blob: 36b01458f45cf4aaa1051986320fbb47f5cd1eea [file] [log] [blame]
Mediatek DSI Device
===================
The Mediatek DSI function block is a sink of the display subsystem and can
drive up to 4-lane MIPI DSI output. Two DSIs can be synchronized for dual-
channel output.
Required properties:
- compatible: "mediatek,<chip>-dsi"
- the supported chips are mt2701, mt7623, mt8167, mt8173 and mt8183.
- reg: Physical base address and length of the controller's registers
- interrupts: The interrupt signal from the function block.
- clocks: device clocks
See Documentation/devicetree/bindings/clock/clock-bindings.txt for details.
- clock-names: must contain "engine", "digital", and "hs"
- phys: phandle link to the MIPI D-PHY controller.
- phy-names: must contain "dphy"
- port: Output port node with endpoint definitions as described in
Documentation/devicetree/bindings/graph.txt. This port should be connected
to the input port of an attached DSI panel or DSI-to-eDP encoder chip.
Optional properties:
- resets: list of phandle + reset specifier pair, as described in [1].
[1] Documentation/devicetree/bindings/reset/reset.txt
MIPI TX Configuration Module
============================
See phy/mediatek,dsi-phy.yaml
Example:
mipi_tx0: mipi-dphy@10215000 {
compatible = "mediatek,mt8173-mipi-tx";
reg = <0 0x10215000 0 0x1000>;
clocks = <&clk26m>;
clock-output-names = "mipi_tx0_pll";
#clock-cells = <0>;
#phy-cells = <0>;
drive-strength-microamp = <4600>;
nvmem-cells= <&mipi_tx_calibration>;
nvmem-cell-names = "calibration-data";
};
dsi0: dsi@1401b000 {
compatible = "mediatek,mt8173-dsi";
reg = <0 0x1401b000 0 0x1000>;
interrupts = <GIC_SPI 192 IRQ_TYPE_LEVEL_LOW>;
clocks = <&mmsys MM_DSI0_ENGINE>, <&mmsys MM_DSI0_DIGITAL>,
<&mipi_tx0>;
clock-names = "engine", "digital", "hs";
resets = <&mmsys MT8173_MMSYS_SW0_RST_B_DISP_DSI0>;
phys = <&mipi_tx0>;
phy-names = "dphy";
port {
dsi0_out: endpoint {
remote-endpoint = <&panel_in>;
};
};
};