| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * This file is part of wl18xx |
| * |
| * Copyright (C) 2011 Texas Instruments Inc. |
| */ |
| |
| #include "../wlcore/cmd.h" |
| #include "../wlcore/debug.h" |
| #include "../wlcore/acx.h" |
| |
| #include "acx.h" |
| #include "wl18xx.h" |
| |
| int wl18xx_acx_host_if_cfg_bitmap(struct wl1271 *wl, u32 host_cfg_bitmap, |
| u32 sdio_blk_size, u32 extra_mem_blks, |
| u32 len_field_size) |
| { |
| struct wl18xx_acx_host_config_bitmap *bitmap_conf; |
| int ret; |
| |
| wl1271_debug(DEBUG_ACX, "acx cfg bitmap %d blk %d spare %d field %d", |
| host_cfg_bitmap, sdio_blk_size, extra_mem_blks, |
| len_field_size); |
| |
| bitmap_conf = kzalloc(sizeof(*bitmap_conf), GFP_KERNEL); |
| if (!bitmap_conf) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| bitmap_conf->host_cfg_bitmap = cpu_to_le32(host_cfg_bitmap); |
| bitmap_conf->host_sdio_block_size = cpu_to_le32(sdio_blk_size); |
| bitmap_conf->extra_mem_blocks = cpu_to_le32(extra_mem_blks); |
| bitmap_conf->length_field_size = cpu_to_le32(len_field_size); |
| |
| ret = wl1271_cmd_configure(wl, ACX_HOST_IF_CFG_BITMAP, |
| bitmap_conf, sizeof(*bitmap_conf)); |
| if (ret < 0) { |
| wl1271_warning("wl1271 bitmap config opt failed: %d", ret); |
| goto out; |
| } |
| |
| out: |
| kfree(bitmap_conf); |
| |
| return ret; |
| } |
| |
| int wl18xx_acx_set_checksum_state(struct wl1271 *wl) |
| { |
| struct wl18xx_acx_checksum_state *acx; |
| int ret; |
| |
| wl1271_debug(DEBUG_ACX, "acx checksum state"); |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| acx->checksum_state = CHECKSUM_OFFLOAD_ENABLED; |
| |
| ret = wl1271_cmd_configure(wl, ACX_CSUM_CONFIG, acx, sizeof(*acx)); |
| if (ret < 0) { |
| wl1271_warning("failed to set Tx checksum state: %d", ret); |
| goto out; |
| } |
| |
| out: |
| kfree(acx); |
| return ret; |
| } |
| |
| int wl18xx_acx_clear_statistics(struct wl1271 *wl) |
| { |
| struct wl18xx_acx_clear_statistics *acx; |
| int ret = 0; |
| |
| wl1271_debug(DEBUG_ACX, "acx clear statistics"); |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| ret = wl1271_cmd_configure(wl, ACX_CLEAR_STATISTICS, acx, sizeof(*acx)); |
| if (ret < 0) { |
| wl1271_warning("failed to clear firmware statistics: %d", ret); |
| goto out; |
| } |
| |
| out: |
| kfree(acx); |
| return ret; |
| } |
| |
| int wl18xx_acx_peer_ht_operation_mode(struct wl1271 *wl, u8 hlid, bool wide) |
| { |
| struct wlcore_peer_ht_operation_mode *acx; |
| int ret; |
| |
| wl1271_debug(DEBUG_ACX, "acx peer ht operation mode hlid %d bw %d", |
| hlid, wide); |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| acx->hlid = hlid; |
| acx->bandwidth = wide ? WLCORE_BANDWIDTH_40MHZ : WLCORE_BANDWIDTH_20MHZ; |
| |
| ret = wl1271_cmd_configure(wl, ACX_PEER_HT_OPERATION_MODE_CFG, acx, |
| sizeof(*acx)); |
| |
| if (ret < 0) { |
| wl1271_warning("acx peer ht operation mode failed: %d", ret); |
| goto out; |
| } |
| |
| out: |
| kfree(acx); |
| return ret; |
| |
| } |
| |
| /* |
| * this command is basically the same as wl1271_acx_ht_capabilities, |
| * with the addition of supported rates. they should be unified in |
| * the next fw api change |
| */ |
| int wl18xx_acx_set_peer_cap(struct wl1271 *wl, |
| struct ieee80211_sta_ht_cap *ht_cap, |
| bool allow_ht_operation, |
| u32 rate_set, u8 hlid) |
| { |
| struct wlcore_acx_peer_cap *acx; |
| int ret = 0; |
| u32 ht_capabilites = 0; |
| |
| wl1271_debug(DEBUG_ACX, |
| "acx set cap ht_supp: %d ht_cap: %d rates: 0x%x", |
| ht_cap->ht_supported, ht_cap->cap, rate_set); |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| if (allow_ht_operation && ht_cap->ht_supported) { |
| /* no need to translate capabilities - use the spec values */ |
| ht_capabilites = ht_cap->cap; |
| |
| /* |
| * this bit is not employed by the spec but only by FW to |
