blob: 69fdca00f364f82d5e210817f273e1b92bb957da [file] [log] [blame]
/* SPDX-License-Identifier: GPL-2.0 */
#ifndef _DRXK_H_
#define _DRXK_H_
#include <linux/types.h>
#include <linux/i2c.h>
* struct drxk_config - Configure the initial parameters for DRX-K
* @adr: I2C address of the DRX-K
* @parallel_ts: True means that the device uses parallel TS,
* Serial otherwise.
* @dynamic_clk: True means that the clock will be dynamically
* adjusted. Static clock otherwise.
* @enable_merr_cfg: Enable SIO_PDR_PERR_CFG/SIO_PDR_MVAL_CFG.
* @single_master: Device is on the single master mode
* @no_i2c_bridge: Don't switch the I2C bridge to talk with tuner
* @antenna_gpio: GPIO bit used to control the antenna
* @antenna_dvbt: GPIO bit for changing antenna to DVB-C. A value of 1
* means that 1=DVBC, 0 = DVBT. Zero means the opposite.
* @mpeg_out_clk_strength: DRXK Mpeg output clock drive strength.
* @chunk_size: maximum size for I2C messages
* @microcode_name: Name of the firmware file with the microcode
* @qam_demod_parameter_count: The number of parameters used for the command
* to set the demodulator parameters. All
* firmwares are using the 2-parameter command.
* An exception is the ```` firmware,
* which uses the 4-parameter command.
* A value of 0 (default) or lower indicates that
* the correct number of parameters will be
* automatically detected.
* On the ``*_gpio`` vars, bit 0 is UIO-1, bit 1 is UIO-2 and bit 2 is
* UIO-3.
struct drxk_config {
u8 adr;
bool single_master;
bool no_i2c_bridge;
bool parallel_ts;
bool dynamic_clk;
bool enable_merr_cfg;
bool antenna_dvbt;
u16 antenna_gpio;
u8 mpeg_out_clk_strength;
int chunk_size;
const char *microcode_name;
int qam_demod_parameter_count;
* drxk_attach - Attach a drxk demod
* @config: pointer to &struct drxk_config with demod configuration.
* @i2c: i2c adapter to use.
* return: FE pointer on success, NULL on failure.
extern struct dvb_frontend *drxk_attach(const struct drxk_config *config,
struct i2c_adapter *i2c);
static inline struct dvb_frontend *drxk_attach(const struct drxk_config *config,
struct i2c_adapter *i2c)
printk(KERN_WARNING "%s: driver disabled by Kconfig\n", __func__);
return NULL;