| // SPDX-License-Identifier: (GPL-2.0+ OR MIT) |
| /* |
| * Copyright 2023 Gateworks Corporation |
| */ |
| |
| #include <dt-bindings/gpio/gpio.h> |
| #include <dt-bindings/leds/common.h> |
| #include <dt-bindings/phy/phy-imx8-pcie.h> |
| |
| / { |
| connector { |
| compatible = "gpio-usb-b-connector", "usb-b-connector"; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_usbcon1>; |
| type = "micro"; |
| label = "Type-C"; |
| id-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>; |
| |
| port { |
| usb_dr_connector: endpoint { |
| remote-endpoint = <&usb3_dwc>; |
| }; |
| }; |
| }; |
| |
| led-controller { |
| compatible = "gpio-leds"; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_gpio_leds>; |
| |
| led-0 { |
| function = LED_FUNCTION_STATUS; |
| color = <LED_COLOR_ID_GREEN>; |
| gpios = <&gpio4 1 GPIO_ACTIVE_HIGH>; |
| default-state = "on"; |
| linux,default-trigger = "heartbeat"; |
| }; |
| |
| led-1 { |
| function = LED_FUNCTION_STATUS; |
| color = <LED_COLOR_ID_RED>; |
| gpios = <&gpio4 5 GPIO_ACTIVE_HIGH>; |
| default-state = "off"; |
| }; |
| }; |
| |
| pcie0_refclk: clock-pcie0 { |
| compatible = "fixed-clock"; |
| #clock-cells = <0>; |
| clock-frequency = <100000000>; |
| }; |
| |
| pps { |
| compatible = "pps-gpio"; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_pps>; |
| gpios = <&gpio4 3 GPIO_ACTIVE_HIGH>; |
| status = "okay"; |
| }; |
| }; |
| |
| /* off-board header */ |
| &ecspi2 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_spi2>; |
| cs-gpios = <&gpio5 13 GPIO_ACTIVE_LOW>; |
| status = "okay"; |
| }; |
| |
| &gpio4 { |
| gpio-line-names = |
| "", "", "", "", |
| "", "", "", "", |
| "dio1", "", "", "dio0", |
| "", "", "pci_usb_sel", "", |
| "", "", "", "", |
| "", "", "", "", |
| "dio3", "", "dio2", "", |
| "pci_wdis#", "", "", ""; |
| }; |
| |
| &i2c2 { |
| clock-frequency = <400000>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_i2c2>; |
| status = "okay"; |
| |
| accelerometer@19 { |
| compatible = "st,lis2de12"; |
| reg = <0x19>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_accel>; |
| st,drdy-int-pin = <1>; |
| interrupt-parent = <&gpio4>; |
| interrupts = <21 IRQ_TYPE_LEVEL_LOW>; |
| }; |
| }; |
| |
| &pcie_phy { |
| fsl,refclk-pad-mode = <IMX8_PCIE_REFCLK_PAD_INPUT>; |
| fsl,clkreq-unsupported; |
| clocks = <&pcie0_refclk>; |
| clock-names = "ref"; |
| status = "okay"; |
| }; |
| |
| &pcie { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_pcie0>; |
| reset-gpio = <&gpio4 29 GPIO_ACTIVE_LOW>; |
| status = "okay"; |
| }; |
| |
| /* GPS */ |
| &uart1 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_uart1>; |
| status = "okay"; |
| }; |
| |
| /* off-board header */ |
| &uart3 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_uart3>; |
