blob: c6aef36b7d150e4adf7ad2c2eae4041b2eef4e9f [file] [log] [blame]
Lantiq XWAY SoC RCU reset controller binding
This binding describes a reset-controller found on the RCU module on Lantiq
This node has to be a sub node of the Lantiq RCU block.
Required properties:
- compatible : Should be one of
- reg : Defines the following sets of registers in the parent
syscon device
- Offset of the reset set register
- Offset of the reset status register
- #reset-cells : Specifies the number of cells needed to encode the
reset line, should be 2.
The first cell takes the reset set bit and the
second cell takes the status bit.
Example for the reset-controllers on the xRX200 SoCs:
reset0: reset-controller@10 {
compatible = "lantiq,xrx200-reset";
reg <0x10 0x04>, <0x14 0x04>;
#reset-cells = <2>;