| // SPDX-License-Identifier: GPL-2.0 |
| // |
| // AWINIC AW37503 Regulator Driver |
| // |
| // Copyright (C) 2023 awinic. All Rights Reserved |
| // |
| // Author: <like@awinic.com> |
| |
| #include <linux/err.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/i2c.h> |
| #include <linux/module.h> |
| #include <linux/regmap.h> |
| #include <linux/regulator/driver.h> |
| #include <linux/regulator/machine.h> |
| |
| #define AW37503_REG_VPOS 0x00 |
| #define AW37503_REG_VNEG 0x01 |
| #define AW37503_REG_APPS 0x03 |
| #define AW37503_REG_CONTROL 0x04 |
| #define AW37503_REG_WPRTEN 0x21 |
| |
| #define AW37503_VOUT_MASK 0x1F |
| #define AW37503_VOUT_N_VOLTAGE 0x15 |
| #define AW37503_VOUT_VMIN 4000000 |
| #define AW37503_VOUT_VMAX 6000000 |
| #define AW37503_VOUT_STEP 100000 |
| |
| #define AW37503_REG_APPS_DIS_VPOS BIT(1) |
| #define AW37503_REG_APPS_DIS_VNEG BIT(0) |
| |
| #define AW37503_REGULATOR_ID_VPOS 0 |
| #define AW37503_REGULATOR_ID_VNEG 1 |
| #define AW37503_MAX_REGULATORS 2 |
| |
| struct aw37503_reg_pdata { |
| struct gpio_desc *en_gpiod; |
| int ena_gpio_state; |
| }; |
| |
| struct aw37503_regulator { |
| struct device *dev; |
| struct aw37503_reg_pdata reg_pdata[AW37503_MAX_REGULATORS]; |
| }; |
| |
| static int aw37503_regulator_enable(struct regulator_dev *rdev) |
| { |
| struct aw37503_regulator *chip = rdev_get_drvdata(rdev); |
| int id = rdev_get_id(rdev); |
| struct aw37503_reg_pdata *rpdata = &chip->reg_pdata[id]; |
| int ret; |
| |
| if (!IS_ERR(rpdata->en_gpiod)) { |
| gpiod_set_value_cansleep(rpdata->en_gpiod, 1); |
| rpdata->ena_gpio_state = 1; |
| } |
| |
| /* Hardware automatically enable discharge bit in enable */ |
| if (rdev->constraints->active_discharge == |
| REGULATOR_ACTIVE_DISCHARGE_DISABLE) { |
| ret = regulator_set_active_discharge_regmap(rdev, false); |
| if (ret < 0) { |
| dev_err(chip->dev, "Failed to disable active discharge: %d\n", |
| ret); |
| return ret; |
| } |
| } |
| |
| return 0; |
| } |
| |
| static int aw37503_regulator_disable(struct regulator_dev *rdev) |
| { |
| struct aw37503_regulator *chip = rdev_get_drvdata(rdev); |
| int id = rdev_get_id(rdev); |
| struct aw37503_reg_pdata *rpdata = &chip->reg_pdata[id]; |
| |
| if (!IS_ERR(rpdata->en_gpiod)) { |
| gpiod_set_value_cansleep(rpdata->en_gpiod, 0); |
| rpdata->ena_gpio_state = 0; |
| } |
| |
| return 0; |
| } |
| |
| static int aw37503_regulator_is_enabled(struct regulator_dev *rdev) |
| { |
| struct aw37503_regulator *chip = rdev_get_drvdata(rdev); |
| int id = rdev_get_id(rdev); |
| struct aw37503_reg_pdata *rpdata = &chip->reg_pdata[id]; |
| |
| if (!IS_ERR(rpdata->en_gpiod)) |
| return rpdata->ena_gpio_state; |
| |
| return 1; |
| } |
| |
| static const struct regulator_ops aw37503_regulator_ops = { |
| .enable = aw37503_regulator_enable, |
| .disable = aw37503_regulator_disable, |
| .is_enabled = aw37503_regulator_is_enabled, |
| .list_voltage = regulator_list_voltage_linear, |
| .map_voltage = regulator_map_voltage_linear, |
| .get_voltage_sel = regulator_get_voltage_sel_regmap, |
| .set_voltage_sel = regulator_set_voltage_sel_regmap, |
| .set_active_discharge = regulator_set_active_discharge_regmap, |
| }; |
| |
| static int aw37503_of_parse_cb(struct device_node *np, |
| const struct regulator_desc *desc, |
| struct regulator_config *config) |
| { |
| struct aw37503_regulator *chip = config->driver_data; |
| struct aw37503_reg_pdata *rpdata = &chip->reg_pdata[desc->id]; |
| int ret; |
| |
