| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * Qualcomm ICE (Inline Crypto Engine) support. |
| * |
| * Copyright (c) 2014-2019, The Linux Foundation. All rights reserved. |
| * Copyright 2019 Google LLC |
| */ |
| |
| #include <linux/platform_device.h> |
| #include <linux/qcom_scm.h> |
| |
| #include "ufshcd-crypto.h" |
| #include "ufs-qcom.h" |
| |
| #define AES_256_XTS_KEY_SIZE 64 |
| |
| /* QCOM ICE registers */ |
| |
| #define QCOM_ICE_REG_CONTROL 0x0000 |
| #define QCOM_ICE_REG_RESET 0x0004 |
| #define QCOM_ICE_REG_VERSION 0x0008 |
| #define QCOM_ICE_REG_FUSE_SETTING 0x0010 |
| #define QCOM_ICE_REG_PARAMETERS_1 0x0014 |
| #define QCOM_ICE_REG_PARAMETERS_2 0x0018 |
| #define QCOM_ICE_REG_PARAMETERS_3 0x001C |
| #define QCOM_ICE_REG_PARAMETERS_4 0x0020 |
| #define QCOM_ICE_REG_PARAMETERS_5 0x0024 |
| |
| /* QCOM ICE v3.X only */ |
| #define QCOM_ICE_GENERAL_ERR_STTS 0x0040 |
| #define QCOM_ICE_INVALID_CCFG_ERR_STTS 0x0030 |
| #define QCOM_ICE_GENERAL_ERR_MASK 0x0044 |
| |
| /* QCOM ICE v2.X only */ |
| #define QCOM_ICE_REG_NON_SEC_IRQ_STTS 0x0040 |
| #define QCOM_ICE_REG_NON_SEC_IRQ_MASK 0x0044 |
| |
| #define QCOM_ICE_REG_NON_SEC_IRQ_CLR 0x0048 |
| #define QCOM_ICE_REG_STREAM1_ERROR_SYNDROME1 0x0050 |
| #define QCOM_ICE_REG_STREAM1_ERROR_SYNDROME2 0x0054 |
| #define QCOM_ICE_REG_STREAM2_ERROR_SYNDROME1 0x0058 |
| #define QCOM_ICE_REG_STREAM2_ERROR_SYNDROME2 0x005C |
| #define QCOM_ICE_REG_STREAM1_BIST_ERROR_VEC 0x0060 |
| #define QCOM_ICE_REG_STREAM2_BIST_ERROR_VEC 0x0064 |
| #define QCOM_ICE_REG_STREAM1_BIST_FINISH_VEC 0x0068 |
| #define QCOM_ICE_REG_STREAM2_BIST_FINISH_VEC 0x006C |
| #define QCOM_ICE_REG_BIST_STATUS 0x0070 |
| #define QCOM_ICE_REG_BYPASS_STATUS 0x0074 |
| #define QCOM_ICE_REG_ADVANCED_CONTROL 0x1000 |
| #define QCOM_ICE_REG_ENDIAN_SWAP 0x1004 |
| #define QCOM_ICE_REG_TEST_BUS_CONTROL 0x1010 |
| #define QCOM_ICE_REG_TEST_BUS_REG 0x1014 |
| |
| /* BIST ("built-in self-test"?) status flags */ |
| #define QCOM_ICE_BIST_STATUS_MASK 0xF0000000 |
| |
| #define QCOM_ICE_FUSE_SETTING_MASK 0x1 |
| #define QCOM_ICE_FORCE_HW_KEY0_SETTING_MASK 0x2 |
| #define QCOM_ICE_FORCE_HW_KEY1_SETTING_MASK 0x4 |
| |
| #define qcom_ice_writel(host, val, reg) \ |
| writel((val), (host)->ice_mmio + (reg)) |
| #define qcom_ice_readl(host, reg) \ |
| readl((host)->ice_mmio + (reg)) |
| |
| static bool qcom_ice_supported(struct ufs_qcom_host *host) |
| { |
| struct device *dev = host->hba->dev; |
| u32 regval = qcom_ice_readl(host, QCOM_ICE_REG_VERSION); |
| int major = regval >> 24; |
| int minor = (regval >> 16) & 0xFF; |
| int step = regval & 0xFFFF; |
| |
| /* For now this driver only supports ICE version 3. */ |
| if (major != 3) { |
| dev_warn(dev, "Unsupported ICE version: v%d.%d.%d\n", |
| major, minor, step); |
| return false; |
| } |
| |
| dev_info(dev, "Found QC Inline Crypto Engine (ICE) v%d.%d.%d\n", |
| major, minor, step); |
| |
| /* If fuses are blown, ICE might not work in the standard way. */ |
| regval = qcom_ice_readl(host, QCOM_ICE_REG_FUSE_SETTING); |
| if (regval & (QCOM_ICE_FUSE_SETTING_MASK | |
| QCOM_ICE_FORCE_HW_KEY0_SETTING_MASK | |
| QCOM_ICE_FORCE_HW_KEY1_SETTING_MASK)) { |
| dev_warn(dev, "Fuses are blown; ICE is unusable!\n"); |
| return false; |
| } |
| return true; |
| } |
| |
| int ufs_qcom_ice_init(struct ufs_qcom_host *host) |
| { |
| struct ufs_hba *hba = host->hba; |
| struct device *dev = hba->dev; |
| struct platform_device *pdev = to_platform_device(dev); |
| struct resource *res; |
| int err; |
| |
| if (!(ufshcd_readl(hba, REG_CONTROLLER_CAPABILITIES) & |
| MASK_CRYPTO_SUPPORT)) |
| return 0; |
| |
| res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "ice"); |
| if (!res) { |
| dev_warn(dev, "ICE registers not found\n"); |
