| // SPDX-License-Identifier: BSD-3-Clause |
| /* |
| * Copyright (c) 2022, Konrad Dybcio <konrad.dybcio@somainline.org> |
| * Copyright (c) 2022, Linaro Limited |
| */ |
| |
| /dts-v1/; |
| |
| #include "sm8450-sony-xperia-nagara.dtsi" |
| |
| / { |
| model = "Sony Xperia 5 IV"; |
| compatible = "sony,pdx224", "qcom,sm8450"; |
| |
| imx563_vdig_regulator: imx563-vdig-regulator { |
| compatible = "regulator-fixed"; |
| regulator-name = "imx563_vdig_regulator"; |
| gpio = <&tlmm 22 GPIO_ACTIVE_HIGH>; |
| enable-active-high; |
| |
| pinctrl-names = "default"; |
| pinctrl-0 = <&uwidec_pwr_en>; |
| }; |
| }; |
| |
| &pm8350b_gpios { |
| gpio-line-names = "CAM_PWR_A_CS", /* GPIO_1 */ |
| "NC", |
| "NC", |
| "NC", |
| "SNAPSHOT_N", |
| "NC", |
| "NC", |
| "FOCUS_N"; |
| }; |
| |
| &pm8350c_gpios { |
| gpio-line-names = "FL_STROBE_TRIG_WIDE", /* GPIO_1 */ |
| "FL_STROBE_TRIG_TELE", |
| "WLC_ID", |
| "WLC_TXPWR_EN", |
| "NC", |
| "NC", /* RGBCIR uses a PMIC vreg, so it's most likely NC. */ |
| "NC", |
| "NC", |
| "WIDEC_PWR_EN"; |
| }; |
| |
| &tlmm { |
| gpio-line-names = "TELE_SPI_MISO", /* GPIO_0 */ |
| "TELE_SPI_MOSI", /* SONY says NC, but it only makes sense this way.. */ |
| "TELE_SPI_CLK", |
| "TELE_SPI_CS_N", |
| "WLC_I2C_SDA", |
| "WLC_I2C_SCL", |
| "NC", |
| "PM8010_1_RESET_N", |
| "WLC_INT_N", |
| "NC", |
| "NC", /* GPIO_10 */ |
| "NC", |
| "DISP_ERR_FG", |
| "HALL_INT_N", |
| "ALS_PROX_INT_N", |
| "IMU1_INT", |
| "TS_I2C_SDA", |
| "TS_I2C_SCL", |
| "DISP_RESET_N", |
| "DISP_VDDR_EN", |
| "TS_RESET_N", /* GPIO_20 */ |
| "TS_INT_N", |
| "UWIDEC_PWR_EN", |
| "TELEC_PWR_EN", |
| "CAM1_RESET_N", |
| "LEO_CAM0_RESET_N", |
| "DEBUG_UART_TX", |
| "DEBUG_UART_RX", |
| "FP_SPI_MISO", |
| "FP_SPI_MOSI", |
| "FP_SPI_CLK", /* GPIO_30 */ |
| "FP_SPI_CS_N", |
| "NFC_I2C_SDA", |
| "NFC_I2C_SCL", |
| "NFC_EN", |
| "NFC_CLK_REQ", |
| "NFC_ESE_SPI_MISO", |
| "NFC_ESE_SPI_MOSI", |
| "NFC_ESE_SPI_CLK", |
| "NFC_ESE_SPI_CS", |
| "FP_INT_N", /* GPIO_40 */ |
| "NC", |
| "FP_RESET_N", |
| "WCD_RST_N", |
| "NC", |
| "NFC_DWL_REQ", |
| "NFC_IRQ", |
| "FORCE_USB_BOOT", |
| "APPS_I2C_1_SDA", |
| "APPS_I2C_1_SCL", |
| "SBU_SW_OE", /* GPIO_50 */ |
| "SBU_SW_SEL", |
| "SPK_AMP_I2C_SDA", |
| "SPK_AMP_I2C_SCL", |
| "NC", |
| "NC", |
| "CAMSENSOR_I2C_SDA", |
| "CAMSENSOR_I2C_SCL", |
| "GNSS_ELNA_EN0", |
| "NC", |
| "NC", /* GPIO_60 */ |
| "NC", |
| "NC", |
| "NC", |
| "NC", |
| "NC", |
| "RGBC_IR_INT", |
| "NC", |
| "NC", |
| "NC", |
| "NC", /* GPIO_70 */ |
| "NC", |
| "HAP_I2C_SDA", |
| "HAP_I2C_SCL", |
| "HAP_RST_N", |
| "HAP_INT_N", |
| "HST_BT_UART_CTS", |
| "HST_BT_UART_RFR", |
| "HST_BT_UART_TX", |
| "HST_BT_UART_RX", |
| "HST_WLAN_EN", /* GPIO_80 */ |
| "HST_BT_EN", |
| "HST_SW_CTRL", |
| "NC", |
| "NC", |
