| /* SPDX-License-Identifier: GPL-2.0 */ |
| /* |
| * amlogic.h - hardware cryptographic offloader for Amlogic SoC |
| * |
| * Copyright (C) 2018-2019 Corentin LABBE <clabbe@baylibre.com> |
| */ |
| #include <crypto/aes.h> |
| #include <crypto/engine.h> |
| #include <crypto/skcipher.h> |
| #include <linux/debugfs.h> |
| #include <linux/crypto.h> |
| #include <linux/scatterlist.h> |
| |
| #define MODE_KEY 1 |
| #define MODE_AES_128 0x8 |
| #define MODE_AES_192 0x9 |
| #define MODE_AES_256 0xa |
| |
| #define MESON_DECRYPT 0 |
| #define MESON_ENCRYPT 1 |
| |
| #define MESON_OPMODE_ECB 0 |
| #define MESON_OPMODE_CBC 1 |
| |
| #define MAXFLOW 2 |
| |
| #define MAXDESC 64 |
| |
| #define DESC_LAST BIT(18) |
| #define DESC_ENCRYPTION BIT(28) |
| #define DESC_OWN BIT(31) |
| |
| /* |
| * struct meson_desc - Descriptor for DMA operations |
| * Note that without datasheet, some are unknown |
| * @t_status: Descriptor of the cipher operation (see description below) |
| * @t_src: Physical address of data to read |
| * @t_dst: Physical address of data to write |
| * t_status is segmented like this: |
| * @len: 0-16 length of data to operate |
| * @irq: 17 Ignored by hardware |
| * @eoc: 18 End means the descriptor is the last |
| * @loop: 19 Unknown |
| * @mode: 20-23 Type of algorithm (AES, SHA) |
| * @begin: 24 Unknown |
| * @end: 25 Unknown |
| * @op_mode: 26-27 Blockmode (CBC, ECB) |
| * @enc: 28 0 means decryption, 1 is for encryption |
| * @block: 29 Unknown |
| * @error: 30 Unknown |
| * @owner: 31 owner of the descriptor, 1 own by HW |
| */ |
| struct meson_desc { |
| __le32 t_status; |
| __le32 t_src; |
| __le32 t_dst; |
| }; |
| |
| /* |
| * struct meson_flow - Information used by each flow |
| * @engine: ptr to the crypto_engine for this flow |
| * @keylen: keylen for this flow operation |
| * @complete: completion for the current task on this flow |
| * @status: set to 1 by interrupt if task is done |
| * @t_phy: Physical address of task |
| * @tl: pointer to the current ce_task for this flow |
| * @stat_req: number of request done by this flow |
| */ |
| struct meson_flow { |
| struct crypto_engine *engine; |
| struct completion complete; |
| int status; |
| unsigned int keylen; |
| dma_addr_t t_phy; |
| struct meson_desc *tl; |
| #ifdef CONFIG_CRYPTO_DEV_AMLOGIC_GXL_DEBUG |
| unsigned long stat_req; |
| #endif |
| }; |
| |
| /* |
| * struct meson_dev - main container for all this driver information |
| * @base: base address of amlogic-crypto |
| * @busclk: bus clock for amlogic-crypto |
| * @dev: the platform device |
| * @chanlist: array of all flow |
| * @flow: flow to use in next request |
| * @irqs: IRQ numbers for amlogic-crypto |
| * @dbgfs_dir: Debugfs dentry for statistic directory |
| * @dbgfs_stats: Debugfs dentry for statistic counters |
| */ |
| struct meson_dev { |
| void __iomem *base; |
| struct clk *busclk; |
| struct device *dev; |
| struct meson_flow *chanlist; |
| atomic_t flow; |
| int irqs[MAXFLOW]; |
| #ifdef CONFIG_CRYPTO_DEV_AMLOGIC_GXL_DEBUG |
| struct dentry *dbgfs_dir; |
| #endif |
| }; |
| |
| /* |
| * struct meson_cipher_req_ctx - context for a skcipher request |
| * @op_dir: direction (encrypt vs decrypt) for this request |
| * @flow: the flow to use for this request |
| */ |
| struct meson_cipher_req_ctx { |
| u32 op_dir; |
| int flow; |
| struct skcipher_request fallback_req; // keep at the end |
| }; |
| |
| /* |
| * struct meson_cipher_tfm_ctx - context for a skcipher TFM |
| * @enginectx: crypto_engine used by this TFM |
| * @key: pointer to key data |
| * @keylen: len of the key |
| * @keymode: The keymode(type and size of key) associated with this TFM |
| * @mc: pointer to the private data of driver handling this TFM |
| * @fallback_tfm: pointer to the fallback TFM |
| */ |
| struct meson_cipher_tfm_ctx { |
| struct crypto_engine_ctx enginectx; |
| u32 *key; |
| u32 keylen; |
| u32 keymode; |
| struct meson_dev *mc; |
| struct crypto_skcipher *fallback_tfm; |
| }; |
| |
| /* |
| * struct meson_alg_template - crypto_alg template |
| * @type: the CRYPTO_ALG_TYPE for this template |
| * @blockmode: the type of block operation |
| * @mc: pointer to the meson_dev structure associated with this template |
| * @alg: one of sub struct must be used |
| * @stat_req: number of request done on this template |
| * @stat_fb: total of all data len done on this template |
| */ |
| struct meson_alg_template { |
| u32 type; |
| u32 blockmode; |
| union { |
| struct skcipher_alg skcipher; |
| } alg; |
| struct meson_dev *mc; |
| #ifdef CONFIG_CRYPTO_DEV_AMLOGIC_GXL_DEBUG |
| unsigned long stat_req; |
| unsigned long stat_fb; |
| #endif |
| }; |
| |
| int meson_enqueue(struct crypto_async_request *areq, u32 type); |
| |
| int meson_aes_setkey(struct crypto_skcipher *tfm, const u8 *key, |
| unsigned int keylen); |
| int meson_cipher_init(struct crypto_tfm *tfm); |
| void meson_cipher_exit(struct crypto_tfm *tfm); |
| int meson_skdecrypt(struct skcipher_request *areq); |
| int meson_skencrypt(struct skcipher_request *areq); |