| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * SPI controller driver for the Atheros AR71XX/AR724X/AR913X SoCs |
| * |
| * Copyright (C) 2009-2011 Gabor Juhos <juhosg@openwrt.org> |
| * |
| * This driver has been based on the spi-gpio.c: |
| * Copyright (C) 2006,2008 David Brownell |
| */ |
| |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/delay.h> |
| #include <linux/spinlock.h> |
| #include <linux/platform_device.h> |
| #include <linux/io.h> |
| #include <linux/spi/spi.h> |
| #include <linux/spi/spi-mem.h> |
| #include <linux/spi/spi_bitbang.h> |
| #include <linux/bitops.h> |
| #include <linux/clk.h> |
| #include <linux/err.h> |
| |
| #define DRV_NAME "ath79-spi" |
| |
| #define ATH79_SPI_RRW_DELAY_FACTOR 12000 |
| #define MHZ (1000 * 1000) |
| |
| #define AR71XX_SPI_REG_FS 0x00 /* Function Select */ |
| #define AR71XX_SPI_REG_CTRL 0x04 /* SPI Control */ |
| #define AR71XX_SPI_REG_IOC 0x08 /* SPI I/O Control */ |
| #define AR71XX_SPI_REG_RDS 0x0c /* Read Data Shift */ |
| |
| #define AR71XX_SPI_FS_GPIO BIT(0) /* Enable GPIO mode */ |
| |
| #define AR71XX_SPI_IOC_DO BIT(0) /* Data Out pin */ |
| #define AR71XX_SPI_IOC_CLK BIT(8) /* CLK pin */ |
| #define AR71XX_SPI_IOC_CS(n) BIT(16 + (n)) |
| |
| struct ath79_spi { |
| struct spi_bitbang bitbang; |
| u32 ioc_base; |
| u32 reg_ctrl; |
| void __iomem *base; |
| struct clk *clk; |
| unsigned int rrw_delay; |
| }; |
| |
| static inline u32 ath79_spi_rr(struct ath79_spi *sp, unsigned int reg) |
| { |
| return ioread32(sp->base + reg); |
| } |
| |
| static inline void ath79_spi_wr(struct ath79_spi *sp, unsigned int reg, u32 val) |
| { |
| iowrite32(val, sp->base + reg); |
| } |
| |
| static inline struct ath79_spi *ath79_spidev_to_sp(struct spi_device *spi) |
| { |
| return spi_controller_get_devdata(spi->controller); |
| } |
| |
| static inline void ath79_spi_delay(struct ath79_spi *sp, unsigned int nsecs) |
| { |
| if (nsecs > sp->rrw_delay) |
| ndelay(nsecs - sp->rrw_delay); |
| } |
| |
| static void ath79_spi_chipselect(struct spi_device *spi, int is_active) |
| { |
| struct ath79_spi *sp = ath79_spidev_to_sp(spi); |
| int cs_high = (spi->mode & SPI_CS_HIGH) ? is_active : !is_active; |
| u32 cs_bit = AR71XX_SPI_IOC_CS(spi_get_chipselect(spi, 0)); |
| |
| if (cs_high) |
| sp->ioc_base |= cs_bit; |
| else |
| sp->ioc_base &= ~cs_bit; |
| |
| ath79_spi_wr(sp, AR71XX_SPI_REG_IOC, sp->ioc_base); |
| } |
| |
| static void ath79_spi_enable(struct ath79_spi *sp) |
| { |
| /* enable GPIO mode */ |
| ath79_spi_wr(sp, AR71XX_SPI_REG_FS, AR71XX_SPI_FS_GPIO); |
| |
| /* save CTRL register */ |
| sp->reg_ctrl = ath79_spi_rr(sp, AR71XX_SPI_REG_CTRL); |
| sp->ioc_base = ath79_spi_rr(sp, AR71XX_SPI_REG_IOC); |
| |
| /* clear clk and mosi in the base state */ |
| sp->ioc_base &= ~(AR71XX_SPI_IOC_DO | AR71XX_SPI_IOC_CLK); |
| |
| /* TODO: setup speed? */ |
| ath79_spi_wr(sp, AR71XX_SPI_REG_CTRL, 0x43); |
| } |
| |
| static void ath79_spi_disable(struct ath79_spi *sp) |
| { |
| /* restore CTRL register */ |
| ath79_spi_wr(sp, AR71XX_SPI_REG_CTRL, sp->reg_ctrl); |
| /* disable GPIO mode */ |
| ath79_spi_wr(sp, AR71XX_SPI_REG_FS, 0); |
| } |
| |
| static u32 ath79_spi_txrx_mode0(struct spi_device *spi, unsigned int nsecs, |
| u32 word, u8 bits, unsigned flags) |
| { |
| struct ath79_spi *sp = ath79_spidev_to_sp(spi); |
| u32 ioc = sp->ioc_base; |
| |
| /* clock starts at inactive polarity */ |
| for (word <<= (32 - bits); likely(bits); bits--) { |
| u32 out; |
| |
| if (word & (1 << 31)) |
| out = ioc | AR71XX_SPI_IOC_DO; |
| else |
| out = ioc & ~AR71XX_SPI_IOC_DO; |
| |
| /* setup MSB (to target) on trailing edge */ |
| ath79_spi_wr(sp, AR71XX_SPI_REG_IOC, out); |
| ath79_spi_delay(sp, nsecs); |
| ath79_spi_wr(sp, AR71XX_SPI_REG_IOC, out | AR71XX_SPI_IOC_CLK); |
| ath79_spi_delay(sp, nsecs); |
| if (bits == 1) |
