| /* |
| * Watchdog driver for SiByte SB1 SoCs |
| * |
| * Copyright (C) 2007 OnStor, Inc. * Andrew Sharp <andy.sharp@lsi.com> |
| * |
| * This driver is intended to make the second of two hardware watchdogs |
| * on the Sibyte 12XX and 11XX SoCs available to the user. There are two |
| * such devices available on the SoC, but it seems that there isn't an |
| * enumeration class for watchdogs in Linux like there is for RTCs. |
| * The second is used rather than the first because it uses IRQ 1, |
| * thereby avoiding all that IRQ 0 problematic nonsense. |
| * |
| * I have not tried this driver on a 1480 processor; it might work |
| * just well enough to really screw things up. |
| * |
| * It is a simple timer, and there is an interrupt that is raised the |
| * first time the timer expires. The second time it expires, the chip |
| * is reset and there is no way to redirect that NMI. Which could |
| * be problematic in some cases where this chip is sitting on the HT |
| * bus and has just taken responsibility for providing a cache block. |
| * Since the reset can't be redirected to the external reset pin, it is |
| * possible that other HT connected processors might hang and not reset. |
| * For Linux, a soft reset would probably be even worse than a hard reset. |
| * There you have it. |
| * |
| * The timer takes 23 bits of a 64 bit register (?) as a count value, |
| * and decrements the count every microsecond, for a max value of |
| * 0x7fffff usec or about 8.3ish seconds. |
| * |
| * This watchdog borrows some user semantics from the softdog driver, |
| * in that if you close the fd, it leaves the watchdog running, unless |
| * you previously wrote a 'V' to the fd, in which case it disables |
| * the watchdog when you close the fd like some other drivers. |
| * |
| * Based on various other watchdog drivers, which are probably all |
| * loosely based on something Alan Cox wrote years ago. |
| * |
| * (c) Copyright 1996 Alan Cox <alan@lxorguk.ukuu.org.uk>, |
| * All Rights Reserved. |
| * |
| * This program is free software; you can redistribute it and/or |
| * modify it under the terms of the GNU General Public License |
| * version 1 or 2 as published by the Free Software Foundation. |
| * |
| */ |
| |
| #define pr_fmt(fmt) KBUILD_MODNAME ": " fmt |
| |
| #include <linux/module.h> |
| #include <linux/io.h> |
| #include <linux/uaccess.h> |
| #include <linux/fs.h> |
| #include <linux/reboot.h> |
| #include <linux/miscdevice.h> |
| #include <linux/watchdog.h> |
| #include <linux/interrupt.h> |
| |
| #include <asm/sibyte/sb1250.h> |
| #include <asm/sibyte/sb1250_regs.h> |
| #include <asm/sibyte/sb1250_int.h> |
| #include <asm/sibyte/sb1250_scd.h> |
| |
| static DEFINE_SPINLOCK(sbwd_lock); |
| |
| /* |
| * set the initial count value of a timer |
| * |
| * wdog is the iomem address of the cfg register |
| */ |
| static void sbwdog_set(char __iomem *wdog, unsigned long t) |
| { |
| spin_lock(&sbwd_lock); |
| __raw_writeb(0, wdog); |
| __raw_writeq(t & 0x7fffffUL, wdog - 0x10); |
| spin_unlock(&sbwd_lock); |
| } |
| |
| /* |
| * cause the timer to [re]load it's initial count and start counting |
| * all over again |
| * |
| * wdog is the iomem address of the cfg register |
| */ |
| static void sbwdog_pet(char __iomem *wdog) |
