| // SPDX-License-Identifier: (GPL-2.0+ OR MIT) |
| /* |
| * Google Veyron (and derivatives) board device tree source |
| * Chromebook specific parts |
| * |
| * Copyright 2015 Google, Inc |
| */ |
| |
| #include <dt-bindings/clock/rockchip,rk808.h> |
| #include <dt-bindings/input/input.h> |
| #include "rk3288-veyron.dtsi" |
| #include "rk3288-veyron-analog-audio.dtsi" |
| #include "rk3288-veyron-edp.dtsi" |
| #include "rk3288-veyron-sdmmc.dtsi" |
| |
| / { |
| aliases { |
| /* Assign 20 so we don't get confused w/ builtin ones */ |
| i2c20 = &i2c_tunnel; |
| }; |
| |
| gpio-charger { |
| compatible = "gpio-charger"; |
| charger-type = "mains"; |
| gpios = <&gpio0 RK_PB0 GPIO_ACTIVE_HIGH>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&ac_present_ap>; |
| }; |
| |
| lid_switch: lid-switch { |
| compatible = "gpio-keys"; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&ap_lid_int_l>; |
| |
| switch-lid { |
| label = "Lid"; |
| gpios = <&gpio0 RK_PA6 GPIO_ACTIVE_LOW>; |
| wakeup-source; |
| linux,code = <SW_LID>; |
| linux,input-type = <EV_SW>; |
| debounce-interval = <1>; |
| }; |
| }; |
| |
| /* A non-regulated voltage from power supply or battery */ |
| vccsys: vccsys { |
| compatible = "regulator-fixed"; |
| regulator-name = "vccsys"; |
| regulator-boot-on; |
| regulator-always-on; |
| }; |
| |
| vcc33_sys: vcc33-sys { |
| vin-supply = <&vccsys>; |
| }; |
| |
| vcc_5v: vcc-5v { |
| vin-supply = <&vccsys>; |
| }; |
| |
| /* This turns on vbus for host1 (dwc2) */ |
| vcc5_host1: vcc5-host1-regulator { |
| compatible = "regulator-fixed"; |
| enable-active-high; |
| gpio = <&gpio0 RK_PB3 GPIO_ACTIVE_HIGH>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&host1_pwr_en>; |
| regulator-name = "vcc5_host1"; |
| regulator-always-on; |
| regulator-boot-on; |
| }; |
| |
| /* This turns on vbus for otg for host mode (dwc2) */ |
| vcc5v_otg: vcc5v-otg-regulator { |
| compatible = "regulator-fixed"; |
| enable-active-high; |
| gpio = <&gpio0 RK_PB4 GPIO_ACTIVE_HIGH>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&usbotg_pwren_h>; |
| regulator-name = "vcc5_host2"; |
| regulator-always-on; |
| regulator-boot-on; |
| }; |
| }; |
| |
| &rk808 { |
| vcc11-supply = <&vcc_5v>; |
| |
| regulators { |
| vcc33_ccd: LDO_REG8 { |
| regulator-name = "vcc33_ccd"; |
| regulator-always-on; |
| regulator-boot-on; |
| regulator-min-microvolt = <3300000>; |
| regulator-max-microvolt = <3300000>; |
| regulator-state-mem { |
| regulator-off-in-suspend; |
| }; |
| }; |
| }; |
| }; |
| |
| &spi0 { |
| status = "okay"; |
| |
| cros_ec: ec@0 { |
| compatible = "google,cros-ec-spi"; |
| reg = <0>; |
| google,cros-ec-spi-pre-delay = <30>; |
| interrupt-parent = <&gpio7>; |
| interrupts = <RK_PA7 IRQ_TYPE_LEVEL_LOW>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&ec_int>; |
| spi-max-frequency = <3000000>; |
| |
| i2c_tunnel: i2c-tunnel { |
| compatible = "google,cros-ec-i2c-tunnel"; |
| google,remote-bus = <0>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| }; |
| }; |
| }; |
| |
| &i2c4 { |
| trackpad@15 { |
| compatible = "elan,ekth3000"; |
| reg = <0x15>; |
| interrupt-parent = <&gpio7>; |
| interrupts = <RK_PA3 IRQ_TYPE_EDGE_FALLING>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&trackpad_int>; |
| vcc-supply = <&vcc33_io>; |
| wakeup-source; |
| }; |
| }; |
| |
| &pinctrl { |
| buttons { |
| ap_lid_int_l: ap-lid-int-l { |
| rockchip,pins = <0 RK_PA6 RK_FUNC_GPIO &pcfg_pull_up>; |
| }; |
| }; |
| |
| charger { |
| ac_present_ap: ac-present-ap { |
| rockchip,pins = <0 RK_PB0 RK_FUNC_GPIO &pcfg_pull_up>; |
| }; |
| }; |
| |
| cros-ec { |
| ec_int: ec-int { |
| rockchip,pins = <7 RK_PA7 RK_FUNC_GPIO &pcfg_pull_none>; |
| }; |
| }; |
| |
| suspend { |
| suspend_l_wake: suspend-l-wake { |
| rockchip,pins = <0 RK_PC1 RK_FUNC_GPIO &pcfg_output_low>; |
| }; |
| |
| suspend_l_sleep: suspend-l-sleep { |
| rockchip,pins = <0 RK_PC1 RK_FUNC_GPIO &pcfg_output_high>; |
| }; |
| }; |
| |
| trackpad { |
| trackpad_int: trackpad-int { |
| rockchip,pins = <7 RK_PA3 RK_FUNC_GPIO &pcfg_pull_up>; |
| }; |
| }; |
| |
| usb-host { |
| host1_pwr_en: host1-pwr-en { |
| rockchip,pins = <0 RK_PB3 RK_FUNC_GPIO &pcfg_pull_none>; |
| }; |
| |
| usbotg_pwren_h: usbotg-pwren-h { |
| rockchip,pins = <0 RK_PB4 RK_FUNC_GPIO &pcfg_pull_none>; |
| }; |
| }; |
| }; |
| |
| #include "../cros-ec-keyboard.dtsi" |