| ath79_spi_wr(sp, AR71XX_SPI_REG_IOC, out); |
| |
| word <<= 1; |
| } |
| |
| return ath79_spi_rr(sp, AR71XX_SPI_REG_RDS); |
| } |
| |
| static int ath79_exec_mem_op(struct spi_mem *mem, |
| const struct spi_mem_op *op) |
| { |
| struct ath79_spi *sp = ath79_spidev_to_sp(mem->spi); |
| |
| /* Ensures that reading is performed on device connected to hardware cs0 */ |
| if (spi_get_chipselect(mem->spi, 0) || spi_get_csgpiod(mem->spi, 0)) |
| return -ENOTSUPP; |
| |
| /* Only use for fast-read op. */ |
| if (op->cmd.opcode != 0x0b || op->data.dir != SPI_MEM_DATA_IN || |
| op->addr.nbytes != 3 || op->dummy.nbytes != 1) |
| return -EOPNOTSUPP; |
| |
| /* disable GPIO mode */ |
| ath79_spi_wr(sp, AR71XX_SPI_REG_FS, 0); |
| |
| memcpy_fromio(op->data.buf.in, sp->base + op->addr.val, op->data.nbytes); |
| |
| /* enable GPIO mode */ |
| ath79_spi_wr(sp, AR71XX_SPI_REG_FS, AR71XX_SPI_FS_GPIO); |
| |
| /* restore IOC register */ |
| ath79_spi_wr(sp, AR71XX_SPI_REG_IOC, sp->ioc_base); |
| |
| return 0; |
| } |
| |
| static const struct spi_controller_mem_ops ath79_mem_ops = { |
| .exec_op = ath79_exec_mem_op, |
| }; |
| |
| static int ath79_spi_probe(struct platform_device *pdev) |
| { |
| struct spi_controller *host; |
| struct ath79_spi *sp; |
| unsigned long rate; |
| int ret; |
| |
| host = spi_alloc_host(&pdev->dev, sizeof(*sp)); |
| if (host == NULL) { |
| dev_err(&pdev->dev, "failed to allocate spi host\n"); |
| return -ENOMEM; |
| } |
| |
| sp = spi_controller_get_devdata(host); |
| host->dev.of_node = pdev->dev.of_node; |
| platform_set_drvdata(pdev, sp); |
| |
| host->use_gpio_descriptors = true; |
| host->bits_per_word_mask = SPI_BPW_RANGE_MASK(1, 32); |
| host->flags = SPI_CONTROLLER_GPIO_SS; |
| host->num_chipselect = 3; |
| host->mem_ops = &ath79_mem_ops; |
| |
| sp->bitbang.master = host; |
| sp->bitbang.chipselect = ath79_spi_chipselect; |
| sp->bitbang.txrx_word[SPI_MODE_0] = ath79_spi_txrx_mode0; |
| sp->bitbang.flags = SPI_CS_HIGH; |
| |
| sp->base = devm_platform_ioremap_resource(pdev, 0); |
| if (IS_ERR(sp->base)) { |
| ret = PTR_ERR(sp->base); |
| goto err_put_host; |
| } |
| |
| sp->clk = devm_clk_get_enabled(&pdev->dev, "ahb"); |
| if (IS_ERR(sp->clk)) { |
| ret = PTR_ERR(sp->clk); |
| goto err_put_host; |
| } |
| |
| rate = DIV_ROUND_UP(clk_get_rate(sp->clk), MHZ); |
| if (!rate) { |
| ret = -EINVAL; |
| goto err_put_host; |
| } |
| |
| sp->rrw_delay = ATH79_SPI_RRW_DELAY_FACTOR / rate; |
| dev_dbg(&pdev->dev, "register read/write delay is %u nsecs\n", |
| sp->rrw_delay); |
| |
| ath79_spi_enable(sp); |
| ret = spi_bitbang_start(&sp->bitbang); |
| if (ret) |
| goto err_disable; |
| |
| return 0; |
| |
| err_disable: |
| ath79_spi_disable(sp); |
| err_put_host: |
| spi_controller_put(host); |
| |
| return ret; |
| } |
| |
| static void ath79_spi_remove(struct platform_device *pdev) |
| { |
| struct ath79_spi *sp = platform_get_drvdata(pdev); |
| |
| spi_bitbang_stop(&sp->bitbang); |
| ath79_spi_disable(sp); |
| spi_controller_put(sp->bitbang.master); |
| } |
| |
| static void ath79_spi_shutdown(struct platform_device *pdev) |
| { |
| ath79_spi_remove(pdev); |
| } |
| |
| static const struct of_device_id ath79_spi_of_match[] = { |
| { .compatible = "qca,ar7100-spi", }, |
| { }, |
| }; |
| MODULE_DEVICE_TABLE(of, ath79_spi_of_match); |
| |
| static struct platform_driver ath79_spi_driver = { |
| .probe = ath79_spi_probe, |
| .remove_new = ath79_spi_remove, |
| .shutdown = ath79_spi_shutdown, |
| .driver = { |
| .name = DRV_NAME, |
| .of_match_table = ath79_spi_of_match, |
| }, |
| }; |
| module_platform_driver(ath79_spi_driver); |
| |
| MODULE_DESCRIPTION("SPI controller driver for Atheros AR71XX/AR724X/AR913X"); |
| MODULE_AUTHOR("Gabor Juhos <juhosg@openwrt.org>"); |
| MODULE_LICENSE("GPL v2"); |
| MODULE_ALIAS("platform:" DRV_NAME); |