| // SPDX-License-Identifier: GPL-2.0+ |
| |
| #include <linux/bitops.h> |
| #include <linux/delay.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/i2c.h> |
| #include <linux/kernel.h> |
| #include <linux/module.h> |
| #include <linux/regmap.h> |
| #include <linux/regulator/driver.h> |
| #include <linux/regulator/of_regulator.h> |
| |
| #define RT6245_VIRT_OCLIMIT 0x00 |
| #define RT6245_VIRT_OTLEVEL 0x01 |
| #define RT6245_VIRT_PGDLYTIME 0x02 |
| #define RT6245_VIRT_SLEWRATE 0x03 |
| #define RT6245_VIRT_SWFREQ 0x04 |
| #define RT6245_VIRT_VOUT 0x05 |
| |
| #define RT6245_VOUT_MASK GENMASK(6, 0) |
| #define RT6245_SLEW_MASK GENMASK(2, 0) |
| #define RT6245_CHKSUM_MASK BIT(7) |
| #define RT6245_CODE_MASK GENMASK(6, 0) |
| |
| /* HW Enable + Soft start time */ |
| #define RT6245_ENTIME_IN_US 5000 |
| |
| #define RT6245_VOUT_MINUV 437500 |
| #define RT6245_VOUT_MAXUV 1387500 |
| #define RT6245_VOUT_STEPUV 12500 |
| #define RT6245_NUM_VOUT ((RT6245_VOUT_MAXUV - RT6245_VOUT_MINUV) / RT6245_VOUT_STEPUV + 1) |
| |
| struct rt6245_priv { |
| struct gpio_desc *enable_gpio; |
| bool enable_state; |
| }; |
| |
| static int rt6245_enable(struct regulator_dev *rdev) |
| { |
| struct rt6245_priv *priv = rdev_get_drvdata(rdev); |
| struct regmap *regmap = rdev_get_regmap(rdev); |
| int ret; |
| |
| if (!priv->enable_gpio) |
| return 0; |
| |
| gpiod_direction_output(priv->enable_gpio, 1); |
| usleep_range(RT6245_ENTIME_IN_US, RT6245_ENTIME_IN_US + 1000); |
| |
| regcache_cache_only(regmap, false); |
| ret = regcache_sync(regmap); |
| if (ret) |
| return ret; |
| |
| priv->enable_state = true; |
| return 0; |
| } |
| |
| static int rt6245_disable(struct regulator_dev *rdev) |
| { |
| struct rt6245_priv *priv = rdev_get_drvdata(rdev); |
| struct regmap *regmap = rdev_get_regmap(rdev); |
| |
| if (!priv->enable_gpio) |
| return -EINVAL; |
| |
| regcache_cache_only(regmap, true); |
| regcache_mark_dirty(regmap); |
| |
| gpiod_direction_output(priv->enable_gpio, 0); |
| |
| priv->enable_state = false; |
| return 0; |
| } |
| |
| static int rt6245_is_enabled(struct regulator_dev *rdev) |
| { |
| struct rt6245_priv *priv = rdev_get_drvdata(rdev); |
| |
| return priv->enable_state ? 1 : 0; |
| } |
| |
| static const struct regulator_ops rt6245_regulator_ops = { |
| .list_voltage = regulator_list_voltage_linear, |
| .set_voltage_sel = regulator_set_voltage_sel_regmap, |
| .get_voltage_sel = regulator_get_voltage_sel_regmap, |
| .set_ramp_delay = regulator_set_ramp_delay_regmap, |
| .enable = rt6245_enable, |
| .disable = rt6245_disable, |
| .is_enabled = rt6245_is_enabled, |
| }; |
| |
| /* ramp delay dividend is 12500 uV/uS, and divisor from 1 to 8 */ |
| static const unsigned int rt6245_ramp_delay_table[] = { |
| 12500, 6250, 4167, 3125, 2500, 2083, 1786, 1562 |
| }; |
| |
| static const struct regulator_desc rt6245_regulator_desc = { |
| .name = "rt6245-regulator", |
| .ops = &rt6245_regulator_ops, |
| .type = REGULATOR_VOLTAGE, |
| .min_uV = RT6245_VOUT_MINUV, |
| .uV_step = RT6245_VOUT_STEPUV, |
| .n_voltages = RT6245_NUM_VOUT, |
| .ramp_delay_table = rt6245_ramp_delay_table, |
| .n_ramp_values = ARRAY_SIZE(rt6245_ramp_delay_table), |
| .owner = THIS_MODULE, |
| .vsel_reg = RT6245_VIRT_VOUT, |
| .vsel_mask = RT6245_VOUT_MASK, |
| .ramp_reg = RT6245_VIRT_SLEWRATE, |
| .ramp_mask = RT6245_SLEW_MASK, |
| }; |
| |
| static int rt6245_init_device_properties(struct device *dev) |
| { |
| const struct { |
| const char *name; |
| unsigned int reg; |
| } rt6245_props[] = { |
| { "richtek,oc-level-select", RT6245_VIRT_OCLIMIT }, |
| { "richtek,ot-level-select", RT6245_VIRT_OTLEVEL }, |
| { "richtek,pgdly-time-select", RT6245_VIRT_PGDLYTIME }, |
| { "richtek,switch-freq-select", RT6245_VIRT_SWFREQ } |
| }; |
| struct regmap *regmap = dev_get_regmap(dev, NULL); |
| u8 propval; |
