| # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) |
| %YAML 1.2 |
| --- |
| $id: http://devicetree.org/schemas/sound/infineon,peb2466.yaml# |
| $schema: http://devicetree.org/meta-schemas/core.yaml# |
| |
| title: Infineon PEB2466 codec |
| |
| maintainers: |
| - Herve Codina <herve.codina@bootlin.com> |
| |
| description: | |
| The Infineon PEB2466 codec is a programmable DSP-based four channels codec |
| with filters capabilities. |
| |
| The time-slots used by the codec must be set and so, the properties |
| 'dai-tdm-slot-num', 'dai-tdm-slot-width', 'dai-tdm-slot-tx-mask' and |
| 'dai-tdm-slot-rx-mask' must be present in the sound card node for sub-nodes |
| that involve the codec. The codec uses one 8bit time-slot per channel. |
| 'dai-tdm-tdm-slot-with' must be set to 8. |
| |
| The PEB2466 codec also supports 28 gpios (signaling pins). |
| |
| allOf: |
| - $ref: /schemas/spi/spi-peripheral-props.yaml |
| - $ref: dai-common.yaml# |
| |
| properties: |
| compatible: |
| const: infineon,peb2466 |
| |
| reg: |
| description: |
| SPI device address. |
| maxItems: 1 |
| |
| clocks: |
| items: |
| - description: Master clock |
| |
| clock-names: |
| items: |
| - const: mclk |
| |
| spi-max-frequency: |
| maximum: 8192000 |
| |
| reset-gpios: |
| description: |
| GPIO used to reset the device. |
| maxItems: 1 |
| |
| firmware-name: |
| maxItems: 1 |
| description: |
| Filters coefficients file to load. If this property is omitted, internal |
| filters are disabled. |
| |
| '#sound-dai-cells': |
| const: 0 |
| |
| '#gpio-cells': |
| const: 2 |
| |
| gpio-controller: true |
| |
| required: |
| - compatible |
| - reg |
| - '#sound-dai-cells' |
| - gpio-controller |
| - '#gpio-cells' |
| |
| unevaluatedProperties: false |
| |
| examples: |
| - | |
| #include <dt-bindings/gpio/gpio.h> |
| spi { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| audio-codec@0 { |
| compatible = "infineon,peb2466"; |
| reg = <0>; |
| spi-max-frequency = <8192000>; |
| reset-gpios = <&gpio 10 GPIO_ACTIVE_LOW>; |
| #sound-dai-cells = <0>; |
| gpio-controller; |
| #gpio-cells = <2>; |
| }; |
| }; |