| status = "okay"; |
| }; |
| |
| /* USB1 Type-C front panel */ |
| &usb3_0 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_usb1>; |
| fsl,over-current-active-low; |
| status = "okay"; |
| }; |
| |
| &usb3_phy0 { |
| status = "okay"; |
| }; |
| |
| &usb_dwc3_0 { |
| /* dual role is implemented but not a full featured OTG */ |
| adp-disable; |
| hnp-disable; |
| srp-disable; |
| dr_mode = "otg"; |
| usb-role-switch; |
| role-switch-default-mode = "peripheral"; |
| status = "okay"; |
| |
| port { |
| usb3_dwc: endpoint { |
| remote-endpoint = <&usb_dr_connector>; |
| }; |
| }; |
| }; |
| |
| /* USB2 - MiniPCIe socket */ |
| &usb3_1 { |
| fsl,permanently-attached; |
| fsl,disable-port-power-control; |
| status = "okay"; |
| }; |
| |
| &usb3_phy1 { |
| status = "okay"; |
| }; |
| |
| &usb_dwc3_1 { |
| dr_mode = "host"; |
| status = "okay"; |
| }; |
| |
| &iomuxc { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_hog>; |
| |
| pinctrl_hog: hoggrp { |
| fsl,pins = < |
| MX8MP_IOMUXC_SAI1_RXD6__GPIO4_IO08 0x40000146 /* DIO1 */ |
| MX8MP_IOMUXC_SAI1_TXC__GPIO4_IO11 0x40000146 /* DIO0 */ |
| MX8MP_IOMUXC_SAI1_TXD2__GPIO4_IO14 0x40000106 /* PCIE_USBSEL */ |
| MX8MP_IOMUXC_SAI2_TXD0__GPIO4_IO26 0x40000146 /* DIO2 */ |
| MX8MP_IOMUXC_SAI2_TXFS__GPIO4_IO24 0x40000146 /* DIO3 */ |
| MX8MP_IOMUXC_SAI3_RXFS__GPIO4_IO28 0x40000106 /* PCIE_WDIS# */ |
| >; |
| }; |
| |
| pinctrl_accel: accelgrp { |
| fsl,pins = < |
| MX8MP_IOMUXC_SAI2_RXFS__GPIO4_IO21 0x150 /* IRQ */ |
| >; |
| }; |
| |
| pinctrl_gpio_leds: gpioledgrp { |
| fsl,pins = < |
| MX8MP_IOMUXC_SAI1_RXC__GPIO4_IO01 0x6 /* LEDG */ |
| MX8MP_IOMUXC_SAI1_RXD3__GPIO4_IO05 0x6 /* LEDR */ |
| >; |
| }; |
| |
| pinctrl_pcie0: pcie0grp { |
| fsl,pins = < |
| MX8MP_IOMUXC_SAI3_RXC__GPIO4_IO29 0x106 |
| >; |
| }; |
| |
| pinctrl_pps: ppsgrp { |
| fsl,pins = < |
| MX8MP_IOMUXC_SAI1_RXD1__GPIO4_IO03 0x146 |
| >; |
| }; |
| |
| pinctrl_usb1: usb1grp { |
| fsl,pins = < |
| MX8MP_IOMUXC_GPIO1_IO13__USB1_OTG_OC 0x140 /* USB1_FLT# */ |
| >; |
| }; |
| |
| pinctrl_usbcon1: usbcon1grp { |
| fsl,pins = < |
| MX8MP_IOMUXC_SAI5_RXD0__GPIO3_IO21 0x140 /* USB1_ID */ |
| >; |
| }; |
| |
| pinctrl_spi2: spi2grp { |
| fsl,pins = < |
| MX8MP_IOMUXC_ECSPI2_SCLK__ECSPI2_SCLK 0x140 |
| MX8MP_IOMUXC_ECSPI2_MOSI__ECSPI2_MOSI 0x140 |
| MX8MP_IOMUXC_ECSPI2_MISO__ECSPI2_MISO 0x140 |
| MX8MP_IOMUXC_ECSPI2_SS0__GPIO5_IO13 0x140 |
| >; |
| }; |
| |
| pinctrl_uart1: uart1grp { |
| fsl,pins = < |
| MX8MP_IOMUXC_UART1_RXD__UART1_DCE_RX 0x140 |
| MX8MP_IOMUXC_UART1_TXD__UART1_DCE_TX 0x140 |
| >; |
| }; |
| |
| pinctrl_uart3: uart3grp { |
| fsl,pins = < |
| MX8MP_IOMUXC_UART3_RXD__UART3_DCE_RX 0x140 |
| MX8MP_IOMUXC_UART3_TXD__UART3_DCE_TX 0x140 |
| >; |
| }; |
| }; |