| # SPDX-License-Identifier: GPL-2.0-only |
| menu "Audio support for Texas Instruments SoCs" |
| depends on DMA_OMAP || TI_EDMA || COMPILE_TEST |
| |
| config SND_SOC_TI_EDMA_PCM |
| tristate |
| select SND_SOC_GENERIC_DMAENGINE_PCM |
| |
| config SND_SOC_TI_SDMA_PCM |
| tristate |
| select SND_SOC_GENERIC_DMAENGINE_PCM |
| |
| comment "Texas Instruments DAI support for:" |
| config SND_SOC_DAVINCI_ASP |
| tristate "daVinci Audio Serial Port (ASP) or McBSP support" |
| depends on ARCH_DAVINCI || COMPILE_TEST |
| select SND_SOC_TI_EDMA_PCM |
| help |
| Say Y or M here if you want audio support via daVinci ASP or McBSP. |
| The driver only implements the ASP support which is a subset of |
| daVinci McBSP (w/o the multichannel support). |
| |
| config SND_SOC_DAVINCI_MCASP |
| tristate "Multichannel Audio Serial Port (McASP) support" |
| select SND_SOC_TI_EDMA_PCM |
| select SND_SOC_TI_SDMA_PCM |
| help |
| Say Y or M here if you want to have support for McASP IP found in |
| various Texas Instruments SoCs like: |
| - daVinci devices |
| - Sitara line of SoCs (AM335x, AM438x, etc) |
| - DRA7x devices |
| - Keystone devices |
| |
| config SND_SOC_DAVINCI_VCIF |
| tristate "daVinci Voice Interface (VCIF) support" |
| depends on ARCH_DAVINCI || COMPILE_TEST |
| select SND_SOC_TI_EDMA_PCM |
| help |
| Say Y or M here if you want audio support via daVinci VCIF. |
| |
| config SND_SOC_OMAP_DMIC |
| tristate "Digital Microphone Module (DMIC) support" |
| depends on ARCH_OMAP4 || SOC_OMAP5 || COMPILE_TEST |
| select SND_SOC_TI_SDMA_PCM |
| help |
| Say Y or M here if you want to have support for DMIC IP found in |
| OMAP4 and OMAP5. |
| |
| config SND_SOC_OMAP_MCBSP |
| tristate "Multichannel Buffered Serial Port (McBSP) support" |
| depends on ARCH_OMAP || ARCH_OMAP1 || COMPILE_TEST |
| select SND_SOC_TI_SDMA_PCM |
| help |
| Say Y or M here if you want to have support for McBSP IP found in |
| Texas Instruments OMAP1/2/3/4/5 SoCs. |
| |
| config SND_SOC_OMAP_MCPDM |
| tristate "Multichannel PDM Controller (McPDM) support" |
| depends on ARCH_OMAP4 || SOC_OMAP5 || COMPILE_TEST |
| select SND_SOC_TI_SDMA_PCM |
| help |
| Say Y or M here if you want to have support for McPDM IP found in |
| OMAP4 and OMAP5. |
| |
| comment "Audio support for boards with Texas Instruments SoCs" |
| config SND_SOC_NOKIA_N810 |
| tristate "SoC Audio support for Nokia N810" |
| depends on MACH_NOKIA_N810 && I2C |
| select SND_SOC_OMAP_MCBSP |
| select SND_SOC_TLV320AIC3X |
| help |
| Say Y or M if you want to add support for SoC audio on Nokia N810. |
| |
| config SND_SOC_NOKIA_RX51 |
| tristate "SoC Audio support for Nokia RX-51" |
| depends on ARCH_OMAP3 && I2C && GPIOLIB |
| select SND_SOC_OMAP_MCBSP |
| select SND_SOC_TLV320AIC3X |
| select SND_SOC_TPA6130A2 |
| help |
| Say Y or M if you want to add support for SoC audio on Nokia RX-51 |
| hardware. This is also known as Nokia N900 product. |
| |
| config SND_SOC_OMAP3_PANDORA |
| tristate "SoC Audio support for OMAP3 Pandora" |
| depends on ARCH_OMAP3 |
| depends on TWL4030_CORE |
| select SND_SOC_OMAP_MCBSP |
| select SND_SOC_TWL4030 |
| help |
| Say Y or M if you want to add support for SoC audio on the OMAP3 Pandora. |
| |
| config SND_SOC_OMAP3_TWL4030 |
| tristate "SoC Audio support for OMAP3 based boards with twl4030 codec" |
| depends on ARCH_OMAP3 || COMPILE_TEST |
| depends on TWL4030_CORE |
| select SND_SOC_OMAP_MCBSP |
| select SND_SOC_TWL4030 |
| help |
| Say Y or M if you want to add support for SoC audio on OMAP3 based |
| boards using twl4030 as codec. This driver currently supports: |
| - Beagleboard or Devkit8000 |
| - Gumstix Overo or CompuLab CM-T35/CM-T3730 |
| - IGEP v2 |
| - OMAP3EVM |
| - SDP3430 |
| - Zoom2 |
| |
| config SND_SOC_OMAP_ABE_TWL6040 |
| tristate "SoC Audio support for OMAP boards using ABE and twl6040 codec" |
| depends on TWL6040_CORE && COMMON_CLK |
