| # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) |
| %YAML 1.2 |
| --- |
| $id: http://devicetree.org/schemas/net/cdns,macb.yaml# |
| $schema: http://devicetree.org/meta-schemas/core.yaml# |
| |
| title: Cadence MACB/GEM Ethernet controller |
| |
| maintainers: |
| - Nicolas Ferre <nicolas.ferre@microchip.com> |
| - Claudiu Beznea <claudiu.beznea@microchip.com> |
| |
| properties: |
| compatible: |
| oneOf: |
| - items: |
| - enum: |
| - cdns,at91rm9200-emac # Atmel at91rm9200 SoC |
| - const: cdns,emac # Generic |
| |
| - items: |
| - enum: |
| - cdns,zynq-gem # Xilinx Zynq-7xxx SoC |
| - cdns,zynqmp-gem # Xilinx Zynq Ultrascale+ MPSoC |
| - const: cdns,gem # Generic |
| deprecated: true |
| |
| - items: |
| - enum: |
| - xlnx,versal-gem # Xilinx Versal |
| - xlnx,zynq-gem # Xilinx Zynq-7xxx SoC |
| - xlnx,zynqmp-gem # Xilinx Zynq Ultrascale+ MPSoC |
| - const: cdns,gem # Generic |
| |
| - items: |
| - enum: |
| - cdns,at91sam9260-macb # Atmel at91sam9 SoCs |
| - cdns,sam9x60-macb # Microchip sam9x60 SoC |
| - microchip,mpfs-macb # Microchip PolarFire SoC |
| - const: cdns,macb # Generic |
| |
| - items: |
| - enum: |
| - atmel,sama5d3-macb # 10/100Mbit IP on Atmel sama5d3 SoCs |
| - enum: |
| - cdns,at91sam9260-macb # Atmel at91sam9 SoCs. |
| - const: cdns,macb # Generic |
| |
| - enum: |
| - atmel,sama5d29-gem # GEM XL IP (10/100) on Atmel sama5d29 SoCs |
| - atmel,sama5d2-gem # GEM IP (10/100) on Atmel sama5d2 SoCs |
| - atmel,sama5d3-gem # Gigabit IP on Atmel sama5d3 SoCs |
| - atmel,sama5d4-gem # GEM IP (10/100) on Atmel sama5d4 SoCs |
| - cdns,np4-macb # NP4 SoC devices |
| - microchip,sama7g5-emac # Microchip SAMA7G5 ethernet interface |
| - microchip,sama7g5-gem # Microchip SAMA7G5 gigabit ethernet interface |
| - sifive,fu540-c000-gem # SiFive FU540-C000 SoC |
| - cdns,emac # Generic |
| - cdns,gem # Generic |
| - cdns,macb # Generic |
| |
| - items: |
| - enum: |
| - microchip,sam9x7-gem # Microchip SAM9X7 gigabit ethernet interface |
| - const: microchip,sama7g5-gem # Microchip SAMA7G5 gigabit ethernet interface |
| |
| reg: |
| minItems: 1 |
| items: |
| - description: Basic register set |
| - description: GEMGXL Management block registers on SiFive FU540-C000 SoC |
| |
| interrupts: |
| minItems: 1 |
| maxItems: 8 |
| description: One interrupt per available hardware queue |
| |
| clocks: |
| minItems: 1 |
| maxItems: 5 |
| |
| clock-names: |
| minItems: 1 |
| items: |
| - enum: [ ether_clk, hclk, pclk ] |
| - enum: [ hclk, pclk ] |
| - const: tx_clk |
| - enum: [ rx_clk, tsu_clk ] |
| - const: tsu_clk |
| |
| local-mac-address: true |
| |
| phy-mode: true |
| |
| phy-handle: true |
| |
| phys: |
| maxItems: 1 |
| |
| resets: |
| maxItems: 1 |
| description: |
| Recommended with ZynqMP, specify reset control for this |
| controller instance with zynqmp-reset driver. |
| |
| reset-names: |
| maxItems: 1 |
| |
| fixed-link: true |
| |
| iommus: |
| maxItems: 1 |
| |
