| /dts-v1/; |
| |
| #include "mt7621.dtsi" |
| |
| #include <dt-bindings/gpio/gpio.h> |
| #include <dt-bindings/input/input.h> |
| |
| / { |
| compatible = "gnubee,gb-pc1", "mediatek,mt7621-soc"; |
| model = "GB-PC1"; |
| |
| memory@0 { |
| device_type = "memory"; |
| reg = <0x0 0x1c000000>, <0x20000000 0x4000000>; |
| }; |
| |
| chosen { |
| bootargs = "console=ttyS0,57600"; |
| }; |
| |
| palmbus: palmbus@1E000000 { |
| i2c@900 { |
| status = "okay"; |
| }; |
| }; |
| |
| gpio-keys { |
| compatible = "gpio-keys"; |
| |
| reset { |
| label = "reset"; |
| gpios = <&gpio 18 GPIO_ACTIVE_HIGH>; |
| linux,code = <KEY_RESTART>; |
| }; |
| }; |
| |
| gpio-leds { |
| compatible = "gpio-leds"; |
| |
| system { |
| label = "gb-pc1:green:system"; |
| gpios = <&gpio 6 GPIO_ACTIVE_LOW>; |
| }; |
| |
| status { |
| label = "gb-pc1:green:status"; |
| gpios = <&gpio 8 GPIO_ACTIVE_LOW>; |
| }; |
| |
| lan1 { |
| label = "gb-pc1:green:lan1"; |
| gpios = <&gpio 24 GPIO_ACTIVE_LOW>; |
| }; |
| |
| lan2 { |
| label = "gb-pc1:green:lan2"; |
| gpios = <&gpio 25 GPIO_ACTIVE_LOW>; |
| }; |
| }; |
| }; |
| |
| &sdhci { |
| status = "okay"; |
| }; |
| |
| &spi0 { |
| status = "okay"; |
| |
| m25p80@0 { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| compatible = "jedec,spi-nor"; |
| reg = <0>; |
| spi-max-frequency = <50000000>; |
| |
| partition@0 { |
| label = "u-boot"; |
| reg = <0x0 0x30000>; |
| read-only; |
| }; |
| |
| partition@30000 { |
| label = "u-boot-env"; |
| reg = <0x30000 0x10000>; |
| read-only; |
| }; |
| |
| factory: partition@40000 { |
| label = "factory"; |
| reg = <0x40000 0x10000>; |
| read-only; |
| }; |
| |
| partition@50000 { |
| label = "firmware"; |
| reg = <0x50000 0x1FB0000>; |
| }; |
| |
| }; |
| }; |
| |
| &sysclock { |
| compatible = "fixed-clock"; |
| /* This is normally 1/4 of cpuclock */ |
| clock-frequency = <225000000>; |
| }; |
| |
| &cpuclock { |
| compatible = "fixed-clock"; |
| clock-frequency = <900000000>; |
| }; |
| |
| &pcie { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pcie_pins>; |
| status = "okay"; |
| }; |
| |
| ðernet { |
| //mtd-mac-address = <&factory 0xe000>; |
| gmac1: mac@0 { |
| compatible = "mediatek,eth-mac"; |
| reg = <0>; |
| phy-handle = <&phy1>; |
| }; |
| |
| mdio-bus { |
| phy1: ethernet-phy@1 { |
| reg = <1>; |
| phy-mode = "rgmii"; |
| }; |
| }; |
| }; |
| |
| &pinctrl { |
| state_default: pinctrl0 { |
| gpio { |
| ralink,group = "wdt", "rgmii2", "uart3"; |
| ralink,function = "gpio"; |
| }; |
| }; |
| }; |