| "NC", |
| "DISP_VSYNC", |
| "NC", |
| "NC", |
| "HW_ID_0", |
| "HW_ID_1", /* GPIO_90 */ |
| "USB_CC_DIR", |
| "TRAY_DET", |
| "SW_SERVICE", |
| "PCIE0_RESET_N", |
| "PCIE0_CLK_REQ_N", |
| "PCIE0_WAKE_N", |
| "OIS_ENABLE_WIDE", |
| "DEBUG_GPIO0", |
| "NC", |
| "CAM_MCLK0", /* GPIO_100 */ |
| "CAM_MCLK1", |
| "CAM_MCLK2", |
| "CAM_MCLK3", |
| "NC", |
| "NC", |
| "NC", /* SONY didn't rename this, but there's no ToF so it's likely NC */ |
| "CAM_SOF", |
| "NC", |
| "AFEXPTMG_TELE", |
| "CCI_I2C0_SDA", /* GPIO_110 */ |
| "CCI_I2C0_SCL", |
| "CCI_I2C1_SDA", |
| "CCI_I2C1_SCL", |
| "CCI_I2C2_SDA", |
| "CCI_I2C2_SCL", |
| "NC", |
| "CAM2_RESET_N", |
| "NC", |
| "EXT_VD0_XVS", |
| "CAM3_RESET_N", /* GPIO_120 */ |
| "NC", |
| "NC", |
| "NC", |
| "NC", |
| "RF_ID_EXTENSION_2", |
| "HAP_I2S_CLK", |
| "HAP_I2S_DOUT", |
| "HAP_TRG1", |
| "HAP_I2S_SYNC", |
| "UIM1_DATA", /* GPIO_130 */ |
| "UIM1_CLK", |
| "UIM1_RESET", |
| "TRAY_DET", |
| "UIM2_DATA", |
| "UIM2_CLK", |
| "UIM2_RESET", |
| "UIM2_PRESENT", |
| "SM_RFFE0_CLK", |
| "SM_RFFE0_DATA", |
| "SM_RFFE1_CLK", /* GPIO_140 */ |
| "SM_RFFE1_DATA", |
| "SM_MSS_GRFC4", |
| "HST_AS_EN", |
| "LAA_RX_EN", |
| "NC", |
| "SM_RFFE4_CLK", |
| "SM_RFFE4_DATA", |
| "WLAN_COEX_UART1_RX", |
| "WLAN_COEX_UART1_TX", |
| "RF_LCD_ID_EN", /* GPIO_150 */ |
| "RF_ID_EXTENSION", |
| "SM_MSS_GRFC12", |
| "NFC_COLD_RST", |
| "NC", |
| "NC", |
| "SDR1_QLINK0_REQ", |
| "SDR1_QLINK0_EN", |
| "SDR1_QLINK0_WMSS_RESET_N", |
| "NC", |
| "NC", /* GPIO_160 */ |
| "NC", |
| "SDR2_QLINK2_REQ", |
| "SDR2_QLINK2_EN", |
| "SDR2_QLINK2_WMSS_RESET_N", |
| "WCD_SWR_TX_CLK", |
| "WCD_SWR_TX_DATA0", |
| "WCD_SWR_TX_DATA1", |
| "WCD_SWR_RX_CLK", |
| "WCD_SWR_RX_DATA0", |
| "WCD_SWR_RX_DATA1", /* GPIO_170 */ |
| "SM_DMIC1_CLK", |
| "SM_DMIC1_DATA", |
| "SM_DMIC2_CLK", |
| "SM_DMIC2_DATA", |
| "SPK_AMP_I2S_CLK", |
| "SPK_AMP_I2S_WS", |
| "NC", |
| "NC", |
| "WCD_SWR_TX_DATA2", |
| "SPK_AMP_I2S_ASP_DIN", /* GPIO_180 */ |
| "SPK_AMP_I2S_ASP_DOUT", |
| "SPK_AMP_INT_N", |
| "SPK_AMP_RESET_N", |
| "HST_BT_WLAN_SLIMBUS_CLK", |
| "HST_BT_WLAN_SLIMBUS_DAT0", |
| "NC", |
| "NC", |
| "NC", |
| "NC", |
| "MAG_I2C_SDA", /* GPIO_190 */ |
| "MAG_I2C_SCL", |
| "IMU_SPI_MISO", |
| "IMU_SPI_MOSI", |
| "IMU_SPI_CLK", |
| "IMU_SPI_CS_N", |
| "SENSOR_I2C_SDA", |
| "SENSOR_I2C_SCL", |
| "OIS_TELE_I2C_SDA", |
| "OIS_TELE_I2C_SCL", |
| "NC", /* GPIO_200 */ |
| "OIS_ENABLE_TELE", |
| "HST_BLE_UART_TX", |
| "HST_BLE_UART_RX", |
| "HSTP_CLK_CFG_SEL", |
| "NC", |
| "APPS_I2C_0_SDA", |
| "APPS_I2C_0_SCL", |
| "CCI_I2C3_SDA", |
| "CCI_I2C3_SCL"; |
| |
| uwidec_pwr_en: uwidec-pwr-en-state { |
| pins = "gpio22"; |
| function = "gpio"; |
| drive-strength = <2>; |
| bias-disable; |
| output-low; |
| }; |
| }; |