| * indicate peer HT support |
| */ |
| ht_capabilites |= WL12XX_HT_CAP_HT_OPERATION; |
| |
| /* get data from A-MPDU parameters field */ |
| acx->ampdu_max_length = ht_cap->ampdu_factor; |
| acx->ampdu_min_spacing = ht_cap->ampdu_density; |
| } |
| |
| acx->hlid = hlid; |
| acx->ht_capabilites = cpu_to_le32(ht_capabilites); |
| acx->supported_rates = cpu_to_le32(rate_set); |
| |
| ret = wl1271_cmd_configure(wl, ACX_PEER_CAP, acx, sizeof(*acx)); |
| if (ret < 0) { |
| wl1271_warning("acx ht capabilities setting failed: %d", ret); |
| goto out; |
| } |
| |
| out: |
| kfree(acx); |
| return ret; |
| } |
| |
| /* |
| * When the host is suspended, we don't want to get any fast-link/PSM |
| * notifications |
| */ |
| int wl18xx_acx_interrupt_notify_config(struct wl1271 *wl, |
| bool action) |
| { |
| struct wl18xx_acx_interrupt_notify *acx; |
| int ret = 0; |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| acx->enable = action; |
| ret = wl1271_cmd_configure(wl, ACX_INTERRUPT_NOTIFY, acx, sizeof(*acx)); |
| if (ret < 0) { |
| wl1271_warning("acx interrupt notify setting failed: %d", ret); |
| goto out; |
| } |
| |
| out: |
| kfree(acx); |
| return ret; |
| } |
| |
| /* |
| * When the host is suspended, we can configure the FW to disable RX BA |
| * notifications. |
| */ |
| int wl18xx_acx_rx_ba_filter(struct wl1271 *wl, bool action) |
| { |
| struct wl18xx_acx_rx_ba_filter *acx; |
| int ret = 0; |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| acx->enable = (u32)action; |
| ret = wl1271_cmd_configure(wl, ACX_RX_BA_FILTER, acx, sizeof(*acx)); |
| if (ret < 0) { |
| wl1271_warning("acx rx ba activity filter setting failed: %d", |
| ret); |
| goto out; |
| } |
| |
| out: |
| kfree(acx); |
| return ret; |
| } |
| |
| int wl18xx_acx_ap_sleep(struct wl1271 *wl) |
| { |
| struct wl18xx_priv *priv = wl->priv; |
| struct acx_ap_sleep_cfg *acx; |
| struct conf_ap_sleep_settings *conf = &priv->conf.ap_sleep; |
| int ret; |
| |
| wl1271_debug(DEBUG_ACX, "acx config ap sleep"); |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| acx->idle_duty_cycle = conf->idle_duty_cycle; |
| acx->connected_duty_cycle = conf->connected_duty_cycle; |
| acx->max_stations_thresh = conf->max_stations_thresh; |
| acx->idle_conn_thresh = conf->idle_conn_thresh; |
| |
| ret = wl1271_cmd_configure(wl, ACX_AP_SLEEP_CFG, acx, sizeof(*acx)); |
| if (ret < 0) { |
| wl1271_warning("acx config ap-sleep failed: %d", ret); |
| goto out; |
| } |
| |
| out: |
| kfree(acx); |
| return ret; |
| } |
| |
| int wl18xx_acx_dynamic_fw_traces(struct wl1271 *wl) |
| { |
| struct acx_dynamic_fw_traces_cfg *acx; |
| int ret; |
| |
| wl1271_debug(DEBUG_ACX, "acx dynamic fw traces config %d", |
| wl->dynamic_fw_traces); |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| acx->dynamic_fw_traces = cpu_to_le32(wl->dynamic_fw_traces); |
| |
| ret = wl1271_cmd_configure(wl, ACX_DYNAMIC_TRACES_CFG, |
| acx, sizeof(*acx)); |
| if (ret < 0) { |
| wl1271_warning("acx config dynamic fw traces failed: %d", ret); |
| goto out; |
| } |
| out: |
| kfree(acx); |
| return ret; |
| } |
| |
| int wl18xx_acx_time_sync_cfg(struct wl1271 *wl) |
| { |
| struct acx_time_sync_cfg *acx; |
| int ret; |
| |
| wl1271_debug(DEBUG_ACX, "acx time sync cfg: mode %d, addr: %pM", |
| wl->conf.sg.params[WL18XX_CONF_SG_TIME_SYNC], |
| wl->zone_master_mac_addr); |
| |
| acx = kzalloc(sizeof(*acx), GFP_KERNEL); |
| if (!acx) { |
| ret = -ENOMEM; |
| goto out; |
| } |
| |
| acx->sync_mode = wl->conf.sg.params[WL18XX_CONF_SG_TIME_SYNC]; |
| memcpy(acx->zone_mac_addr, wl->zone_master_mac_addr, ETH_ALEN); |
| |
| ret = wl1271_cmd_configure(wl, ACX_TIME_SYNC_CFG, |
| acx, sizeof(*acx)); |
| if (ret < 0) { |
| wl1271_warning("acx time sync cfg failed: %d", ret); |
| goto out; |
| } |
| out: |
| kfree(acx); |
| return ret; |
| } |