| { |
| spin_lock(&sbwd_lock); |
| __raw_writeb(__raw_readb(wdog) | 1, wdog); |
| spin_unlock(&sbwd_lock); |
| } |
| |
| static unsigned long sbwdog_gate; /* keeps it to one thread only */ |
| static char __iomem *kern_dog = (char __iomem *)(IO_BASE + (A_SCD_WDOG_CFG_0)); |
| static char __iomem *user_dog = (char __iomem *)(IO_BASE + (A_SCD_WDOG_CFG_1)); |
| static unsigned long timeout = 0x7fffffUL; /* useconds: 8.3ish secs. */ |
| static int expect_close; |
| |
| static const struct watchdog_info ident = { |
| .options = WDIOF_CARDRESET | WDIOF_SETTIMEOUT | |
| WDIOF_KEEPALIVEPING | WDIOF_MAGICCLOSE, |
| .identity = "SiByte Watchdog", |
| }; |
| |
| /* |
| * Allow only a single thread to walk the dog |
| */ |
| static int sbwdog_open(struct inode *inode, struct file *file) |
| { |
| stream_open(inode, file); |
| if (test_and_set_bit(0, &sbwdog_gate)) |
| return -EBUSY; |
| __module_get(THIS_MODULE); |
| |
| /* |
| * Activate the timer |
| */ |
| sbwdog_set(user_dog, timeout); |
| __raw_writeb(1, user_dog); |
| |
| return 0; |
| } |
| |
| /* |
| * Put the dog back in the kennel. |
| */ |
| static int sbwdog_release(struct inode *inode, struct file *file) |
| { |
| if (expect_close == 42) { |
| __raw_writeb(0, user_dog); |
| module_put(THIS_MODULE); |
| } else { |
| pr_crit("%s: Unexpected close, not stopping watchdog!\n", |
| ident.identity); |
| sbwdog_pet(user_dog); |
| } |
| clear_bit(0, &sbwdog_gate); |
| expect_close = 0; |
| |
| return 0; |
| } |
| |
| /* |
| * 42 - the answer |
| */ |
| static ssize_t sbwdog_write(struct file *file, const char __user *data, |
| size_t len, loff_t *ppos) |
| { |
| int i; |
| |
| if (len) { |
| /* |
| * restart the timer |
| */ |
| expect_close = 0; |
| |
| for (i = 0; i != len; i++) { |
| char c; |
| |
| if (get_user(c, data + i)) |
| return -EFAULT; |
| if (c == 'V') |
| expect_close = 42; |
| } |
| sbwdog_pet(user_dog); |
| } |
| |
| return len; |
| } |
| |
| static long sbwdog_ioctl(struct file *file, unsigned int cmd, |
| unsigned long arg) |
| { |
| int ret = -ENOTTY; |
| unsigned long time; |
| void __user *argp = (void __user *)arg; |
| int __user *p = argp; |
| |
| switch (cmd) { |
| case WDIOC_GETSUPPORT: |
| ret = copy_to_user(argp, &ident, sizeof(ident)) ? -EFAULT : 0; |
| break; |
| |
| case WDIOC_GETSTATUS: |
| case WDIOC_GETBOOTSTATUS: |
| ret = put_user(0, p); |
| break; |
| |
| case WDIOC_KEEPALIVE: |
| sbwdog_pet(user_dog); |
| ret = 0; |
| break; |
| |
| case WDIOC_SETTIMEOUT: |
| ret = get_user(time, p); |
| if (ret) |
| break; |
| |
| time *= 1000000; |
| if (time > 0x7fffffUL) { |
| ret = -EINVAL; |
| break; |
| } |
| timeout = time; |
| sbwdog_set(user_dog, timeout); |
| sbwdog_pet(user_dog); |
| fallthrough; |
| |
| case WDIOC_GETTIMEOUT: |
| /* |
| * get the remaining count from the ... count register |
| * which is 1*8 before the config register |
| */ |
| ret = put_user((u32)__raw_readq(user_dog - 8) / 1000000, p); |
| break; |
| } |
| return ret; |
| } |
| |
| /* |
| * Notifier for system down |
| */ |
| static int sbwdog_notify_sys(struct notifier_block *this, unsigned long code, |
| void *erf) |
| { |
| if (code == SYS_DOWN || code == SYS_HALT) { |
| /* |
| * sit and sit |
| */ |
| __raw_writeb(0, user_dog); |