| power-domains: |
| maxItems: 1 |
| |
| cdns,rx-watermark: |
| $ref: /schemas/types.yaml#/definitions/uint32 |
| description: |
| When the receive partial store and forward mode is activated, |
| the receiver will only begin to forward the packet to the external |
| AHB or AXI slave when enough packet data is stored in the SRAM packet buffer. |
| rx-watermark corresponds to the number of SRAM buffer locations, |
| that need to be filled, before the forwarding process is activated. |
| Width of the SRAM is platform dependent, and can be 4, 8 or 16 bytes. |
| |
| '#address-cells': |
| const: 1 |
| |
| '#size-cells': |
| const: 0 |
| |
| mdio: |
| type: object |
| description: |
| Node containing PHY children. If this node is not present, then PHYs will |
| be direct children. |
| |
| patternProperties: |
| "^ethernet-phy@[0-9a-f]$": |
| type: object |
| $ref: ethernet-phy.yaml# |
| |
| properties: |
| reset-gpios: true |
| |
| magic-packet: |
| type: boolean |
| deprecated: true |
| description: |
| Indicates that the hardware supports waking up via magic packet. |
| |
| unevaluatedProperties: false |
| |
| required: |
| - compatible |
| - reg |
| - interrupts |
| - clocks |
| - clock-names |
| - phy-mode |
| |
| allOf: |
| - $ref: ethernet-controller.yaml# |
| |
| - if: |
| not: |
| properties: |
| compatible: |
| contains: |
| const: sifive,fu540-c000-gem |
| then: |
| properties: |
| reg: |
| maxItems: 1 |
| |
| unevaluatedProperties: false |
| |
| examples: |
| - | |
| macb0: ethernet@fffc4000 { |
| compatible = "cdns,macb"; |
| reg = <0xfffc4000 0x4000>; |
| interrupts = <21>; |
| cdns,rx-watermark = <0x44>; |
| phy-mode = "rmii"; |
| local-mac-address = [3a 0e 03 04 05 06]; |
| clock-names = "pclk", "hclk", "tx_clk"; |
| clocks = <&clkc 30>, <&clkc 30>, <&clkc 13>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| ethernet-phy@1 { |
| reg = <0x1>; |
| reset-gpios = <&pioE 6 1>; |
| }; |
| }; |
| |
| - | |
| #include <dt-bindings/clock/xlnx-zynqmp-clk.h> |
| #include <dt-bindings/power/xlnx-zynqmp-power.h> |
| #include <dt-bindings/reset/xlnx-zynqmp-resets.h> |
| #include <dt-bindings/phy/phy.h> |
| |
| bus { |
| #address-cells = <2>; |
| #size-cells = <2>; |
| gem1: ethernet@ff0c0000 { |
| compatible = "xlnx,zynqmp-gem", "cdns,gem"; |
| interrupt-parent = <&gic>; |
| interrupts = <0 59 4>, <0 59 4>; |
| reg = <0x0 0xff0c0000 0x0 0x1000>; |
| clocks = <&zynqmp_clk LPD_LSBUS>, <&zynqmp_clk GEM1_REF>, |
| <&zynqmp_clk GEM1_TX>, <&zynqmp_clk GEM1_RX>, |
| <&zynqmp_clk GEM_TSU>; |
| clock-names = "pclk", "hclk", "tx_clk", "rx_clk", "tsu_clk"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| iommus = <&smmu 0x875>; |
| power-domains = <&zynqmp_firmware PD_ETH_1>; |
| resets = <&zynqmp_reset ZYNQMP_RESET_GEM1>; |
| reset-names = "gem1_rst"; |
| phy-mode = "sgmii"; |
| phys = <&psgtr 1 PHY_TYPE_SGMII 1 1>; |
| fixed-link { |
| speed = <1000>; |
| full-duplex; |
| pause; |
| }; |
| }; |
| }; |