| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * DRM driver for Ilitek ILI9486 panels |
| * |
| * Copyright 2020 Kamlesh Gurudasani <kamlesh.gurudasani@gmail.com> |
| */ |
| |
| #include <linux/backlight.h> |
| #include <linux/delay.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/module.h> |
| #include <linux/property.h> |
| #include <linux/spi/spi.h> |
| |
| #include <video/mipi_display.h> |
| |
| #include <drm/drm_atomic_helper.h> |
| #include <drm/drm_drv.h> |
| #include <drm/drm_fbdev_dma.h> |
| #include <drm/drm_gem_atomic_helper.h> |
| #include <drm/drm_gem_dma_helper.h> |
| #include <drm/drm_managed.h> |
| #include <drm/drm_mipi_dbi.h> |
| #include <drm/drm_modeset_helper.h> |
| |
| #define ILI9486_ITFCTR1 0xb0 |
| #define ILI9486_PWCTRL1 0xc2 |
| #define ILI9486_VMCTRL1 0xc5 |
| #define ILI9486_PGAMCTRL 0xe0 |
| #define ILI9486_NGAMCTRL 0xe1 |
| #define ILI9486_DGAMCTRL 0xe2 |
| #define ILI9486_MADCTL_BGR BIT(3) |
| #define ILI9486_MADCTL_MV BIT(5) |
| #define ILI9486_MADCTL_MX BIT(6) |
| #define ILI9486_MADCTL_MY BIT(7) |
| |
| /* |
| * The PiScreen/waveshare rpi-lcd-35 has a SPI to 16-bit parallel bus converter |
| * in front of the display controller. This means that 8-bit values have to be |
| * transferred as 16-bit. |
| */ |
| static int waveshare_command(struct mipi_dbi *mipi, u8 *cmd, u8 *par, |
| size_t num) |
| { |
| struct spi_device *spi = mipi->spi; |
| unsigned int bpw = 8; |
| void *data = par; |
| u32 speed_hz; |
| int i, ret; |
| __be16 *buf; |
| |
| buf = kmalloc(32 * sizeof(u16), GFP_KERNEL); |
| if (!buf) |
| return -ENOMEM; |
| |
| /* |
| * The displays are Raspberry Pi HATs and connected to the 8-bit only |
| * SPI controller, so 16-bit command and parameters need byte swapping |
| * before being transferred as 8-bit on the big endian SPI bus. |
| */ |
| buf[0] = cpu_to_be16(*cmd); |
| spi_bus_lock(spi->controller); |
| gpiod_set_value_cansleep(mipi->dc, 0); |
| speed_hz = mipi_dbi_spi_cmd_max_speed(spi, 2); |
| ret = mipi_dbi_spi_transfer(spi, speed_hz, 8, buf, 2); |
| spi_bus_unlock(spi->controller); |
| if (ret || !num) |
| goto free; |
| |
| /* 8-bit configuration data, not 16-bit pixel data */ |
| if (num <= 32) { |
| for (i = 0; i < num; i++) |
| buf[i] = cpu_to_be16(par[i]); |
| num *= 2; |
| data = buf; |
| } |
| |
| /* |
| * Check whether pixel data bytes needs to be swapped or not |
| */ |
| if (*cmd == MIPI_DCS_WRITE_MEMORY_START && !mipi->swap_bytes) |
| bpw = 16; |
| |
| spi_bus_lock(spi->controller); |
| gpiod_set_value_cansleep(mipi->dc, 1); |
| speed_hz = mipi_dbi_spi_cmd_max_speed(spi, num); |
| ret = mipi_dbi_spi_transfer(spi, speed_hz, bpw, data, num); |