| __raw_writeb(0, kern_dog); |
| } |
| |
| return NOTIFY_DONE; |
| } |
| |
| static const struct file_operations sbwdog_fops = { |
| .owner = THIS_MODULE, |
| .write = sbwdog_write, |
| .unlocked_ioctl = sbwdog_ioctl, |
| .compat_ioctl = compat_ptr_ioctl, |
| .open = sbwdog_open, |
| .release = sbwdog_release, |
| }; |
| |
| static struct miscdevice sbwdog_miscdev = { |
| .minor = WATCHDOG_MINOR, |
| .name = "watchdog", |
| .fops = &sbwdog_fops, |
| }; |
| |
| static struct notifier_block sbwdog_notifier = { |
| .notifier_call = sbwdog_notify_sys, |
| }; |
| |
| /* |
| * interrupt handler |
| * |
| * doesn't do a whole lot for user, but oh so cleverly written so kernel |
| * code can use it to re-up the watchdog, thereby saving the kernel from |
| * having to create and maintain a timer, just to tickle another timer, |
| * which is just so wrong. |
| */ |
| irqreturn_t sbwdog_interrupt(int irq, void *addr) |
| { |
| unsigned long wd_init; |
| char *wd_cfg_reg = (char *)addr; |
| u8 cfg; |
| |
| cfg = __raw_readb(wd_cfg_reg); |
| wd_init = __raw_readq(wd_cfg_reg - 8) & 0x7fffff; |
| |
| /* |
| * if it's the second watchdog timer, it's for those users |
| */ |
| if (wd_cfg_reg == user_dog) |
| pr_crit("%s in danger of initiating system reset " |
| "in %ld.%01ld seconds\n", |
| ident.identity, |
| wd_init / 1000000, (wd_init / 100000) % 10); |
| else |
| cfg |= 1; |
| |
| __raw_writeb(cfg, wd_cfg_reg); |
| |
| return IRQ_HANDLED; |
| } |
| |
| static int __init sbwdog_init(void) |
| { |
| int ret; |
| |
| /* |
| * register a reboot notifier |
| */ |
| ret = register_reboot_notifier(&sbwdog_notifier); |
| if (ret) { |
| pr_err("%s: cannot register reboot notifier (err=%d)\n", |
| ident.identity, ret); |
| return ret; |
| } |
| |
| /* |
| * get the resources |
| */ |
| |
| ret = request_irq(1, sbwdog_interrupt, IRQF_SHARED, |
| ident.identity, (void *)user_dog); |
| if (ret) { |
| pr_err("%s: failed to request irq 1 - %d\n", |
| ident.identity, ret); |
| goto out; |
| } |
| |
| ret = misc_register(&sbwdog_miscdev); |
| if (ret == 0) { |
| pr_info("%s: timeout is %ld.%ld secs\n", |
| ident.identity, |
| timeout / 1000000, (timeout / 100000) % 10); |
| return 0; |
| } |
| free_irq(1, (void *)user_dog); |
| out: |
| unregister_reboot_notifier(&sbwdog_notifier); |
| |
| return ret; |
| } |
| |
| static void __exit sbwdog_exit(void) |
| { |
| misc_deregister(&sbwdog_miscdev); |
| free_irq(1, (void *)user_dog); |
| unregister_reboot_notifier(&sbwdog_notifier); |
| } |
| |
| module_init(sbwdog_init); |
| module_exit(sbwdog_exit); |
| |
| MODULE_AUTHOR("Andrew Sharp <andy.sharp@lsi.com>"); |
| MODULE_DESCRIPTION("SiByte Watchdog"); |
| |
| module_param(timeout, ulong, 0); |
| MODULE_PARM_DESC(timeout, |
| "Watchdog timeout in microseconds (max/default 8388607 or 8.3ish secs)"); |
| |
| MODULE_LICENSE("GPL"); |
| |
| /* |
| * example code that can be put in a platform code area to utilize the |
| * first watchdog timer for the kernels own purpose. |
| |
| void platform_wd_setup(void) |
| { |
| int ret; |
| |
| ret = request_irq(1, sbwdog_interrupt, IRQF_SHARED, |
| "Kernel Watchdog", IOADDR(A_SCD_WDOG_CFG_0)); |
| if (ret) { |
| pr_crit("Watchdog IRQ zero(0) failed to be requested - %d\n", ret); |
| } |
| } |
| |
| |
| */ |