| int i, ret; |
| |
| for (i = 0; i < ARRAY_SIZE(rt6245_props); i++) { |
| ret = device_property_read_u8(dev, rt6245_props[i].name, &propval); |
| if (ret) |
| continue; |
| |
| ret = regmap_write(regmap, rt6245_props[i].reg, propval); |
| if (ret) { |
| dev_err(dev, "Fail to apply [%s:%d]\n", rt6245_props[i].name, propval); |
| return ret; |
| } |
| } |
| |
| return 0; |
| } |
| |
| static int rt6245_reg_write(void *context, unsigned int reg, unsigned int val) |
| { |
| struct i2c_client *i2c = context; |
| static const u8 func_base[] = { 0x6F, 0x73, 0x78, 0x61, 0x7C, 0 }; |
| unsigned int code, bit_count; |
| |
| code = func_base[reg]; |
| code += val; |
| |
| /* xor checksum for bit 6 to 0 */ |
| bit_count = hweight8(code & RT6245_CODE_MASK); |
| if (bit_count % 2) |
| code |= RT6245_CHKSUM_MASK; |
| else |
| code &= ~RT6245_CHKSUM_MASK; |
| |
| return i2c_smbus_write_byte(i2c, code); |
| } |
| |
| static const struct reg_default rt6245_reg_defaults[] = { |
| /* Default over current 14A */ |
| { RT6245_VIRT_OCLIMIT, 2 }, |
| /* Default over temperature 150'c */ |
| { RT6245_VIRT_OTLEVEL, 0 }, |
| /* Default power good delay time 10us */ |
| { RT6245_VIRT_PGDLYTIME, 1 }, |
| /* Default slewrate 12.5mV/uS */ |
| { RT6245_VIRT_SLEWRATE, 0 }, |
| /* Default switch frequency 800KHz */ |
| { RT6245_VIRT_SWFREQ, 1 }, |
| /* Default voltage 750mV */ |
| { RT6245_VIRT_VOUT, 0x19 } |
| }; |
| |
| static const struct regmap_config rt6245_regmap_config = { |
| .reg_bits = 8, |
| .val_bits = 8, |
| .max_register = RT6245_VIRT_VOUT, |
| .cache_type = REGCACHE_FLAT, |
| .reg_defaults = rt6245_reg_defaults, |
| .num_reg_defaults = ARRAY_SIZE(rt6245_reg_defaults), |
| .reg_write = rt6245_reg_write, |
| }; |
| |
| static int rt6245_probe(struct i2c_client *i2c) |
| { |
| struct rt6245_priv *priv; |
| struct regmap *regmap; |
| struct regulator_config regulator_cfg = {}; |
| struct regulator_dev *rdev; |
| int ret; |
| |
| priv = devm_kzalloc(&i2c->dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| |
| priv->enable_state = true; |
| |
| priv->enable_gpio = devm_gpiod_get_optional(&i2c->dev, "enable", GPIOD_OUT_HIGH); |
| if (IS_ERR(priv->enable_gpio)) { |
| dev_err(&i2c->dev, "Failed to get 'enable' gpio\n"); |
| return PTR_ERR(priv->enable_gpio); |
| } |
| |
| usleep_range(RT6245_ENTIME_IN_US, RT6245_ENTIME_IN_US + 1000); |
| |
| regmap = devm_regmap_init(&i2c->dev, NULL, i2c, &rt6245_regmap_config); |
| if (IS_ERR(regmap)) { |
| dev_err(&i2c->dev, "Failed to initialize the regmap\n"); |
| return PTR_ERR(regmap); |
| } |
| |
| ret = rt6245_init_device_properties(&i2c->dev); |
| if (ret) { |
| dev_err(&i2c->dev, "Failed to initialize device properties\n"); |
| return ret; |
| } |
| |
| regulator_cfg.dev = &i2c->dev; |
| regulator_cfg.of_node = i2c->dev.of_node; |
| regulator_cfg.regmap = regmap; |
| regulator_cfg.driver_data = priv; |
| regulator_cfg.init_data = of_get_regulator_init_data(&i2c->dev, i2c->dev.of_node, |
| &rt6245_regulator_desc); |
| rdev = devm_regulator_register(&i2c->dev, &rt6245_regulator_desc, ®ulator_cfg); |
| if (IS_ERR(rdev)) { |
| dev_err(&i2c->dev, "Failed to register regulator\n"); |
| return PTR_ERR(rdev); |
| } |
| |
| return 0; |
| } |
| |
| static const struct of_device_id __maybe_unused rt6245_of_match_table[] = { |
| { .compatible = "richtek,rt6245", }, |
| {} |
| }; |
| MODULE_DEVICE_TABLE(of, rt6245_of_match_table); |
| |
| static struct i2c_driver rt6245_driver = { |
| .driver = { |
| .name = "rt6245", |
| .probe_type = PROBE_PREFER_ASYNCHRONOUS, |
| .of_match_table = rt6245_of_match_table, |
| }, |
| .probe = rt6245_probe, |
| }; |
| module_i2c_driver(rt6245_driver); |
| |
| MODULE_AUTHOR("ChiYuan Huang <cy_huang@richtek.com>"); |
| MODULE_DESCRIPTION("Richtek RT6245 Regulator Driver"); |
| MODULE_LICENSE("GPL v2"); |