| spi_bus_unlock(spi->controller); |
| free: |
| kfree(buf); |
| |
| return ret; |
| } |
| |
| static void waveshare_enable(struct drm_simple_display_pipe *pipe, |
| struct drm_crtc_state *crtc_state, |
| struct drm_plane_state *plane_state) |
| { |
| struct mipi_dbi_dev *dbidev = drm_to_mipi_dbi_dev(pipe->crtc.dev); |
| struct mipi_dbi *dbi = &dbidev->dbi; |
| u8 addr_mode; |
| int ret, idx; |
| |
| if (!drm_dev_enter(pipe->crtc.dev, &idx)) |
| return; |
| |
| DRM_DEBUG_KMS("\n"); |
| |
| ret = mipi_dbi_poweron_conditional_reset(dbidev); |
| if (ret < 0) |
| goto out_exit; |
| if (ret == 1) |
| goto out_enable; |
| |
| mipi_dbi_command(dbi, ILI9486_ITFCTR1); |
| mipi_dbi_command(dbi, MIPI_DCS_EXIT_SLEEP_MODE); |
| msleep(250); |
| |
| mipi_dbi_command(dbi, MIPI_DCS_SET_PIXEL_FORMAT, 0x55); |
| |
| mipi_dbi_command(dbi, ILI9486_PWCTRL1, 0x44); |
| |
| mipi_dbi_command(dbi, ILI9486_VMCTRL1, 0x00, 0x00, 0x00, 0x00); |
| |
| mipi_dbi_command(dbi, ILI9486_PGAMCTRL, |
| 0x0F, 0x1F, 0x1C, 0x0C, 0x0F, 0x08, 0x48, 0x98, |
| 0x37, 0x0A, 0x13, 0x04, 0x11, 0x0D, 0x0); |
| mipi_dbi_command(dbi, ILI9486_NGAMCTRL, |
| 0x0F, 0x32, 0x2E, 0x0B, 0x0D, 0x05, 0x47, 0x75, |
| 0x37, 0x06, 0x10, 0x03, 0x24, 0x20, 0x00); |
| mipi_dbi_command(dbi, ILI9486_DGAMCTRL, |
| 0x0F, 0x32, 0x2E, 0x0B, 0x0D, 0x05, 0x47, 0x75, |
| 0x37, 0x06, 0x10, 0x03, 0x24, 0x20, 0x00); |
| |
| mipi_dbi_command(dbi, MIPI_DCS_SET_DISPLAY_ON); |
| msleep(100); |
| |
| out_enable: |
| switch (dbidev->rotation) { |
| case 90: |
| addr_mode = ILI9486_MADCTL_MY; |
| break; |
| case 180: |
| addr_mode = ILI9486_MADCTL_MV; |
| break; |
| case 270: |
| addr_mode = ILI9486_MADCTL_MX; |
| break; |
| default: |
| addr_mode = ILI9486_MADCTL_MV | ILI9486_MADCTL_MY | |
| ILI9486_MADCTL_MX; |
| break; |
| } |
| addr_mode |= ILI9486_MADCTL_BGR; |
| mipi_dbi_command(dbi, MIPI_DCS_SET_ADDRESS_MODE, addr_mode); |
| mipi_dbi_enable_flush(dbidev, crtc_state, plane_state); |
| out_exit: |
| drm_dev_exit(idx); |
| } |
| |
| static const struct drm_simple_display_pipe_funcs waveshare_pipe_funcs = { |
| DRM_MIPI_DBI_SIMPLE_DISPLAY_PIPE_FUNCS(waveshare_enable), |
| }; |
| |
| static const struct drm_display_mode waveshare_mode = { |
| DRM_SIMPLE_MODE(480, 320, 73, 49), |
| }; |
| |
| DEFINE_DRM_GEM_DMA_FOPS(ili9486_fops); |
| |
| static const struct drm_driver ili9486_driver = { |
| .driver_features = DRIVER_GEM | DRIVER_MODESET | DRIVER_ATOMIC, |
| .fops = &ili9486_fops, |
| DRM_GEM_DMA_DRIVER_OPS_VMAP, |
| .debugfs_init = mipi_dbi_debugfs_init, |
| .name = "ili9486", |
| .desc = "Ilitek ILI9486", |
| .date = "20200118", |
| .major = 1, |
| .minor = 0, |
