| /* SPDX-License-Identifier: GPL-2.0-only */ |
| /* |
| * Copyright (c) 2013, Sony Mobile Communications AB. |
| */ |
| #ifndef __PINCTRL_MSM_H__ |
| #define __PINCTRL_MSM_H__ |
| |
| #include <linux/pm.h> |
| #include <linux/types.h> |
| |
| #include <linux/pinctrl/pinctrl.h> |
| |
| struct platform_device; |
| |
| struct pinctrl_pin_desc; |
| |
| #define APQ_PIN_FUNCTION(fname) \ |
| [APQ_MUX_##fname] = PINCTRL_PINFUNCTION(#fname, \ |
| fname##_groups, \ |
| ARRAY_SIZE(fname##_groups)) |
| |
| #define IPQ_PIN_FUNCTION(fname) \ |
| [IPQ_MUX_##fname] = PINCTRL_PINFUNCTION(#fname, \ |
| fname##_groups, \ |
| ARRAY_SIZE(fname##_groups)) |
| |
| #define MSM_PIN_FUNCTION(fname) \ |
| [msm_mux_##fname] = PINCTRL_PINFUNCTION(#fname, \ |
| fname##_groups, \ |
| ARRAY_SIZE(fname##_groups)) |
| |
| #define QCA_PIN_FUNCTION(fname) \ |
| [qca_mux_##fname] = PINCTRL_PINFUNCTION(#fname, \ |
| fname##_groups, \ |
| ARRAY_SIZE(fname##_groups)) |
| |
| /** |
| * struct msm_pingroup - Qualcomm pingroup definition |
| * @grp: Generic data of the pin group (name and pins) |
| * @funcs: A list of pinmux functions that can be selected for |
| * this group. The index of the selected function is used |
| * for programming the function selector. |
| * Entries should be indices into the groups list of the |
| * struct msm_pinctrl_soc_data. |
| * @ctl_reg: Offset of the register holding control bits for this group. |
| * @io_reg: Offset of the register holding input/output bits for this group. |
| * @intr_cfg_reg: Offset of the register holding interrupt configuration bits. |
| * @intr_status_reg: Offset of the register holding the status bits for this group. |
| * @intr_target_reg: Offset of the register specifying routing of the interrupts |
| * from this group. |
| * @mux_bit: Offset in @ctl_reg for the pinmux function selection. |
| * @pull_bit: Offset in @ctl_reg for the bias configuration. |
| * @drv_bit: Offset in @ctl_reg for the drive strength configuration. |
| * @od_bit: Offset in @ctl_reg for controlling open drain. |
| * @oe_bit: Offset in @ctl_reg for controlling output enable. |
| * @in_bit: Offset in @io_reg for the input bit value. |
| * @out_bit: Offset in @io_reg for the output bit value. |
| * @intr_enable_bit: Offset in @intr_cfg_reg for enabling the interrupt for this group. |
| * @intr_status_bit: Offset in @intr_status_reg for reading and acking the interrupt |
| * status. |
| * @intr_wakeup_present_bit: Offset in @intr_target_reg specifying the GPIO can generate |
| * wakeup events. |
| * @intr_wakeup_enable_bit: Offset in @intr_target_reg to enable wakeup events for the GPIO. |
| * @intr_target_bit: Offset in @intr_target_reg for configuring the interrupt routing. |
| * @intr_target_width: Number of bits used for specifying interrupt routing target. |
| * @intr_target_kpss_val: Value in @intr_target_bit for specifying that the interrupt from |
| * this gpio should get routed to the KPSS processor. |
| * @intr_raw_status_bit: Offset in @intr_cfg_reg for the raw status bit. |
| * @intr_polarity_bit: Offset in @intr_cfg_reg for specifying polarity of the interrupt. |
| * @intr_detection_bit: Offset in @intr_cfg_reg for specifying interrupt type. |
| * @intr_detection_width: Number of bits used for specifying interrupt type, |
| * Should be 2 for SoCs that can detect both edges in hardware, |
| * otherwise 1. |
| */ |
| struct msm_pingroup { |