| depends on ARCH_OMAP4 || (SOC_OMAP5 && MFD_PALMAS) || COMPILE_TEST |
| select SND_SOC_OMAP_DMIC |
| select SND_SOC_OMAP_MCPDM |
| select SND_SOC_TWL6040 |
| help |
| Say Y or M if you want to add support for SoC audio on OMAP boards |
| using ABE and twl6040 codec. This driver currently supports: |
| - SDP4430/Blaze boards |
| - PandaBoard (4430) |
| - PandaBoardES (4460) |
| - OMAP5 uEVM |
| |
| config SND_SOC_OMAP_AMS_DELTA |
| tristate "SoC Audio support for Amstrad E3 (Delta) videophone" |
| depends on MACH_AMS_DELTA && TTY |
| select SND_SOC_OMAP_MCBSP |
| select SND_SOC_CX20442 |
| help |
| Say Y or M if you want to add support for SoC audio device |
| connected to a handset and a speakerphone found on Amstrad E3 (Delta) |
| videophone. |
| |
| Note that in order to get those devices fully supported, you have to |
| build the kernel with standard serial port driver included and |
| configured for at least 4 ports. Then, from userspace, you must load |
| a line discipline #19 on the modem (ttyS3) serial line. The simplest |
| way to achieve this is to install util-linux-ng and use the included |
| ldattach utility. This can be started automatically from udev, |
| a simple rule like this one should do the trick (it does for me): |
| ACTION=="add", KERNEL=="controlC0", \ |
| RUN+="/usr/sbin/ldattach 19 /dev/ttyS3" |
| |
| config SND_SOC_OMAP_HDMI |
| tristate "OMAP4/5 HDMI audio support" |
| depends on OMAP4_DSS_HDMI || OMAP5_DSS_HDMI || COMPILE_TEST |
| select SND_SOC_TI_SDMA_PCM |
| help |
| For HDMI audio to work OMAPDSS HDMI support should be |
| enabled. |
| The hdmi audio driver implements cpu-dai component using the |
| callbacks provided by OMAPDSS and registers the component |
| under DSS HDMI device. Omap-pcm is registered for platform |
| component also under DSS HDMI device. Dummy codec is used as |
| as codec component. The hdmi audio driver implements also |
| the card and registers it under its own platform device. |
| The device for the driver is registered by OMAPDSS hdmi |
| driver. |
| |
| config SND_SOC_OMAP_OSK5912 |
| tristate "SoC Audio support for omap osk5912" |
| depends on MACH_OMAP_OSK && I2C |
| select SND_SOC_OMAP_MCBSP |
| select SND_SOC_TLV320AIC23_I2C |
| help |
| Say Y or M if you want to add support for SoC audio on osk5912. |
| |
| config SND_SOC_DAVINCI_EVM |
| tristate "SoC Audio support for DaVinci EVMs" |
| depends on ARCH_DAVINCI && I2C |
| select SND_SOC_DAVINCI_ASP if MACH_DAVINCI_DM355_EVM |
| select SND_SOC_DAVINCI_ASP if SND_SOC_DM365_AIC3X_CODEC |
| select SND_SOC_DAVINCI_VCIF if SND_SOC_DM365_VOICE_CODEC |
| select SND_SOC_DAVINCI_ASP if MACH_DAVINCI_EVM # DM6446 |
| select SND_SOC_DAVINCI_MCASP if MACH_DAVINCI_DM6467_EVM |
| select SND_SOC_SPDIF if MACH_DAVINCI_DM6467_EVM |
| select SND_SOC_DAVINCI_MCASP if MACH_DAVINCI_DA830_EVM |
| select SND_SOC_DAVINCI_MCASP if MACH_DAVINCI_DA850_EVM |
| select SND_SOC_TLV320AIC3X |
| help |
| Say Y if you want to add support for SoC audio on the following TI |
| DaVinci EVM platforms: |
| - DM355 |
| - DM365 |
| - DM6446 |
| - DM6447 |
| - DM830 |
| - DM850 |
| |
| choice |
| prompt "DM365 codec select" |
| depends on SND_SOC_DAVINCI_EVM |
| depends on MACH_DAVINCI_DM365_EVM |
| |
| config SND_SOC_DM365_AIC3X_CODEC |
| bool "Audio Codec - AIC3101" |
| help |
| Say Y if you want to add support for AIC3101 audio codec |
| |
| config SND_SOC_DM365_VOICE_CODEC |
| bool "Voice Codec - CQ93VC" |
| help |
| Say Y if you want to add support for SoC On-chip voice codec |
| endchoice |
| |
| config SND_SOC_DM365_VOICE_CODEC_MODULE |
| def_tristate y |
| depends on SND_SOC_DM365_VOICE_CODEC && SND_SOC |
| select MFD_DAVINCI_VOICECODEC |
| select SND_SOC_CQ0093VC |
| help |
| The is an internal symbol needed to ensure that the codec |
| and MFD driver can be built as loadable modules if necessary. |
| |
| endmenu |
| |
