| # SPDX-License-Identifier: GPL-2.0-only |
| # |
| # Micrel device configuration |
| # |
| |
| config NET_VENDOR_MICREL |
| bool "Micrel devices" |
| default y |
| depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM |
| help |
| If you have a network (Ethernet) card belonging to this class, say Y. |
| |
| Note that the answer to this question doesn't directly affect the |
| kernel: saying N will just cause the configurator to skip all |
| the questions about Micrel devices. If you say Y, you will be asked |
| for your specific card in the following questions. |
| |
| if NET_VENDOR_MICREL |
| |
| config KS8842 |
| tristate "Micrel KSZ8841/42 with generic bus interface" |
| depends on HAS_IOMEM && DMA_ENGINE |
| help |
| This platform driver is for KSZ8841(1-port) / KS8842(2-port) |
| ethernet switch chip (managed, VLAN, QoS) from Micrel or |
| Timberdale(FPGA). |
| |
| config KS8851 |
| tristate "Micrel KS8851 SPI" |
| depends on SPI |
| depends on PTP_1588_CLOCK_OPTIONAL |
| select MII |
| select CRC32 |
| select EEPROM_93CX6 |
| select PHYLIB |
| select MICREL_PHY |
| help |
| SPI driver for Micrel KS8851 SPI attached network chip. |
| |
| config KS8851_MLL |
| tristate "Micrel KS8851 MLL" |
| depends on HAS_IOMEM |
| depends on PTP_1588_CLOCK_OPTIONAL |
| select MII |
| select CRC32 |
| select EEPROM_93CX6 |
| select PHYLIB |
| select MICREL_PHY |
| help |
| This platform driver is for Micrel KS8851 Address/data bus |
| multiplexed network chip. |
| |
| config KSZ884X_PCI |
| tristate "Micrel KSZ8841/2 PCI" |
| depends on PCI |
| select MII |
| select CRC32 |
| help |
| This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip. |
| |
| To compile this driver as a module, choose M here. The module |
| will be called ksz884x. |
| |
| endif # NET_VENDOR_MICREL |
