| TPS62360 Voltage regulators |
| |
| Required properties: |
| - compatible: Must be one of the following. |
| "ti,tps62360" |
| "ti,tps62361", |
| "ti,tps62362", |
| "ti,tps62363", |
| - reg: I2C slave address |
| |
| Optional properties: |
| - ti,enable-force-pwm: Enable force PWM mode. This is boolean value. |
| - ti,enable-vout-discharge: Enable output discharge. This is boolean value. |
| - ti,enable-pull-down: Enable pull down. This is boolean value. |
| - ti,vsel0-gpio: GPIO for controlling VSEL0 line. |
| If this property is missing, then assume that there is no GPIO |
| for vsel0 control. |
| - ti,vsel1-gpio: Gpio for controlling VSEL1 line. |
| If this property is missing, then assume that there is no GPIO |
| for vsel1 control. |
| - ti,vsel0-state-high: Inital state of vsel0 input is high. |
| If this property is missing, then assume the state as low (0). |
| - ti,vsel1-state-high: Inital state of vsel1 input is high. |
| If this property is missing, then assume the state as low (0). |
| |
| Any property defined as part of the core regulator binding, defined in |
| regulator.txt, can also be used. |
| |
| Example: |
| |
| abc: tps62360 { |
| compatible = "ti,tps62361"; |
| reg = <0x60>; |
| regulator-name = "tps62361-vout"; |
| regulator-min-microvolt = <500000>; |
| regulator-max-microvolt = <1500000>; |
| regulator-boot-on |
| ti,vsel0-gpio = <&gpio1 16 0>; |
| ti,vsel1-gpio = <&gpio1 17 0>; |
| ti,vsel0-state-high; |
| ti,vsel1-state-high; |
| ti,enable-pull-down; |
| ti,enable-force-pwm; |
| ti,enable-vout-discharge; |
| }; |
