| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Driver for Goodix touchscreens that use the i2c-hid protocol. |
| * |
| * Copyright 2020 Google LLC |
| */ |
| |
| #include <linux/delay.h> |
| #include <linux/device.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/i2c.h> |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/of.h> |
| #include <linux/pm.h> |
| #include <linux/regulator/consumer.h> |
| |
| #include "i2c-hid.h" |
| |
| struct goodix_i2c_hid_timing_data { |
| unsigned int post_gpio_reset_delay_ms; |
| unsigned int post_power_delay_ms; |
| }; |
| |
| struct i2c_hid_of_goodix { |
| struct i2chid_ops ops; |
| |
| struct regulator *vdd; |
| struct notifier_block nb; |
| struct gpio_desc *reset_gpio; |
| const struct goodix_i2c_hid_timing_data *timings; |
| }; |
| |
| static void goodix_i2c_hid_deassert_reset(struct i2c_hid_of_goodix *ihid_goodix, |
| bool regulator_just_turned_on) |
| { |
| if (regulator_just_turned_on && ihid_goodix->timings->post_power_delay_ms) |
| msleep(ihid_goodix->timings->post_power_delay_ms); |
| |
| gpiod_set_value_cansleep(ihid_goodix->reset_gpio, 0); |
| if (ihid_goodix->timings->post_gpio_reset_delay_ms) |
| msleep(ihid_goodix->timings->post_gpio_reset_delay_ms); |
| } |
| |
| static int goodix_i2c_hid_power_up(struct i2chid_ops *ops) |
| { |
| struct i2c_hid_of_goodix *ihid_goodix = |
| container_of(ops, struct i2c_hid_of_goodix, ops); |
| |
| return regulator_enable(ihid_goodix->vdd); |
| } |
| |
| static void goodix_i2c_hid_power_down(struct i2chid_ops *ops) |
| { |
| struct i2c_hid_of_goodix *ihid_goodix = |
| container_of(ops, struct i2c_hid_of_goodix, ops); |
| |
| regulator_disable(ihid_goodix->vdd); |
| } |
| |
| static int ihid_goodix_vdd_notify(struct notifier_block *nb, |
| unsigned long event, |
| void *ignored) |
| { |
| struct i2c_hid_of_goodix *ihid_goodix = |
| container_of(nb, struct i2c_hid_of_goodix, nb); |
| int ret = NOTIFY_OK; |
| |
| switch (event) { |
| case REGULATOR_EVENT_PRE_DISABLE: |
| gpiod_set_value_cansleep(ihid_goodix->reset_gpio, 1); |
| break; |
| |
| case REGULATOR_EVENT_ENABLE: |
| goodix_i2c_hid_deassert_reset(ihid_goodix, true); |
| break; |
| |
| case REGULATOR_EVENT_ABORT_DISABLE: |
| goodix_i2c_hid_deassert_reset(ihid_goodix, false); |
| break; |
| |
| default: |
| ret = NOTIFY_DONE; |
| break; |
| } |
| |
| return ret; |
| } |
| |
| static int i2c_hid_of_goodix_probe(struct i2c_client *client) |
| { |
| struct i2c_hid_of_goodix *ihid_goodix; |
| int ret; |
| ihid_goodix = devm_kzalloc(&client->dev, sizeof(*ihid_goodix), |
| GFP_KERNEL); |
| if (!ihid_goodix) |
| return -ENOMEM; |
| |
| ihid_goodix->ops.power_up = goodix_i2c_hid_power_up; |
| ihid_goodix->ops.power_down = goodix_i2c_hid_power_down; |
| |
| /* Start out with reset asserted */ |
| ihid_goodix->reset_gpio = |
| devm_gpiod_get_optional(&client->dev, "reset", GPIOD_OUT_HIGH); |
| if (IS_ERR(ihid_goodix->reset_gpio)) |
| return PTR_ERR(ihid_goodix->reset_gpio); |
| |
| ihid_goodix->vdd = devm_regulator_get(&client->dev, "vdd"); |
| if (IS_ERR(ihid_goodix->vdd)) |
| return PTR_ERR(ihid_goodix->vdd); |
| |
| ihid_goodix->timings = device_get_match_data(&client->dev); |
| |
| /* |
| * We need to control the "reset" line in lockstep with the regulator |
| * actually turning on an off instead of just when we make the request. |
| * This matters if the regulator is shared with another consumer. |
| * - If the regulator is off then we must assert reset. The reset |
| * line is active low and on some boards it could cause a current |
| * leak if left high. |
| * - If the regulator is on then we don't want reset asserted for very |
| * long. Holding the controller in reset apparently draws extra |
| * power. |
| */ |
| ihid_goodix->nb.notifier_call = ihid_goodix_vdd_notify; |
| ret = devm_regulator_register_notifier(ihid_goodix->vdd, &ihid_goodix->nb); |
| if (ret) |
| return dev_err_probe(&client->dev, ret, |
| "regulator notifier request failed\n"); |
| |
| /* |
| * If someone else is holding the regulator on (or the regulator is |
| * an always-on one) we might never be told to deassert reset. Do it |
| * now... and temporarily bump the regulator reference count just to |
| * make sure it is impossible for this to race with our own notifier! |
| * We also assume that someone else might have _just barely_ turned |
| * the regulator on so we'll do the full "post_power_delay" just in |
| * case. |
| */ |
| if (ihid_goodix->reset_gpio && regulator_is_enabled(ihid_goodix->vdd)) { |
| ret = regulator_enable(ihid_goodix->vdd); |
| if (ret) |
| return ret; |
| goodix_i2c_hid_deassert_reset(ihid_goodix, true); |
| regulator_disable(ihid_goodix->vdd); |
| } |
| |
| return i2c_hid_core_probe(client, &ihid_goodix->ops, 0x0001, 0); |
| } |
| |
| static const struct goodix_i2c_hid_timing_data goodix_gt7375p_timing_data = { |
| .post_power_delay_ms = 10, |
| .post_gpio_reset_delay_ms = 180, |
| }; |
| |
| static const struct of_device_id goodix_i2c_hid_of_match[] = { |
| { .compatible = "goodix,gt7375p", .data = &goodix_gt7375p_timing_data }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(of, goodix_i2c_hid_of_match); |
| |
| static struct i2c_driver goodix_i2c_hid_ts_driver = { |
| .driver = { |
| .name = "i2c_hid_of_goodix", |
| .pm = &i2c_hid_core_pm, |
| .probe_type = PROBE_PREFER_ASYNCHRONOUS, |
| .of_match_table = of_match_ptr(goodix_i2c_hid_of_match), |
| }, |
| .probe_new = i2c_hid_of_goodix_probe, |
| .remove = i2c_hid_core_remove, |
| .shutdown = i2c_hid_core_shutdown, |
| }; |
| module_i2c_driver(goodix_i2c_hid_ts_driver); |
| |
| MODULE_AUTHOR("Douglas Anderson <dianders@chromium.org>"); |
| MODULE_DESCRIPTION("Goodix i2c-hid touchscreen driver"); |
| MODULE_LICENSE("GPL v2"); |