| struct pingroup grp; |
| |
| unsigned *funcs; |
| unsigned nfuncs; |
| |
| u32 ctl_reg; |
| u32 io_reg; |
| u32 intr_cfg_reg; |
| u32 intr_status_reg; |
| u32 intr_target_reg; |
| |
| unsigned int tile:2; |
| |
| unsigned mux_bit:5; |
| |
| unsigned pull_bit:5; |
| unsigned drv_bit:5; |
| unsigned i2c_pull_bit:5; |
| |
| unsigned od_bit:5; |
| unsigned egpio_enable:5; |
| unsigned egpio_present:5; |
| unsigned oe_bit:5; |
| unsigned in_bit:5; |
| unsigned out_bit:5; |
| |
| unsigned intr_enable_bit:5; |
| unsigned intr_status_bit:5; |
| unsigned intr_ack_high:1; |
| |
| unsigned intr_wakeup_present_bit:5; |
| unsigned intr_wakeup_enable_bit:5; |
| unsigned intr_target_bit:5; |
| unsigned intr_target_width:5; |
| unsigned intr_target_kpss_val:5; |
| unsigned intr_raw_status_bit:5; |
| unsigned intr_polarity_bit:5; |
| unsigned intr_detection_bit:5; |
| unsigned intr_detection_width:5; |
| }; |
| |
| /** |
| * struct msm_gpio_wakeirq_map - Map of GPIOs and their wakeup pins |
| * @gpio: The GPIOs that are wakeup capable |
| * @wakeirq: The interrupt at the always-on interrupt controller |
| */ |
| struct msm_gpio_wakeirq_map { |
| unsigned int gpio; |
| unsigned int wakeirq; |
| }; |
| |
| /** |
| * struct msm_pinctrl_soc_data - Qualcomm pin controller driver configuration |
| * @pins: An array describing all pins the pin controller affects. |
| * @npins: The number of entries in @pins. |
| * @functions: An array describing all mux functions the SoC supports. |
| * @nfunctions: The number of entries in @functions. |
| * @groups: An array describing all pin groups the pin SoC supports. |
| * @ngroups: The numbmer of entries in @groups. |
| * @ngpio: The number of pingroups the driver should expose as GPIOs. |
| * @pull_no_keeper: The SoC does not support keeper bias. |
| * @wakeirq_map: The map of wakeup capable GPIOs and the pin at PDC/MPM |
| * @nwakeirq_map: The number of entries in @wakeirq_map |
| * @wakeirq_dual_edge_errata: If true then GPIOs using the wakeirq_map need |
| * to be aware that their parent can't handle dual |
| * edge interrupts. |
| * @gpio_func: Which function number is GPIO (usually 0). |
| * @egpio_func: If non-zero then this SoC supports eGPIO. Even though in |
| * hardware this is a mux 1-level above the TLMM, we'll treat |
| * it as if this is just another mux state of the TLMM. Since |
| * it doesn't really map to hardware, we'll allocate a virtual |
| * function number for eGPIO and any time we see that function |
| * number used we'll treat it as a request to mux away from |
| * our TLMM towards another owner. |
| */ |
| struct msm_pinctrl_soc_data { |
| const struct pinctrl_pin_desc *pins; |
| unsigned npins; |
| const struct pinfunction *functions; |
| unsigned nfunctions; |
| const struct msm_pingroup *groups; |
| unsigned ngroups; |
| unsigned ngpios; |
| bool pull_no_keeper; |
| const char *const *tiles; |
| unsigned int ntiles; |
| const int *reserved_gpios; |
| const struct msm_gpio_wakeirq_map *wakeirq_map; |
| unsigned int nwakeirq_map; |
| bool wakeirq_dual_edge_errata; |
| unsigned int gpio_func; |
| unsigned int egpio_func; |
| }; |
| |
| extern const struct dev_pm_ops msm_pinctrl_dev_pm_ops; |
| |
| int msm_pinctrl_probe(struct platform_device *pdev, |
| const struct msm_pinctrl_soc_data *soc_data); |
| void msm_pinctrl_remove(struct platform_device *pdev); |
| |
| #endif |