| goto disable; |
| } |
| |
| if (!qcom_scm_ice_available()) { |
| dev_warn(dev, "ICE SCM interface not found\n"); |
| goto disable; |
| } |
| |
| host->ice_mmio = devm_ioremap_resource(dev, res); |
| if (IS_ERR(host->ice_mmio)) { |
| err = PTR_ERR(host->ice_mmio); |
| dev_err(dev, "Failed to map ICE registers; err=%d\n", err); |
| return err; |
| } |
| |
| if (!qcom_ice_supported(host)) |
| goto disable; |
| |
| return 0; |
| |
| disable: |
| dev_warn(dev, "Disabling inline encryption support\n"); |
| hba->caps &= ~UFSHCD_CAP_CRYPTO; |
| return 0; |
| } |
| |
| static void qcom_ice_low_power_mode_enable(struct ufs_qcom_host *host) |
| { |
| u32 regval; |
| |
| regval = qcom_ice_readl(host, QCOM_ICE_REG_ADVANCED_CONTROL); |
| /* |
| * Enable low power mode sequence |
| * [0]-0, [1]-0, [2]-0, [3]-E, [4]-0, [5]-0, [6]-0, [7]-0 |
| */ |
| regval |= 0x7000; |
| qcom_ice_writel(host, regval, QCOM_ICE_REG_ADVANCED_CONTROL); |
| } |
| |
| static void qcom_ice_optimization_enable(struct ufs_qcom_host *host) |
| { |
| u32 regval; |
| |
| /* ICE Optimizations Enable Sequence */ |
| regval = qcom_ice_readl(host, QCOM_ICE_REG_ADVANCED_CONTROL); |
| regval |= 0xD807100; |
| /* ICE HPG requires delay before writing */ |
| udelay(5); |
| qcom_ice_writel(host, regval, QCOM_ICE_REG_ADVANCED_CONTROL); |
| udelay(5); |
| } |
| |
| int ufs_qcom_ice_enable(struct ufs_qcom_host *host) |
| { |
| if (!(host->hba->caps & UFSHCD_CAP_CRYPTO)) |
| return 0; |
| qcom_ice_low_power_mode_enable(host); |
| qcom_ice_optimization_enable(host); |
| return ufs_qcom_ice_resume(host); |
| } |
| |
| /* Poll until all BIST bits are reset */ |
| static int qcom_ice_wait_bist_status(struct ufs_qcom_host *host) |
| { |
| int count; |
| u32 reg; |
| |
| for (count = 0; count < 100; count++) { |
| reg = qcom_ice_readl(host, QCOM_ICE_REG_BIST_STATUS); |
| if (!(reg & QCOM_ICE_BIST_STATUS_MASK)) |
| break; |
| udelay(50); |
| } |
| if (reg) |
| return -ETIMEDOUT; |
| return 0; |
| } |
| |
| int ufs_qcom_ice_resume(struct ufs_qcom_host *host) |
| { |
| int err; |
| |
| if (!(host->hba->caps & UFSHCD_CAP_CRYPTO)) |
| return 0; |
| |
| err = qcom_ice_wait_bist_status(host); |
| if (err) { |
| dev_err(host->hba->dev, "BIST status error (%d)\n", err); |
| return err; |
| } |
| return 0; |
| } |
| |
| /* |
| * Program a key into a QC ICE keyslot, or evict a keyslot. QC ICE requires |
| * vendor-specific SCM calls for this; it doesn't support the standard way. |
| */ |
| int ufs_qcom_ice_program_key(struct ufs_hba *hba, |
| const union ufs_crypto_cfg_entry *cfg, int slot) |
| { |
| union ufs_crypto_cap_entry cap; |
| union { |
| u8 bytes[AES_256_XTS_KEY_SIZE]; |
| u32 words[AES_256_XTS_KEY_SIZE / sizeof(u32)]; |
| } key; |
| int i; |
| int err; |
| |
| if (!(cfg->config_enable & UFS_CRYPTO_CONFIGURATION_ENABLE)) |
| return qcom_scm_ice_invalidate_key(slot); |
| |
| /* Only AES-256-XTS has been tested so far. */ |
| cap = hba->crypto_cap_array[cfg->crypto_cap_idx]; |
| if (cap.algorithm_id != UFS_CRYPTO_ALG_AES_XTS || |
| cap.key_size != UFS_CRYPTO_KEY_SIZE_256) { |
| dev_err_ratelimited(hba->dev, |
| "Unhandled crypto capability; algorithm_id=%d, key_size=%d\n", |
| cap.algorithm_id, cap.key_size); |
| return -EINVAL; |
| } |
| |
| memcpy(key.bytes, cfg->crypto_key, AES_256_XTS_KEY_SIZE); |
| |
| /* |
| * The SCM call byte-swaps the 32-bit words of the key. So we have to |
| * do the same, in order for the final key be correct. |
| */ |
| for (i = 0; i < ARRAY_SIZE(key.words); i++) |
| __cpu_to_be32s(&key.words[i]); |
| |
| err = qcom_scm_ice_set_key(slot, key.bytes, AES_256_XTS_KEY_SIZE, |
| QCOM_SCM_ICE_CIPHER_AES_256_XTS, |
| cfg->data_unit_size); |
| memzero_explicit(&key, sizeof(key)); |
| return err; |
| } |