| }; |
| |
| static const struct of_device_id ili9486_of_match[] = { |
| { .compatible = "waveshare,rpi-lcd-35" }, |
| { .compatible = "ozzmaker,piscreen" }, |
| {}, |
| }; |
| MODULE_DEVICE_TABLE(of, ili9486_of_match); |
| |
| static const struct spi_device_id ili9486_id[] = { |
| { "ili9486", 0 }, |
| { "rpi-lcd-35", 0 }, |
| { "piscreen", 0 }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(spi, ili9486_id); |
| |
| static int ili9486_probe(struct spi_device *spi) |
| { |
| struct device *dev = &spi->dev; |
| struct mipi_dbi_dev *dbidev; |
| struct drm_device *drm; |
| struct mipi_dbi *dbi; |
| struct gpio_desc *dc; |
| u32 rotation = 0; |
| int ret; |
| |
| dbidev = devm_drm_dev_alloc(dev, &ili9486_driver, |
| struct mipi_dbi_dev, drm); |
| if (IS_ERR(dbidev)) |
| return PTR_ERR(dbidev); |
| |
| dbi = &dbidev->dbi; |
| drm = &dbidev->drm; |
| |
| dbi->reset = devm_gpiod_get(dev, "reset", GPIOD_OUT_HIGH); |
| if (IS_ERR(dbi->reset)) |
| return dev_err_probe(dev, PTR_ERR(dbi->reset), "Failed to get GPIO 'reset'\n"); |
| |
| dc = devm_gpiod_get(dev, "dc", GPIOD_OUT_LOW); |
| if (IS_ERR(dc)) |
| return dev_err_probe(dev, PTR_ERR(dc), "Failed to get GPIO 'dc'\n"); |
| |
| dbidev->backlight = devm_of_find_backlight(dev); |
| if (IS_ERR(dbidev->backlight)) |
| return PTR_ERR(dbidev->backlight); |
| |
| device_property_read_u32(dev, "rotation", &rotation); |
| |
| ret = mipi_dbi_spi_init(spi, dbi, dc); |
| if (ret) |
| return ret; |
| |
| dbi->command = waveshare_command; |
| dbi->read_commands = NULL; |
| |
| ret = mipi_dbi_dev_init(dbidev, &waveshare_pipe_funcs, |
| &waveshare_mode, rotation); |
| if (ret) |
| return ret; |
| |
| drm_mode_config_reset(drm); |
| |
| ret = drm_dev_register(drm, 0); |
| if (ret) |
| return ret; |
| |
| spi_set_drvdata(spi, drm); |
| |
| drm_fbdev_dma_setup(drm, 0); |
| |
| return 0; |
| } |
| |
| static void ili9486_remove(struct spi_device *spi) |
| { |
| struct drm_device *drm = spi_get_drvdata(spi); |
| |
| drm_dev_unplug(drm); |
| drm_atomic_helper_shutdown(drm); |
| } |
| |
| static void ili9486_shutdown(struct spi_device *spi) |
| { |
| drm_atomic_helper_shutdown(spi_get_drvdata(spi)); |
| } |
| |
| static struct spi_driver ili9486_spi_driver = { |
| .driver = { |
| .name = "ili9486", |
| .of_match_table = ili9486_of_match, |
| }, |
| .id_table = ili9486_id, |
| .probe = ili9486_probe, |
| .remove = ili9486_remove, |
| .shutdown = ili9486_shutdown, |
| }; |
| module_spi_driver(ili9486_spi_driver); |
| |
| MODULE_DESCRIPTION("Ilitek ILI9486 DRM driver"); |
| MODULE_AUTHOR("Kamlesh Gurudasani <kamlesh.gurudasani@gmail.com>"); |
| MODULE_LICENSE("GPL"); |