "okay";
};