| rpdata->en_gpiod = devm_fwnode_gpiod_get(chip->dev, of_fwnode_handle(np), |
| "enable", GPIOD_OUT_LOW, |
| "enable"); |
| |
| if (IS_ERR(rpdata->en_gpiod)) { |
| ret = PTR_ERR(rpdata->en_gpiod); |
| |
| /* Ignore the error other than probe defer */ |
| if (ret == -EPROBE_DEFER) |
| return ret; |
| return 0; |
| } |
| |
| return 0; |
| } |
| |
| #define AW37503_REGULATOR_DESC(_id, _name) \ |
| [AW37503_REGULATOR_ID_##_id] = { \ |
| .name = "aw37503-"#_name, \ |
| .supply_name = "vin", \ |
| .id = AW37503_REGULATOR_ID_##_id, \ |
| .of_match = of_match_ptr(#_name), \ |
| .of_parse_cb = aw37503_of_parse_cb, \ |
| .ops = &aw37503_regulator_ops, \ |
| .n_voltages = AW37503_VOUT_N_VOLTAGE, \ |
| .min_uV = AW37503_VOUT_VMIN, \ |
| .uV_step = AW37503_VOUT_STEP, \ |
| .enable_time = 500, \ |
| .vsel_mask = AW37503_VOUT_MASK, \ |
| .vsel_reg = AW37503_REG_##_id, \ |
| .active_discharge_off = 0, \ |
| .active_discharge_on = AW37503_REG_APPS_DIS_##_id, \ |
| .active_discharge_mask = AW37503_REG_APPS_DIS_##_id, \ |
| .active_discharge_reg = AW37503_REG_APPS, \ |
| .type = REGULATOR_VOLTAGE, \ |
| .owner = THIS_MODULE, \ |
| } |
| |
| static const struct regulator_desc aw_regs_desc[AW37503_MAX_REGULATORS] = { |
| AW37503_REGULATOR_DESC(VPOS, outp), |
| AW37503_REGULATOR_DESC(VNEG, outn), |
| }; |
| |
| static const struct regmap_range aw37503_no_reg_ranges[] = { |
| regmap_reg_range(AW37503_REG_CONTROL + 1, |
| AW37503_REG_WPRTEN - 1), |
| }; |
| |
| static const struct regmap_access_table aw37503_no_reg_table = { |
| .no_ranges = aw37503_no_reg_ranges, |
| .n_no_ranges = ARRAY_SIZE(aw37503_no_reg_ranges), |
| }; |
| |
| static const struct regmap_config aw37503_regmap_config = { |
| .reg_bits = 8, |
| .val_bits = 8, |
| .max_register = AW37503_REG_WPRTEN, |
| .rd_table = &aw37503_no_reg_table, |
| .wr_table = &aw37503_no_reg_table, |
| }; |
| |
| static int aw37503_probe(struct i2c_client *client) |
| { |
| struct device *dev = &client->dev; |
| struct aw37503_regulator *chip; |
| struct regulator_dev *rdev; |
| struct regmap *regmap; |
| struct regulator_config config = { }; |
| int id; |
| |
| chip = devm_kzalloc(dev, sizeof(*chip), GFP_KERNEL); |
| if (!chip) |
| return -ENOMEM; |
| |
| regmap = devm_regmap_init_i2c(client, &aw37503_regmap_config); |
| if (IS_ERR(regmap)) |
| return dev_err_probe(dev, PTR_ERR(regmap), |
| "Failed to init regmap\n"); |
| |
| i2c_set_clientdata(client, chip); |
| chip->dev = dev; |
| |
| config.regmap = regmap; |
| config.dev = dev; |
| config.driver_data = chip; |
| |
| for (id = 0; id < AW37503_MAX_REGULATORS; ++id) { |
| rdev = devm_regulator_register(dev, &aw_regs_desc[id], |
| &config); |
| if (IS_ERR(rdev)) |
| return dev_err_probe(dev, PTR_ERR(rdev), |
| "Failed to register regulator %s\n", |
| aw_regs_desc[id].name); |
| } |
| return 0; |
| } |
| |
| static const struct i2c_device_id aw37503_id[] = { |
| {.name = "aw37503",}, |
| {}, |
| }; |
| MODULE_DEVICE_TABLE(i2c, aw37503_id); |
| |
| static const struct of_device_id aw37503_of_match[] = { |
| {.compatible = "awinic,aw37503",}, |
| { /* Sentinel */ }, |
| }; |
| |
| MODULE_DEVICE_TABLE(of, aw37503_of_match); |
| |
| static struct i2c_driver aw37503_i2c_driver = { |
| .driver = { |
| .name = "aw37503", |
| .of_match_table = aw37503_of_match, |
| }, |
| .probe = aw37503_probe, |
| .id_table = aw37503_id, |
| }; |
| |
| module_i2c_driver(aw37503_i2c_driver); |
| |
| MODULE_DESCRIPTION("aw37503 regulator driver"); |
| MODULE_AUTHOR("Alec Li <like@awinic.com>"); |
| MODULE_LICENSE("GPL"); |