| // SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause |
| /* |
| * Copyright (C) 2012-2014, 2018-2019 Intel Corporation |
| * Copyright (C) 2017 Intel Deutschland GmbH |
| */ |
| #include <linux/leds.h> |
| #include "iwl-io.h" |
| #include "iwl-csr.h" |
| #include "mvm.h" |
| |
| static void iwl_mvm_send_led_fw_cmd(struct iwl_mvm *mvm, bool on) |
| { |
| struct iwl_led_cmd led_cmd = { |
| .status = cpu_to_le32(on), |
| }; |
| struct iwl_host_cmd cmd = { |
| .id = WIDE_ID(LONG_GROUP, LEDS_CMD), |
| .len = { sizeof(led_cmd), }, |
| .data = { &led_cmd, }, |
| .flags = CMD_ASYNC, |
| }; |
| int err; |
| |
| if (!iwl_mvm_firmware_running(mvm)) |
| return; |
| |
| err = iwl_mvm_send_cmd(mvm, &cmd); |
| |
| if (err) |
| IWL_WARN(mvm, "LED command failed: %d\n", err); |
| } |
| |
| static void iwl_mvm_led_set(struct iwl_mvm *mvm, bool on) |
| { |
| if (fw_has_capa(&mvm->fw->ucode_capa, |
| IWL_UCODE_TLV_CAPA_LED_CMD_SUPPORT)) { |
| iwl_mvm_send_led_fw_cmd(mvm, on); |
| return; |
| } |
| |
| iwl_write32(mvm->trans, CSR_LED_REG, |
| on ? CSR_LED_REG_TURN_ON : CSR_LED_REG_TURN_OFF); |
| } |
| |
| static void iwl_led_brightness_set(struct led_classdev *led_cdev, |
| enum led_brightness brightness) |
| { |
| struct iwl_mvm *mvm = container_of(led_cdev, struct iwl_mvm, led); |
| |
| iwl_mvm_led_set(mvm, brightness > 0); |
| } |
| |
| int iwl_mvm_leds_init(struct iwl_mvm *mvm) |
| { |
| int mode = iwlwifi_mod_params.led_mode; |
| int ret; |
| |
| switch (mode) { |
| case IWL_LED_BLINK: |
| IWL_ERR(mvm, "Blink led mode not supported, used default\n"); |
| fallthrough; |
| case IWL_LED_DEFAULT: |
| case IWL_LED_RF_STATE: |
| mode = IWL_LED_RF_STATE; |
| break; |
| case IWL_LED_DISABLE: |
| IWL_INFO(mvm, "Led disabled\n"); |
| return 0; |
| default: |
| return -EINVAL; |
| } |
| |
| mvm->led.name = kasprintf(GFP_KERNEL, "%s-led", |
| wiphy_name(mvm->hw->wiphy)); |
| if (!mvm->led.name) |
| return -ENOMEM; |
| |
| mvm->led.brightness_set = iwl_led_brightness_set; |
| mvm->led.max_brightness = 1; |
| |
| if (mode == IWL_LED_RF_STATE) |
| mvm->led.default_trigger = |
| ieee80211_get_radio_led_name(mvm->hw); |
| |
| ret = led_classdev_register(mvm->trans->dev, &mvm->led); |
| if (ret) { |
| kfree(mvm->led.name); |
| IWL_INFO(mvm, "Failed to enable led\n"); |
| return ret; |
| } |
| |
| mvm->init_status |= IWL_MVM_INIT_STATUS_LEDS_INIT_COMPLETE; |
| return 0; |
| } |
| |
| void iwl_mvm_leds_sync(struct iwl_mvm *mvm) |
| { |
| if (!(mvm->init_status & IWL_MVM_INIT_STATUS_LEDS_INIT_COMPLETE)) |
| return; |
| |
| /* |
| * if we control through the register, we're doing it |
| * even when the firmware isn't up, so no need to sync |
| */ |
| if (mvm->trans->trans_cfg->device_family < IWL_DEVICE_FAMILY_8000) |
| return; |
| |
| iwl_mvm_led_set(mvm, mvm->led.brightness > 0); |
| } |
| |
| void iwl_mvm_leds_exit(struct iwl_mvm *mvm) |
| { |
| if (!(mvm->init_status & IWL_MVM_INIT_STATUS_LEDS_INIT_COMPLETE)) |
| return; |
| |
| led_classdev_unregister(&mvm->led); |
| kfree(mvm->led.name); |
| mvm->init_status &= ~IWL_MVM_INIT_STATUS_LEDS_INIT_COMPLETE; |
| } |